SPL REPAIRS TO SEWAGE LINE FROM T-193 TO T-212 AT BAIRAGARH SRW-18, PROVN OF SHED FOR PARKING VEHICLE AT 21 CGSR REV-12, PROVN OF SHED FOR WHEEL ALIGNMENT AT 194 FWC REV-14 AND PROVN OF 2 X 1.5 SPLIT AC FOR ADDITIONAL DENTAL SURGERY ROOM AT MD

Amount

COMMON B/R ITEMS FOR JOB 'A', 'B' & 'C'

Excavating in post holes (or similar holes) in soft/loose / hard dense soil each not exceeding 0.5cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering and removing surplus soil to a distance not exceeding 50m and making good surface complete all as specified and directed.

M&L for Cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in foundations, filling and mass concrete complete all as specified and directed.

S&F Steel work in tubular/structural trusses including special shaped washer etc complete using ERW or induction butt welded tubes conforming to IS.1161-1979 grade St.-240 or steel sections conforming to Fe 410-W (Gde E-250) quality -A complete all as specified and directed.

S&F Rolled mild steel flat as wind ties conforming to Fe 410-W (Gde E-250) quality -A including securing bolts and all necessary drilling, bolting complete all as specified and directed.

S&F Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet, 0.5mm thickness, of colour as approved by GE, having tensile strength of 550 Mpa as in roof coverings/cladding to wall, etc, fixed with & including self tapping screws on angle frame complete all as specified and directed. [MAKE: TATA BLUE SCOPE / EVEREST INDUSTRIES/JINDAL]

M&L for Preparing new or previously untreated steel & iron surfaces of any description over 10cm in width or girth and applying two coats of synthetic enamel paint over & including a coat of red oxide zinc chrome primer complete all as specified and directed.

Removing excavated soil to a distance not exceeding 50m and depositing where directed. at a level not exceeding 1.5m above the starting point complete all as specified and directed.

S&F Mild steel TMT bars 10mm dia and over as reinforcement for concrete, cut to length, bent to shape required, including cranking, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all as specified and directed.

OTHER THAN COMMON ITEMS FOR JOB 'A'

Demolition and breaking up drain pipes (SGSW, AC, RCC or PVC) of internal dia 100/150 mm, set in cement mortar and disposal of unservicable materials and rubbish to a distance not exceeding 100m complete all as specified and directed.

Demolition and breaking up drain pipes (SGSW, AC, RCC or PVC) of internal dia 200 mm, set in cement mortar and disposal of unservicable materials and rubbish to a distance not exceeding 100m complete all as specified and directed.

Demolition and breaking up drain pipes (SGSW, AC, RCC or PVC) of internal dia 300 mm, set in cement mortar and disposal of unservicable materials and rubbish to a distance not exceeding 100m complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and paving not exceeding 15cm thickness (below or above ground level) complete all as specified and directed.

Excavation in trenches, not exceeding 1.5m wide and not exceeding 1.5m in depth for foundation, etc or not exceeding 10 Sqm on plan and not exceeding 1.5m in depth for shafts, cesspits, manholes, pier holes, etc and getting out in soft/loose soil complete all as specified and directed.

Excavating in trenches, not exceeding 1.5m wide and exceeding 1.5m but not exceeding 3m in depth for foundation, etc or not exceeding 10 Sqm on plan and exceeding 1.5m but not exceeding 3m in depth for shafts, cesspits, manholes, pier holes, etc and getting out in soft/loose / hard dense soil complete all as specified and directed.

Returning, filling in excavated approved soil, including spreading, levelling, watering and well ramming in layers not exceeding 25cm each complete all as specified and directed.

M&L for Cement concrete 1:3:6 type C-2 using 40mm graded stone aggregate in foundations, filling and mass concrete including sub base of floors complete all as specified and directed.

M&L for Concrete bed to drain pipes 150 mm bore including packing under and haunching against the sides of pipes after they are laid and tasted; in cement concrete 1:4:8 type D2 using 40mm graded stone aggregate complete all as specified and directed.

