Repairing of Residence No. 21/2 and 21/4 of PA Block Canal Colony Cantt Road, Lucknow. (Lot No.46)

Amount

Dry Earth work in Foundation including disposal and back filling with all cost of labour, matrerial and T&P etc.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:3:6 (1 Cement : 3 coarse sand (zone-III) : 6 graded stone aggregate 20 mm nominal size)

Brick work with common burnt clay non modular bricks of class 150 in foundation and Cement mortar 1:6 (1 cement : 6 coarse sand)

Brick work with common burnt clay non modular bricks of class 150 in superstructure above plinth level up to floor V level in all shapes and sizes Cement mortar 1:6 (1 cement : 6 coarse sand)

12mm cement plaster in sigle coat on rough side of single/ half brick wall for interior/ exterior plastering in single storey building finished even & smooth 1 cement : 4 coarse sand including all L/M, T&P etc.

Providing corrugated G.S. sheet roofing including vertical / curved surface fixed with polymer coated J or L hooks, bolts and nuts 8mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/ vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 1.00 mm thick with zinc coating not less than 275 gm/m²

Providing and applying white cement based putty of average thickness 2 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

One priming coat & two coat oil distemper on new work including supply of all materials, labour and T & P etc required for proper completion of the work .

Providing and fixing C.P. brass bib cock of approved quality conforming to IS 8931 15mm nominal size

Providing and fixing ISI marked oxidised M.S. sliding door bolts with nuts and screws etc. complete 250x16 mm

Providing and fixing bright finished brass tower bolts (barrel type) with necessary screws etc. complete size 250x10 mm

Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810 gms 15 mm nominal bore

Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 15 mm nominal bore

M/S KISHORE KUMAR