Widening and strengthening work of Nevada Gajnpur Duwariya Pure Pehalwan Paliya Musafirkhana road from chainage 0.000 to 5.800 (including 5-year maintenance)

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 Carted Earth For Pound Portion.

Providing and laying granular sub-base (GSB) by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in plant method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401.As per Direction of E/I.

For T Junction

Scarifying the existing bituminous road surface to a depth of 50 mm and disposal of scarified material with in all lifts and lead upto 1000 metres.50%

Dismentling of existing Interlocking Paver Blocks and disposal of scarified material with in all lifts and lead upto 200 metres. As per SI No-697

Relaying of 80 mm thick C.C. Pre rubber moulded inter locking paver tiles incl. 40 mm thick fine sand cusion bed in proper slope & camber including all material, labour, T&P etc. required for proper completion of the work. Only labour rates only 50% of Dismateled tiles

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density. As per MORT&H reff.- 406

For T Junction

Providing and applying primer coat with bitumen emulsion on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means.

For T Junction

Providing and laying dense graded bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder @ 4.5 per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 505 complete in all respects.

For T Junction

Providing and applying tack coat with Bitumen VG-10 using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous/granular surface cleaned . as per MORT&H Sp. 503. As per Direction of E/I.

For T Junction

Providing and laying bituminous concrete with 100-120 TPH batch type HMP producing an average output of 75 tonnes per hour using crushed aggregates of specified grading premixed with bituminous [email protected] per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finesher with senser control to the required grade,level and alignment,rolling with smooth wheeled,vibratory and tandem rollers to achieve the disiered compaction as per MoRT&H specifications clause 509 complete in all respects . As per Direction of E/I.

For T Junction

Construction of un-reinforced, dowel jointed, plain cement concrete pavement, over a prepared sub base, with approve grade cement @ 400 kg. per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with fixed form or slipform paver, spread, compacted and finished in a contiuous operation including provision of contraction expension, construction and longitudinal joint, joint filler separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compund, finishing to lines and grades as per drawing.

Construction of earthen shoulders (Patries) with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 As per Direction of E/I.

For T Junction

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross-sections, and transporting to the embankment location with a lift upto 1.5 m and lead upto 1000 m as per Technical Specification Clause 302.3 For Drain

Construction of Duct For Road Cross

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 For Drain

Construction of Duct For Road Cross

Plain/reinforced cement concrete in substructure complete as per drawings and technical specification Clauses 802, 804, 805, 806, 807, 1202 ans 1204 For Drain

Construction of Duct For Road Cross

Supplying, fitting and placing HYSD bar reinforcement (Fe 415) in substructrue complete as per drawings and technical specification Clauses 1002, 1005, 1010 & 1202 , For Drain

Construction of Duct For Road Cross

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross-sections, and transporting to the embankment location with a lift upto 1.5 m and lead upto 1000 m as per Technical Specification Clause 302.3 (1000 mm)

For 600 MM

For 350 MM

Supply Of RCC Hume Pipes NP-3 as Per Direction Of E/I. (1000 mm)

For 600 MM

For 350 MM

Laying & fixing of 1000 mm dia NP-3 pipe with collers As per SOR Chapter-17. (1000 mm)

For 600mm

For 350 MM

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 (1000 mm)

For 600mm

For 350 MM

Brick Masonry Work in Cement Mortar 1:3 in Foundation complete excluding Pointing and Plastering, as per Drawing and Technical Specifications.(1000 mm)

For 600mm

For 350mm

Struck pointing 1:2 in cement and fine sand mortar as per SI-13.32.1.(1000 mm)

For 600mm

For 350mm

Plastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1204

For 600mm

For 350mm

Plain Cement Concrete M-15 in complete as per Drawing and Technical Specifications.as per SOR 4.2.5

Reinforced Cement Concrete Grade M25 for wall & slab etc. complete as per Drawing and Technical Specifications.as per SOR-5.3

Supplying, Fitting and Placing un-coated HYSD bar Reinforcement in sub-structure complete as per Drawing and Technical Specifications.

S/F KM Stone,Hecto-stone, etc complete work

Maintenance Cost @ 2.50% As per Go No. 17/2024/Sa-113/23-23-1-2024-23-1099/113/2023 Dt 16.01.2024 and 3689C/PRML/Mul-23-24 Dt 17.02.2024

Note : 1. Item for which no rate has been entered in will not be paid for by the Employer when executed and shall be deemed covered by the other rates and prices in the bill of quantities (Refer : ITB Clause 13.2 and GCC Clause 43.3). 2- Unit rates shall be quoted by the bidder in Indian rupee [ITB Clause 14.1].

Please Enable Macros to View BoQ information