Construction of MNB 28.880 on Digras Darwha Karanja section in (km ch.0.00 to 74.351) NH361C two lanes with paved shoulder in the state of Maharashtra. (At Risk and Cost of contractor).

Excavation for foundation in hard murum including shoring and strutting , dewatering as necessary and disposing off excavated stuff as directed etc. complete. a) Upto 1.50m lift Normal Rate b) 1.50m to 3.00m lift, Add 10% c) 3.00m to 4.50m lift, Add 20% d) 4.50m to 6.0m lift, Add 30%

Back filling behind abutment ,wing wall and return wall as per drawings and technical specifications etc. complete. (by sandy material)./cutting bushes,grass and dressing shoulder to desired camber and disposing of excavated stuff up to road boundary etc complete. as directed by Engineer In Charge.

Providing and laying filter material under neath pitching in slopes as per drawings and technical specifications etc. complete.

Providing and laying Cast insitu / Ready Mix cement concrete in M15 of trap / granite / quartzite / gneiss metal for foundation and bedding / steps including steel centering , formwork , laying / pumping , compacting , roughening them if special finish is to be provided , finishing uneven and honey combed surface and curing etc . complete . The Cement Mortar 1:3 plaster is considered for rendering uneven and honey combed surface , only . Newly laid concrete shall be covered by gunny bag , plastic , tar paulin etc . ( Wooden centering will not be allowed . ) , with fully automatic micro processor based PLC with SCADA enabled reversible Drum Typemixer / concrete Batch mix plant (Pan mixer) etc. complete. With fine aggregate (Crushed sand VSI Grade)

Providing and laying in situ / ready mix M-35 cement concrete of trap / granite / quartzite / gneiss metal for cast in citu R.C.C. solid piers , column etc . including provision of V shaped false joints to form suitable panels on the faces to approved design with compacting by vibrating and curing complete . Including plywood / steel formwork , centering (excluding dewatering by means of pump) and including bailling out water and including CM 1:3 curing complete. a) Height upto 5 M. (With Concrete Mixer) i) Height up to 5 m, normal rate. ii) Height 5 to 7.50 m, add 5 percent extra over basic rate. iii) Height 7.50 to 10 m, 7.50 percent extra. iv) Over 10 m Height , add 10 percent extra fore very 2.50 m rise with fine agreegates of required specifications ( VSI sand finely washed etc)

Providing, cutting, bending, hooking, tying and laying in position TMT FE 500 steel bars for reinforcement for all RCC works as per detailed drawings etc. complete.

Providing and laying insitu/ready mix M-35 plain cement concrete of trap/granite/quartzite/gneiss metal for cast insitu piers,abutment,returns,wings etc. including provision of "V" shaped false joints to form suitable panels on the faces to approved esign with compacting by vibrating and curing complete,including plywood/steel form work centering (excluding dewatering by means of pump ) and including bailling out water and curing finishing in CM 1:3 etc. complete . as directed by engineer incharge basicrate shall be increased for height above 5.00 m in following manners b) Height upto 5 M. (With Batch Mix Plant)With fully automatic microprocessor based PLC with SCADA enable with fine agreegates of required specifications ( VSI sand finely washed etc ) i) Height up to 5 m, normal rate. ii) Height 5 to 7.50 m, add 5 percent extra over basic rate. iii) Height 7.50 to 10 m, 7.50 percent extra. iv) Over 10 m Height, add 10 percent extra for every 2.50m rise.

Providing cutting, bending, hooking, tying and laying in position TMT FE 500 steel bars for reinforcement for all RCC works as per detailed drawings etc. complete.

Providing and laying insitu / ready mix M-35 cement concrete Trap / Granite / Quartzite / Gneiss metal for R.C.C.well curbs including necessary compacting by vibrating , finishing and curing complete . with fine agreegates of required specifications ( V S I sand finely washed etc )( excluding reinforcement and includings huttering) A ) With Batch Mix Plant With fully automatic micro processor based PLC with SCADA enabled.

Providing and laying Cast in situ/Ready Mix cement concrete M-35 of trap / granite/quartzite/ gneiss metal for R.C.C. work in foundations like raft, strip foundations, grillage and footings of R.C.C. columns and steel stanchions etc. columns as per detailed designs and drawing or as directed including Steel centering, formwork, cover blocks, laying/pumping, compaction finishing the formed surfaces with cement mortar 1:3 of sufficient minimum thickness to give a smooth and even surface or roughening if special finish is to be provided and curing etc. complete,(Excluding reinforcement and structural steel).with fully automatic micro processor based PLC with SCADA enabled reversible Drum Type mixer/ concrete Batch mix plant (Pan mixer) etc. complete. With fine aggregate (Crushed sand VSI Grade)