Special Repair of 7.5 MLD S...

[12.157.1.1]Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing / panelling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge. (Glazing, panelling and dash fasteners to be paid for separately) : 1.1. For fixed portion Anodised aluminium (anodised transparent or dyed to required shade according to IS: 1868, Minimum anodic coating of grade AC 15) [Through Rate]

[12.158.2]Providing and fixing 12 mm thick prelaminated particle board flat pressed three layer or graded wood particle board conforming to IS: 12823 Grade l Type ll, in panelling fixed in aluminium doors, windows shutters and partition frames with C.P. brass / stainless steel screws etc. complete as per architectural drawings and directions of engineer-in-charge. 2. Pre-laminated particle board with decorative lamination on both sides [Through Rate]

[30.28.1]Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : 1. One or more coats on old work [Through Rate]

Providing and Fixing of PLC card for scada system

Providing and fixing Chlorinators with providing of new Vaccum regulator, injector and service of leakage absorption system etc

C-Tech Hydrostatic Level Sensor

Providing and Fixing of DO sensor with transmitter for Ctech Basin

Providing and Fixing of Feed pump Stater, Spares

Sludge Dewatering Centrifuge including new Bearing and Lube seals etc

Providing and Fixing of 117mm PU DIFFUSER MEMBRANES, SS Clamp

Decanter New worm wheel, shaft replacement of C-Tech tank

Rake Mechanism Gear Box , Replacement with new Brass Bushes , oil seals, bearings etc

PAV and SAS VALVE ACTUATORS of Limit Switch Replacement

ACB and VCB Braker of main panel and Pole Assembly, Jaw contact, Terminal, Replacement

Transformer Oil and Silica gel ,

DG set battery, DG Service

Providing and Fixing of Street light

Replacement of Computer and printer also

Water pilot (Sensor) Replacement

UPS online and Replacement of Online UPS batteries

Soft Starter for blower

Decanter VFD

Blower Servicing

Chain block for chlorine 4 ton

Juction Box

Blower Air filter

APFC Panel and capacitor

Blower VFD

Deduction for old material

Please Enable Macros to View BoQ information