REPLACEMENT OF EXISTING VINTAGE DOORS IN DESIGNATED ROOMS WITH ASSOCIATED ALLIED WORKS AT 1ST FLOOR A BLOCK DESIDOC DELHI BUILDING NO P 143 AND PROVISION OF EMERGENCY EXIT ARRANGEMENTS IN SS BUILDING AT SSPL UNDER GE I RnD DELHI

Demolition of cement concrete in ground floors and pavings etc not exc 15 cm thick above or below ground level complete all as specified and directed.

Excavation as in trenches in any type of soil not exceeding 1.5 metres wide and not exceeding 1.5 metres deep lines and getting out complete all as specified and directed by Engineer-in-Charge.

M&L Returning, filling in any type of soil, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick, complete all as specified and directed.

Removing excavated material/Malba to a distance exceeding 1.5 KM and not exceeding 5 KM depositing where directed at a level not exceeding 1.50m above the starting point complete all as specified and directed.

M & L for PCC (1:4:8) type D-2 using 40mm graded stone aggregates for foundation filling, mass concrete finished even and rough to receive topping layer completed all as specified by engg in charge.

S&F of TMT bars 10mm dia and over cut to length bend to shape required including cranking bending complete all as specified and directed.

Use and waste of form work to soffits of suspended slab such as roof slab, floor slab, landing and similar work not exceeding 200mm thick surface flat for rough finished surface of concrete complete all as specified.

M&L for RCC work (Nominal Mix) (1:2:4) type B-0 (using 12.5mm graded stone aggregate) as in piers, pedestals, tie beams, slabs supported on walls, shelves, man hole cover ,drain covers etc and like complete all as specified and directed.

S&F MS Framed work with MS angle, channels, ISMB, gusset plates, rails, braces,Chequred plates,flat iron, Nut, bolts, rivets, connecting MS plates etc as in Fire exit stair case, barreled iron doors, ladders, framed balusters, walk ways, railings, framework of water tanks, cover grills and similar work etc complete drilled for fixing of steel sheeting or other covering including welding work ,PCC work 1:1.5:3 in grouting etc to be prepared including MS fasteneres, hooks, hinges,necessary holdfasts etc and including all kind of ERW welding, induction butt welding, riveting work and fixing in building upto 12 mtr height complete all as spfd and directed by engr in charge.

M&L for preparation of newly steel surfaces of any description, over 10cm in width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed by Engineer-in-Charge.