PROVISION OF OPEN CAR PARKING SHED FOR JWO AND ABOVE POOL SMQ AT NO. 2 AFSB MYSORE

Amount

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, in hard/dense soil.

M&L for cement concrete type B2 1:2:4 (40 mm graded aggregate) in post holes.

S&F compound girders and stanchions,lattice girder, aerial masts, stging for water tanks and the like including caps,bases, splices etc.builtup from two or more beam or channel section or angles with plates,including all lattice bars,stiffeners,gusset plates,etc of Fe-410-W(gde-E-250)quality-A.

S&F for steel work in Roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc.or induction butt welded to angles, cleats conforming to I. S.1161-1979 grade St.-240

S&F for pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified and directed.

S & F Pre-painted Alu-zink Plain steel sheets for ridge etc (Galvalume base) 0.5 mm thick, of any colour having tensile strength of 550 Mpa fixed with self tapping screws as specified & diected.

Surface excavation not exc 30 cm deep and avaraging 15 cm deep and getting out soft/loose soil

Rough Excavation n.exc 1.5 m deep and getting out Hard/dense soil complete all as specified and directed

Removing excavated material to a distance n.exc 50m and depositing where directed at level n.exc 1.5m above the starting point complete all as specified and directed.

M&L precast cement concrete block masonry with solid blocks exc 10 cm in width type C1 1:3:6 ( 20mm graded aggregate) set in CM 1:6.

M&L for rendering 15mm thick in cement plaster 1:4 on fair faces of brick work or concrete surfaces finishing the surface even and smooth without using extra cement complete all as specified and as directed

M&L for prepration of new wall surfaces and applying two coats of cement base paint

M&L for preparation of new steel surfaces of any description, over 10 cm in width or girth and applying two coats of synthetic enamel paint over red oxide complete all as specified and directed.

M&L Hard core of gauge n exc 63 mm broken stone deposited, spread and levelled in layers n exc 15 cm thick, watered and well rammed to a true surface.

M&L for providing 75 mm thick Cement Concrete type D-2, 1:4:8 (40 mm graded stone agg) as in sub base to floors.

M&L for providing 100 mm thick Cement Concrete type B-1, 1:2:4 (20 mm graded stone agg) as in floor etc complete all as specified and directed.

Aditya Associates