Loading
Loading…
Loading…
Tender Value
₹67.4 L
EMD Value
₹1.3 L
Closing Date
17 Dec 2025, 11:00 amClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
45 days
Expenditure
Capital (Works)
Above/Below/Par
TECHNICAL
15 conditions · 4 needing a document upload
The tenderer must have minimum average annual contractual turnover of [V/N or 'V' whichever is less; where V = Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
The tenderer must submit a valid Electrical Contractor license as per Indian Electricity Rules for the respective category of works issued by the Government Electrical License Board on or before the closing date of the tender. A copy of the electrical contractor license should be submitted along with the tender offer; otherwise, the tender will be summarily rejected.
The Similar nature of works for this instant tender shall be "Supply, installation, testing and commissioning of any LT/HT electrical work." The tenderer should have executed the similar nature of works in Central /State Government department or PSUs of Central /State Government."
52 conditions · 4 needing a document upload
Whether the cost of earnest money deposited
WHETHER VALID ELECTRICAL CONTRACTOR LICENCE SUBMITTED
Migration to GST regime - Special Tender Conditions: The rates should clearly indicate the rate of applicable duties and taxes included in the prices quoted by them. Any variation in tax structure/ rate due to introduction of GST, shall be dealt with under Statutory Variation Clause. It should be ensure that bidders/tenderers are GST compliant and quoted tax structure/rates are as per GST Law.
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Contractor should submit the GSTIN number and same should be mentioned in the bills along with a copy of GSTIN registration certificate while submitting the bills to accounts for audit and payment, As GST is scheduled to implemented wef 01.07.2017. Without GSTN, no bill will be accepted w.e.f. 01.07.2017
From 01.07.2017 GST has been implemented but the detail guideline is still not clear. Hence, new tax structure on materials and labour will be applicable to both Railway & contractor after getting proper notification
Payment of Earnest Money deposit (EMD) , in respect of e- tendering,should be accepted through net banking or online payment gateway only
i)Development of Infrastructural works for Kamakhya Coaching Depot & associated facilities.ii) At PNO: Electrical sub-estimate for power supply arrangement required for installation of 10 ton EOT crane at Track machine Zonal Depot Pandu.
EL-LM-25-26-31~NFR
EL-LM-25-26-31
Open
Works - General
120 Days
Hojai, Assam
₹0
₹1.3 L
17 Dec 2025
25 Nov 2025
3 Dec 2025
79 items across 2 schedules
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 40,25,243.73 | ||
| — | 400.00 | — | — | ||
| Provision of HDT machine for horizontal boring in outside of the Road/Railway track Embankment at aminimum distance of 6 Mts. from the embankment GL and depth of 2 Mts. below from G.L. with preparation of site for boring by placing of pipes for electric cable protection through contractor's own arrangement for 200 mm diameter hole as per direction of site Engineer. | — | — | — | 14,21,572 | |
| — | 1600.00 | — | — | ||
| Supply & laying of HDPE pipe 63 mmdia of pressure rating 6.0 kgf/ cm2(PN -6.0) are to be laid along the pole/ beam/brackets by 25x5 mm MS clamp with required nut, bolt/ washer and under the ground by digging trench of depth 1 mtr if necessary.Necessary compression socket and short radius compression bend has to be provided as per direction of Railway Engineer. Pre- inspection of materials by Railway Engineer shouldbe imparted. The cable laying is to bedone as per Annexure-B. Make-AJAPLAS, SWASTIK, Prime, Falcon | — | — | — | 1,58,016 | |
| — | 2400.00 | — | — | ||
| Laying, commissioning of LT/HT cable XLPEinsulated power cables with armoured aluminum conductors of different sizes (4core 95 sqmm) partly along the pole and partly through ground in cable trench.Loading, unloading & carrying of cable to actual work site by contractor own arrangement as per instruction of Engineer incharge at site. (Cable will be supplied by Railway.) | — | — | — | 1,07,232 | |
| — | 8.00 | — | — | ||
| SITC of HT heat shrinkable type outdoor cable end termination kit suitable for single core 11 KV grade XLPE 120 sq.mm XLPE cable | — | — | — | 24,219.84 | |
| — | 40.00 | — | — | ||
| Supply & Erection fixing octagonal pole 6 meters long for street light | — | — | — | 5,20,000 | |
| — | 40.00 | — | — | ||
| Supply & Erection fixing of MS hot dip galvanized single arm bracket 1000 mm long arm pipe outer dia 48.3 mm, thickness 3.25 mm with mounting pipe of suitable size. | — | — | — | 80,000 | |
| — | 40.00 | — | — | ||
| "Supply, installation, testing & commissioning of 45 wattoutdoor LED street light luminaire with heat resistant glass with connecting lead (IP protection- IP 66 class-I,System efficacy>=105 lm/w, Housing- Pressure die cast aluminium powder coated, THD<10%, p.f.>0.95, Surge protection- 5 kV) as per instruction of Engineer inchargeat site. (Embarcking maximum light to ensure visibility at night to persons with low visibility) | — | — | — | 1,53,433.2 | |
| — | 800.00 | — | — | ||
| — | 800.00 | — | — | ||
| — | 1.00 | — | — | ||
| — | — | — | 11,403.73 | ||
| — | 150.00 | — | — | ||
| — | — | — | 1,95,897 | ||
| — | 144.00 | — | — | ||
| — | — | — | 6,90,384.96 | ||
| — | 1.00 | — | — | ||
| — | — | — | 4,62,229 | ||
| — | 2.00 | — | — | ||
| Supply, installation, testing & commissioning of 4 way 400 A copper busbar chamber(wall mounted). | — | — | — | 54,280 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
EL-LM-25-26-31.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .