8640 SPECIAL REPAIR TO WKSP FLOOR SHUTTER AND WINDOW OF EME PROVN OF HARD STANDING FOR MT AT 15 JAT AND PROVN OF HARD STANDING CHAIN LINK FENCING NEAR ECHS POLYCLINIC UNDER AGE BR I AND II AND III OF GE SOUTH PUNE

Amount

Dismantling wrought iron or mild steel work of any description not otherwise provided for, complete all as specified and directed.

S&F steel rolling shutter, thickness of laths 1.25mm, without ball bearing, as specified including top cover, anchoring rod, hasp and staple and one shop coat of primer, erected in position as directed at site, gear operated type with chain wheel and hand chain, complete all as specified and directed

S&F safety lever locks mild steel with 4 levers suitable for rolling shutters, complete all as specified and directed.

M&L for two coats of synthetic enamel aluminium paint on new / old steel surface of any description exceeding 10cm width or girth, including preparation of new / old steel surfaces, complete all as specified and directed

M&L for two coats of synthetic enamel paint over a coat of red oxide primer on new steel surface of any description exc. 10 cm width or girth, including preparation of new steel surfaces, complete all as specified and directed.

S&F Powder coated aluminium (minimum thickness of powder coating 50 micron) three track sliding window with two or more shutter with 4mm thick tinted glass one shutter including with stainless steel wire cloth 0.36mm nominal dia and 1.18mm width aperture for mosquito proofing with good quality bearing handle, lock, rubber beading and glazing clips etc by using following aluminium powder coated sections conforming to catalogue of 'JINDAL' or of equivalent make as mentioned here-in-after, complete all as specified and as directed by Engr-in-Charge:- (a) Bottom frame - 20620 (b) Top frame & vertical - 20621 (c) Handle (side) - 20606 (d) Shutter inter lock - 20724 (e) Shutter top & Bottom - 20844 (f) Glazing clips - 19352.

M&L for precast cement concrete block masonry with solid blocks exc. 10 cm in width and setting in cement mortar 1:6 using PCC 1:3:6 type C-1 precast cement concrete blocks, complete all as specified and directed.

Demolition cement concrete (Unreinforced) in any description and in any position not otherwise specifically provided for complete all as specified and directed.

Demolition of PCC block masonary, built in cement mortar including all quoins, arches, pillars etc., complete all as specified and directed.

M&L for providing PCC 1:2:4 type B-0 using 12.5mm graded stone aggregate as in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as specified and directed.

M&L for hardcore of broken stone or boulders of gauge not exceeding 63mm, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface, complete all as specified and directed.

Surface excavation in soft / loose soil n.exc. 30cm deep and averaging 15cm deep and getting out, complete all as specified and directed.

M&L for precast cement concrete interlocking paver blocks, coloured, matt finish with any shape and size conforming to IS-15658-2006, 60mm thick, M-35 grade, laid over & including 50mm thick stone dust/grit, complete all as specified and directed.

M&L PCC 1:4:8 type D-2 as in foundations, filling in mass concrete etc. complete all as specified and directed

M&L for PCC 1:3:6 type C-2, (using 40mm graded stone aggregate) of 75mm thick, laid in alternate bays as in path and plinth protection including finishing the surfaces even and smooth using extra cement, complete all as specified and directed

Supply only chain link MS galvanised fencing any size or type complete all as specified and as directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire, complete all as specified and directed.

Supply & Fixing MS work in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed.

Supply & Fixing MS framed work as in doors or gates or drain covers of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete conforming to Fe 410-W (Gde- E- 250) quality-A, complete all as specified and as directed.

M&L for 3mm thick Aluminium Composite Panel (ACP) exterior grade (skin thickness 0.25mm) including aluminium anodised frame work of AA 300/5000 series with one core of material of virgin LDPE and coating of kynar 500 resin based PVDF coating (metallic colour) with joint filling silicon weather proofing any colour, complete all as specified and directed.

M&L for 150mm thick PCC 1:4:8 type D-2 (Using 40mm graded stone aggregate) as in sub base of floor, finished the surfaces fair & even, complete all as specified and directed.

M & L for 100mm thick PCC 1:2:4 type B-1 (using 20 mm graded stone aggregate) as in flooring, finished even and smooth surfaces with out using extra cement complete all as specified and directed.

M&L for forming contraction (Dummy) joints 65mm deep x 10mm wide, filled with 'A' grade sealing compound, complete all as specified and directed.

M&L for PCC 1:2:4 type B-1 using 20 mm graded stone aggregate as in roof kerbs or mud stops etc., rounded or chamfered on edges etc., complete all as specified and directed.

Taking down chowkhat or frames exc. 1.5 sqm but n. exc. 4 sqm each with shutter without taking off shutter from the frame complete all as specified and directed.

M&L for preparation of new plastered surfaces of walls and applying two coats of oil bound distemper complete all as specified and directed

M&L for framed work as in grills, gratings etc. with ends of bars shouldered and / or rivetted, or forged into spikes; framed guard bars; barred iron door, ladder, railings and similar work conforming to Fe 290 Gde E-165, complete all as specified and directed.

M&L for rendering 15 mm thick on fair faces of brick or stone or concrete surfaces in cement mortar 1:6 with finished even and smooth without using extra cement including taking down of old existing cement plaster, complete all as specified and directed

M&L for rendering 15 mm thick on fair faces of brick or stone or concrete surfaces in cement mortar 1:4 with finished even and smooth without using extra cement complete all as specified and directed

M&L for applying two coats cement base paint (snowcem) over a coat of primer on new walls surfaces, including preparation of surface of walls, complete all as specified and directed.

M&L for two coats of synthetic enamel paint over a coat of red oxide primer on new steel surface of any description exc. 10 cm width or girth, including preparation of new steel surfaces, complete all as specified and directed.

M&L for preparation of any description of surfaces over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of primer on brick / concrete surfaces, complete all as specified and directed

M&L for shingle / sand filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled, and blinded with earth and rammed including watering etc complete all as specified and directed

Excavation in trenches, not exc 1.5 m wide and not exc 1.5 m in depth; for foundation etc. and getting out in soft /loose soil, complete all as specified and directed.

Excavation in soft / loose soil for post holes (or similar holes) each n.exc. 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth arround, in layers n. exc. 25 cm, watering, and removing surplus soil to a distance n. exc. 50m and making good disturbed surfaces, complete all as specified and directed.

Removing excavated material exceeding 1.50 Km but n. exc. 5 Km and depositing where directed at a level not exc. 1.5 m above the starting point, complete all as specified and directed

TULSAYA CONSTRUCTION (BID ID -3243824)

K S CHADHA AND SONS (BID ID -3243681)

M/s.BAJRANG CONSTRUCTION (BID ID -3243236)

Sunny Enterprises (BID ID -3242527)

ANIL CONSTRUCTION CO. (BID ID -3241106)

Gauri Associates (BID ID -3243801)

M/S - SUJIT ELECTRICALS (BID ID -3249729)