REPAIR/ MAINT OF DRAIN FENCING FOOTPATH AND BDY WALL IN ZONE F AREA OF AGE B/R-II (WEST) UNDER GE (WEST) LUCKNOW

Amount

M&L for rendering 15 mm thick in cement mortar 1:4 on brick wall or concrete surface including finishing the surface even and fair including taking down cement or cement lime plaster on walls any description including racking out joints hacking for key, scrubbing down with water etc. and removing rubbish complete all as specified and directed.

M & L for preparation of new surface of walls and applying two coats of cement base paint complete all as specified and directed.

Excavation in trenches, n. exc. 1.5 m wide and n. exc 1.5 m in depth ,for foundation, laying of pipes, cables etc. or for shafts , wells, cesspits, manholes, pier holes, etc. n.exc. 10 Sqm on plan and n. exc. 1.5 m in depth and getting out in hard/dense soil complete all as specified and directed.

M&L PCC type C2, 1:3:6 (40mm graded aggregate) as in foundation, filling and mass concrete incl demolitiom of existing complete all as specified and directed.

M&L for brick work with fly ash bricks, old size, straight or curved on plan exceeding 6 mtr mean radius and built in cement mortar 1:6 including demolition of brick work built in cement mortar including precast concrete articles complete all as specified and directed.

M&L for rendering 15mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4 finished even and fair complete all as specified and directed.

M&L plain cement concrete type D-2, 1:4:8 (using 40mm graded stone aggregates) as in foundation, posts filling, sub base of floors including necessary formwork including demolition of cement concrete (unreinforced) in ground floor and paving n exc 15 cm thickness and below or above ground level complete all as specified and directed.

M&L Cement concrete 1:2:4 type B1 using 20mm graded aggregate in cills, steps, coping and like including necessary form work including demolition of cement concrete (unreinforced) in ground floor and paving n exc 15 cm thickness and below or above ground level complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in soft/loose soil complete all as specified and directed.

Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting poin complete all as specified and directed

M&L for 75 mm thick PCC 1:3:6 type C1 using 20 mm graded crushed stone aggregate as in plinth protection surface finished fair and even complete all as specified. Note :- Plinth protection shall be of width as directed and shall be laid to slope of 1:30 in alternative bays not exceeding 3 meter in length. Joints of 6 mm wide and 10 mm deep shall be provided along the wall and bays and same shall be filled with bitumen mastic (1:3) including demolition of old existing PCC complete all as specified and directed.

M&L for 75 mm thick Cement concrete PCC 1:4:8 type D-2(using 40 mm graded granite stone aggregate) in sub base including demolition of cement concrete (unreinforced) in ground floor and paving n exc 15 cm thickness and below or above ground level complete all as specified and directed

Providing and laying of Machine pressed roubber moulded precast conctete interlocking paver block any shape and size of 60-62mm thickness, M-35 Grade laid over and incl 25 mm thick sand cushion and joint filled with fine sand including leveling tamping & sweeping etc including dismantling stone slab and tiles of any description or thickness laid bedded and pointed in any mortar complete all as specified and directed.

M & L of Chequered cement concrete tiles 30cm x 30cm x 20mm thick, set, jointed and pointed in neat cement slurry in floors including 15mm thick screed bed in cement & sand mortar 1:6 complete all as specified and directed.

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning,filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm,in soft/loose soil complete all as specified and directed.

S & F angle iron as in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc; flat iron fillets including all necessary drilling, bolting or rivetting etc and similar work confirming to Fe 290 Gd E-165 complete all as specified and as directed.

S & F mild steel screw bolts (machine made ) with hexagonal or square heads at one end, 10mm dia, not exc 10 cm long, bolt with waher and nuts complete all as specified and directed.

Supply of GI wire chain link fencing with 75x75mm mesh size and fixed to any type of strandard rails straining bolts etc including provision of binding wire complete all as specified and directed. Note: Weight constantant shall be detrmined by BOO of chain link fencing.

Fixing only chain link fencing including line wires, any mesh, size and type fixed to any type of standards rails, straining bolts, etc.including provission of binding wire complete all as specified and directed.

M&L preparation of new steel Surfaces of any description, over 10cm in width or girth,not otherwise described and applying two coat of synthetic enamel paint over a coat of red oxide complete all as specified and directed.

M&L for Providing factory made RCC cover full floor mediun duty weight Square/rectangular exc 0.30 sqm but n.exc 0.70sqm thickness not less than 75mm set in CM 1:6, as in cover slabs (for manhole, drains etc) with plain fair faces, with angle iron frame alround all as specified and directed.

