PROVISION OF SECURITY BOUNDARY WALL IN UPPER MES COLONY AT MIL STN KALKA UNDER GE (I) JUTOGH

Excavation in trenches in hard/ dense soil n. exc 1.5m wide and n. exc 1.50m deep and getting out complete all as specified and directed

M&L for PCC 1:4:8, type D-2, using 40mm graded crushed stone aggregate as in foundation, mass concrete for stay set/ Pole/ FPB etc including fair finish even and fir to exposed surfaces without using extra cement, complete all as specified and directed.

S&F for Mild steel bars 10mm dia TMT bar and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

S&F Mild steel bars 5mm and over upto and including 10mm dia in stirrups spaces and binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

S&F angle iron as in posts and struts for fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc flat iron fillets (for securing wire mesh etc) including all necessary drilling bolting or riveting etc and similar work conforming to Fe-290, gde E-165, complete all as specified and directed.

S&F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.5mm thick of any colour having tensile strength of 550 Mpa as in roof covering/ cladding to wall, fixed with self tapping screws, complete all as specified and directed.

S&F in repair Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc., (each line wire to be measured), complete all as specified and directed.

M&L for Punched tape concertina coil 610 mm dia, made out of 2.60 mm dia ( + 0.05 mm) high tensile spring steel wire (1620 MPA) with having zinc coating of 120 gms/Sqm as per IS: 228. Each coil having a min 50 turns (Circles), average weight 7.50 to 8 Kg ( + )5% including handle and spikes at both ends of coil errect and fixed on top of the 'Y' Shape fencing, tied to the barbed wire/ angle iron with suitable GI binding wires, complete all as specified and directed. Specifications: Diameter: 610 mm No of Rounds: 50 rounds Stretch of each coil: 6-8 meter Total length of straight wire in each coil: 94.26 Meter barb Length (mm): 11.50 mm ( + 2.00 mm) Weight of each coil: 7.50 to 8 Kg

M&L for formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter, complete all as specified and directed.

M&L for formwork to sides of pillars, posts, struts, piers, columns and stanchions incl fair finishes of surfaces, complete all as specified and directed.