MPLAD-2025-2026,Construction of VAO Office at Anaimalaiayan patty Panchayat

Amount

Construction of VAO Office at Anaimalaiayan patty Panchayat.

Earth work excavation in all clauses of soils except hard rock with an initial lead and lift including strutting, bailing out water as per standard speciation etc complete.

Cement concrete -1:4:8 using 40 mm metal (ISS HBG metal) including cost and conveyance of all materials to site and all labour charges etc

Brick work in cm 1: 5 mix using country brick including cost and conveyance of all materials to site and all labor charges etc.

Supplying and erecting centering including cost and conveyance of all material to site and all labour charges etc complete. For beams and roof.

Brelow GL

Above GL

Supplying and fabrication of of steel including cost and conveyance of all materials to site and all labour charges etc complete.

RCC -1:1.5:3 using 20 mm metal (ISS HBG metal) including cost and conveyance of all materials to site and all labour charges etc

Finishing the top of roof with one course of machine pressed tiles of size 20 cum X 20 cum of approved quality laid in cement mortar 1:3 mix, 12 mm thick mixes with water proofing

Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [ The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty shoule be got approved by the Executive Engineer before use on work.

Ceiling Plastering with cement mortar 1:3 using 10mm thick over the cement concrete for floor finish including curing etc complete

Plastering with cement mortar 1:5 using 12mm thick over the cement concrete for floor finish including curing etc complete

Floor finish with granolithic pattern with plain cement concrete 1:2:4 using 10 to 12 mm size hard broken granite stone jelly 25 mm thick and the top rubbed smooth, etc complete.

Supplying and painting the walls with two coats of oil bound distemper over one coat of water based cement primer including cost for distemper, primer, cleaning and scrapping the walls, rendering the walls smooth with necessary putty, brushes, scaffolding arrangements, labour charges, etc., as per standard specification. (The colour and shade of the distemper shall be got approved by the Executive Engineer before use of work).

Painting using Plastic Emulsion paint including cost and conveyance of all materials to site and all labour charges etc

Europeon Water Closet with all fittings and 10lit capacity flusing tank

Supplying and fixing in position best quality and approved make Indian made white / colour glazed earthernware wash hand basin of size 550 x 400mm (with pedestal / without pedestal) with a pair of cast iron brackets, including cost 15mm dia brass CP pillar tap, 32mm dia "B" class GI waste pipe with rubber plug and chain, 15mm dia GM wheel valve, 15mm brass nipple, 15mm dia nylone connection, 32mm dia CP brass waste coupling including fixing of wash basin using CI brackets on to the wall in position with TW plugs and screws, rubber washers, white lead and giving necessary water supply connection and painting the brackets with two coat of painting over a priming coat of anti-corrosive paint including testing for leakages etc., complete complying with standard specification and as directed by the departmental officers. (The wash hand basin and specials should be got approved by the Executive Engineer before use on works).

Flooring with following ceramic tiles of size 305 x 305 x 6 mm laid over 20 mm thick cement mortar 1:3 (One Cement and Three M.Sand) base mortar over the existing slab / floor including cutting the tiles to the required size with special cutter wherever necessary, laying in position and pointing with white cement mixed with colouring pigment at the rate of 0.3 Kg. / sq.m. etc., complete complying with standard specification. (The make and brand of the tiles should be got approved by Executive Engineer before use on works)

Paving the floor with best quality Vetrified Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three M.Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification. (The make and brand of the tiles should be got approved by Executive Engineer before use on works)

Fabrication and supply of mild steel Door of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete.

door (1.20x2.10)

Toilet door (0.75 x1.80)

Fabrication and supply of mild steel window of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete

Window 1.20x1.30

Labour charge for fixing Doors and windows

door (1.20x2.10)

Window 1.20x1.30

Dadooing walls with following best approved quality, white / colour glazed tiles of following sizes set in Cement Mortar 1:2 (One Cement and Two crushed stone M.Sand) 10mm thick and pointing the joints with white cement mixed with colouring pigments at the rate of 0.40 Kg. / sq.m. neatly in all floors, curing, etc., complying with standard specification and as directed by the departmental officers.

Electrical Arrengements

Wiring with 2 x 1.5 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A FT switch with painting of suitable colour for open PVC light point / fan point (for electronic regulator) (5 points per coil) SD 18

Supply and fixing of single box type 4'40W fluorescent fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed FRLS copper leads from terminals to the fitting SD 88

Wiring with 2 x 1.5 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mm TW switch box with 3mm thick hylem sheet cover for 5A 3 pin non inter locking wall socket with 5A flush type switch with continuous earth wire connection of 1.5 sq.mm copper wire and making good of the concealed portion with suitable colour for concealed PVC plug point SD 38

Supply and fixing of 1200mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 1 meter down rod on the existing clamp SD 107

Supply and run of 2 of 1.50 sq.mm (22/0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade on 7/20GI bearer wire for service connection mains SD 54

Supply and fixing of WT bulk head fitting with guard for 11W CFL SD 83

Supply and fixing of 8 way single pole and neutral MCB sheet steel enclosure distribution board with double door (metal) 1 No. 32A DP MCB as incoming and 6 Nos. 6A to 32A SPMCB outgoing in flush with wall and making good of the concealed portion with earth connection only. The MCB DB and MCB's should be with ISI mark (like standard make) SD 151

Provision for Rain water pipe -110mm pvc pipe-4ksc

Providing Borewell Flushing and New Motor Installation in VAO Office Near

Rate for flushing of borewell of 6" dia requiring less than 4 hours operation using drill rods/ hose with required size of pipes for various capacity compressor including transportation, labour, and fuel charges for compressors as directed by the TWAD Officer and conducting yield test by 'V' notch method if required.

Supply and delivery of Single phase supmersible pump set 2 HP as per IS 8034 without panel board having Duty condition of 20LPM x 150M head

Supply and delivery of single phase panel board with two level guard and auto start suitable for 2HP submersible pumb set.

4 Sqm submersible cable

Supply and delivery of GI & PVC pipes & specials

40mm GI pipe

40mm GI coupling

40mm GI Elbow

40mm GI union

50mm NRV

GI kitty

Supply and run of 2 of 4 sq.mm. PVC insulated SC unsheathed FRLS copper conductor of 1100V on 7 / 20 GI bearer wire for service connection mains (SD65)

Labour charges for the erection of 2HP supmersible pump set in the deep borewell including fixing and jointing supmersible cable with proper clamps upto the starter requirted with deapth and also fixing if raiser pipes to the required the depth valves erection.

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

JEGATHEES CONSTRUCTION (BID ID -1462087)