M&L for Concrete bed to drain pipes 200 mm bore including packing under and haunching against the sides of pipes after they are laid and tasted; in cement concrete 1:4:8 type D2 using 40mm graded stone aggregate complete all as specified and directed.

M&L for Concrete bed to drain pipes 300 mm bore including packing under and haunching against the sides of pipes after they are laid and tasted; in cement concrete 1:4:8 type D2 using 40mm graded stone aggregate complete all as specified and directed.

M&L for Concrete bed to drain pipes 450 mm bore including packing under and haunching against the sides of pipes after they are laid and tasted; in cement concrete 1:4:8 type D2 using 40mm graded stone aggregate complete all as specified and directed.

S&F Salt glazed stoneware drain pipes 200 mm bore, grade ‘A’, ISI marked, laid in trenches and jointed as specified complete all as specified and directed.

S&F reinforced concrete pipes, class NP2, 200 mm bore, laid and jointed with collars complete all as specified and directed.

S&F reinforced concrete pipes, class NP2, 300 mm bore, laid and jointed with collars complete all as specified and directed.

S&F reinforced concrete pipes, class NP2, 450 mm bore, laid and jointed with collars complete all as specified and directed.

S&F PVC (SWR) pipes, single socketed, in any length with rubber ring joints, laid in trenches or in floors,fixed to walls, etc 75mm bore complete all as specified and directed.

S&F PVC (SWR) pipes, single socketed, in any length with rubber ring joints, laid in trenches or in floors,fixed to walls, etc 110mm bore complete all as specified and directed.

S&F PVC (SWR) bends any radius, 75 mm bore complete all as specified and directed.

S&F PVC (SWR) bends any radius, 110 mm bore complete all as specified and directed.

S&F PVC (SWR) junction single (single T), equal or unequal, 75mm bore complete all as specified and directed.

S&F PVC (SWR) junction single (single T), equal or unequal, 110mm bore complete all as specified and directed.

S&F PVC (SWR) floor trap, plain with CP grating including jointing with solvent cement, dia of outlet 75 mm complete all as specified and directed.

Demolition of brickwork built in cement or cement lime mortar complete all as specified and directed.

M&L for Brick work with fly ash bricks (Modular), straight or curved on plan exceeding 6m mean radius, built in cement mortar 1:6 complete all as specified and directed.

Taking down cement or cement lime plaster, any description, on brick or stone walls, ceilings, etc including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for 15 mm thick plaster in CM 1:4 on brick walls or concrete surfaces in any position including finishing the surfaces even and smooth (without using extra cement) complete all as specified and directed.

M&L for 15 mm thick plaster in CM 1:6 on brick walls or concrete surfaces in any position including finishing the surfaces even and smooth (without using extra cement) complete all as specified and directed.

M&L for Providing cement concrete 1:2:4 type B-0 using 12.5mm graded stone aggregate in cills, seismic and other similar bands, plinth courses, copings, bed plates, bond stones, etc including weathering, slightly rounded or chamfered angles and throating as directed including necessary form work complete all as specified and directed.

Demolition of cement concrete (reinforced) in ground floors and paving not exceeding 15cm thickness (below or above ground level) reinforcement cut as required to facilitate demolition as in man hole covers complete all as specified and directed.

M&L for Providing precast reinforced cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in cover slabs (for manholes etc), shelves and similar articles with plain faces including necessary moulds and setting in cement mortar 1:4 complete all as specified and directed. (Note:-Reinforcement to be measured separately).

S&F Mild steel TMT bars 6 to 8mm dia as reinforcement for concrete, cut to length, bent to shape required, including cranking, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all as specified and directed.

M&L for Reinforced cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in slabs supported on walls, beams & columns complete all as specified and directed.

Cleaning of manholes of any description, size, depth and in any position, mechanically or manually by taking off sludge waste/night soil and silted soil from the existing manhole, collecting and removal of sludge in pit dug out for the purpose and covering with excaved soil complete all as specified and directed.

