MID/J/52

Decoupling of 10 cusec pump of pumping unit no II from motor and then dismantling the pump from the base frame. Carriage & shifting of dismantled pump of Lift irrigation station Kothey Kalyana New on head load through path in fields to roadside using manual labour and then to workshop by carriage vehicle. Dismantling of 10 cusec discharge pump of pumping unit no II at workshop for extraction of all worn out/damaged parts i.e. pump shaft, impeller, bearings, sleeves, bush, check nuts, nuts & bolts, gland plate, gland studs. Cleaning of pump casing to remove sand and silt. Providing and fitting of new pump shaft as per the size and specifications of pumping unit, turning and threading of pump shaft at required portions for fastening of check nut and fabrication of groove for key way at the position of coupling pulley. Repairs to the impeller by filling cavities and cracks by way of metal filling and grinding to the original size. Providing and fitting of two number new bearings and one number thrust bearing number, 1 no’s neck ring, shaft protection sleeve, check nut, nuts & bolts, fabrication of new gland plate with providing and fitting of 2 no’s new gland studs. Reassembling all parts of pump with proper greasing & filling of pump bearing housing with fresh M oil. Providing and fitting of graphite packing in pumping unit. Repair to 400 mm diameter foot valve of pumping unit no II by way of dismantling parts. Cleaning of all internal parts to remove silt and rust. Fabrication of foot valve plate as per size, new leather washer, hinge pin, new nuts & bolts. The job includes fitting it with foot valve at the end of suction pipe. Providing/fitting and replacement of aluminum conductors of rabbit gauge capacity in four lengths of 50 mtrs. each after extracting the old worn out rabbit gauge from LT pole of Transformer to LT pole near LIS along with insulators, U-clamps, nut bolts etc. Getting the HT supply connected and checking the availability of power supply in the pump room. Back shifting after carrying out repairs to pump machinery to site. The job includes loading, un-loading, manual labour, carriage charges of vehicle (to & fro), tools & tackles etc. Alignment of pump and motor. The job includes the cost of materials and labour charges. Complete job Note:- The tenderers are requested to visit the site and quote the rate as per site conditions. Any modifications/ alterations of the job, absolutely necessary if required at the time of execution may be done as per actual site conditions.

Rebate on Old Parts