M&L for Providing precast cement concrete 1:2:4, type B1 (20 mm graded aggregate) set in CM 1:6, as in cover slabs (for manhole, drains etc) with plain fair faces, incl demolition of existing complete all as specified and directed.

M&L MS deformed or twisted bars 10mm dia and over, cut to length, bent to shape required, including cranking,bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed)not less than 0.9mm dia complete all as specified and directed.

Rectifying complaints of blockage of bathroom / kitchen / WHB / urinals / WCs etc of any pattern and make it fully functional. The blockage shall be cleared complete all as specified and directed. (a) The period of rectifying each complaint is maximum 48 hrs and Rs 100 / each complaint will be charged for each complaint in case of failure to rectify the complaint in the stipulated period. (b) The contractor shall provide adequate labours and tools to rectify the complaints. (c) The sludge obtained during rectifying the complaints shall be deposited beyond the periphery of defence land.

Rectifying complaints blockage of manholes depth not exc 1.00 mtr incl removing all sludge complete all as specified and directed. (a) The period of rectifying each complaints is maximum 48 hrs and Rs 100 / each complaint will be charged in case of failure to rectify the complaint in the stipulated period. (b) The contractor shall provide adequate labours and tools to rectify the complaints. (c) The sludge obtained during rectifying the complaints shall be deposited beyond the periphery of defence land.

Rectifying complaints blockage of manholes depth exc 1.00 mtr but not exc 1.50 mtr incl removing all sludge as specified and directed (a) The period of rectifying each complaints is maximum 48 hrs and Rs 100 / each complaint will be charged in case of failure to rectify the complaint in the stipulated period. (b) The contractor shall provide adequate labours and tools to rectify the complaints. (c) The sludge obtained during rectifying the complaints shall be deposited beyond the periphery of defence land.

Rectifying complaints of blockage of sewage lines 100 mm dia of any length & depth and make it fully functional complete all as specified and directed.

Rectifying complaints of blockage of sewage lines 150 mm dia of any length & depth and make it fully functional complete all as specified and directed.

Cleaning of soak well using mechanical pumps diesel driven with fuel, operator and necessary excavation on half buried night soil and disposed off soak well water etc in pits including necessary excavation and earth work for pits for burrying the night soil etc in soft/loose soil complete all as specified and directed.

Cleaning/disludging of existing septic tank of any capacity/sump well of any dia and depth incl taking out sludge in any form and other foreign matter etc viz sediment, sand, ash, grease, fibre, silt, roots or vegetation etc means of sewage sucking machine or by way of any other suitable means and removing the sludge outside MD land by any means complete all as specified and directed. Note: The sludge/burried soil etc taken out shall be stacked alongwith the septic tank, sump well etc. After 48 hours of the sludge taken out, measurement shall be taken as of the solid contents for the purpose of payment. The tenderer are advised take up this aspect in mind while quotating the rates. After taking measurements, the solid contents shall be disposed off outside the MD land/area

S & F in repair Vitreous China squatting pan of orissa pattern, size 580x440mm white with CI ‘P’ or ‘S’ trap, front or back inlet and foot rests, any pattern (including fixing of flush pipe) including provision of cement concrete bedding, in repair complete all as specified and directed.

S&F in repair Vitreous china wash down water closet pan (pedestal pattern), white, complete including fixing to trap, Incl Supply and fixing of PVC seat and cover for pedestal pan complete all as specified and directed.

S & F of CI spun Hubless Pipes 100 mm bore single socketed in any length socketed in any length in trenches or in floors with shield coupling SS (304) with EPDM rubber gasket but fixed to walls including taking down old pipe complete all as specified and directed

S & F of CI spun Hubless Pipes 75 mm bore single socketed in any length socketed in any length in trenches or in floors with shield coupling SS (304) with EPDM rubber gasket but fixed to walls including taking down old pipe complete all as specified and directed

S & F of CI spun Hubless bends any radius 100 mm size complete all as specified and directed.

S & F of CI spun Hubless bends any radius 75 mm size complete all as specified and directed.

S & F of any bore pipe stack clamps out of 50 mm by 5 mm flat iron and 16mm dia round iron stays or hold fast(brass/ stainless steel), including bolts and nuts and securing ends of stays to wall or roof any type complete all as specified and directed.

M & L of repair 100 mm dia CI any type of trap fixed in cement concrete type B-1 (1:2:4) complete all as speciifed and directed.

S & F in repair of plastic water closet seat cover (any size/ shape) closed pattern with flat bottom and cover and mild steel chromium plated or aluminised hanging device complete all as specified and directed.

M/S Reliance Construction (BID ID -3110619)

M/s Bajpai Constructions (BID ID -3107210)

abhinish traders (BID ID -3124063)

M/S S S A ASSOCIATES (BID ID -3111474)