S&F in repairs Vitreous china squatting pan ‘Orissa’ pattern, size 580 x 440 mm, white with integral foot rests including provision of cement concrete bedding & ‘P’ or ‘S’ trap complete all as specified and directed. [MAKE:-SOMANY (Cat.No.121115), PRAYAG (Cat No.4055) or equivalent in CERA/PARRYWARE/ HINDWARE as approved by GE.]

Supply only integral water proofing compound complete all as specified and directed. [MAKE: ACCOPROOF/WATER SEAL/MC BOUCHAMIE, MUMBAI/FOSROC/CICO/PIDILITE as approved by GE]

Use & waste of Form work to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick, for fair finished flat surfaces of concrete complete all as specified and directed.

S&F PVC (SWR) vent cowl, 75mm bore complete all as specified and directed.

S&F PVC (SWR) vent cowl, 110mm bore complete all as specified and directed.

OTHER THAN COMMON ITEMS FOR JOB 'B'

S&F Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet, 0.5mm thickness, of colour as approved by GE, having tensile strength of 550 Mpa as in ridges, etc, fixed with & including self tapping screws complete all as specified and directed. [MAKE: TATA BLUE SCOPE / EVEREST INDUSTRIES/JINDAL as approved by GE]

OTHER THAN COMMON ITEMS FOR JOB 'C'

M&L for Cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate in foundations, filling and mass concrete complete all as specified and directed.

M&L for Cement concrete 1:2:4 type B2 using 40mm graded stone aggregate in floors and paving, 100 mm thick, laid in panels and finished even & smooth using extra cement including making joints 12mm wide to the full depth of PCC at every 3 meters and at every change of direction and filling the same with & including bitumen and sand 1:3 by weight or mastic filler and spike rolling to surfaces or making impressions of expanded metal on concrete surfaces whilst it is green complete all as specified and directed.

ITEMS FOR JOB 'D'

M&L for sub main wiring with approved colour coding as per IS (Red, Black and Green for single phase circuits) with two single core PVC insulated FRLS cable 1100V unsheathed with stranded copper conductor of 4.0 sqmm nominal cross section area and drawing into and including PVC conduit/ casing capping, ISI marked, medium grade, inclusive of all fittings such as tees, bends, junction boxes, elbows, saddles, pipe hooks, couples, lock outs, etc. 25mm external diameter and PVC insulated stranded copper conductor of 2.5 sqmm nominal cross section area as earth wire complete all as specified and directed. [Make of Cable : V-MARC/ Plaza/ Havells as approved by GE] Note : (i) Wiring to be done as per approved colour code in IE rule. (ii) Two runs of 4.0 sqmm cable, one run of 2.5 sqmm cable of earth continuity conductor & PVC conduit pipe shall be measured as one unit length.

S&F sheet metal earth plug & socket, single pole and neutral with and including 1no. single pole MCB 20 Amps 240 volts complete all as specified and directed. [Make:-Legrand Cat No. 607841 or equivalent in Crabtree/HAVELLS as approved by GE].

Supply, installation and commissioning of Split AC units (indoor & Outdoor) with cordless remote control unit and with in built air ioniser and plasma filter for better indoor air quality with minimum 5 star rating and EER 3.2 of capacity 1.5 TR, outdoor unit fixed on suitable steel brackets complete all as specified and directed. [Make:- HITACHI/ GENERAL/DAIKIN/ CARRIER as approved by GE]

S&F in replacement MCB SPN, 240 volts, 10 KA breaking capacity, 'C' curve, of capacity 6 to 32 amps complete all as specified and directed. [MAKE:Hegar (L&T)/ Siemens/ Legrand/HAVELLS as approved by GE]

Supply and installation of voltage stablizer of capacity 5 KVA for wall mounting, digital automatic operation, single phase, neutrally air cooled, indoor type and designed for input varation between 130to 280 volt with output voltage stablized at 220 volt with accuracy of +2.5% complete all as specified and directed. [Make: Venus/Accube/ Everest as approved by GE]

Deduct schedule of credit (calculation will be done off line) Rs.24,900.00

Samaksh Enterprises

M/S RAKESH TRADERS

MODI CORPORATION

M S MEWALAL UPADHYAY