65/EUCC-V/LESA/2023-24

Amount

Dragging, loading, carriage and unloading of following store materials with proper stacking from ESC Daliganj to JE dumps store and from JE dump store to work site within municipal area.

ST Pole 11 mtr. long

33 KV Vtype cross Arm (100x50x6 mm), ms channel

33 KV Pin Insulator

33 KV Pin with nut

MS earthing rod 20x2500 mm.

Stay Set 16x1800 mm

Guarding X arm of size 65x65x6 mm 2200 mm

4 wire earth wire of size 7/10 swg

G.I. wire 5 mm 6 swg

Erection/fixing of cross arm on existing 11 mtr. ST pole with Pin Insulator & other items under 33 KV existing line (Only 33 KV V Type cross arms, pin insulator provided by department)

Grouting,Plinting and Painting of new erected 11M long ST poles of single pole support,double pole cable exposures and end type poles of 33 KV lines

Digging of Pit in kachcha/Pakka land in depth upto 1/6 length of Pole, Dragging of STP from near by place/Dump, Erection of Single pole along with stone pad in bottom with proper alignment of line for 33 KV line on 11 M long ST Pole and refilling with ramming of earth.

Grouting of pole in depth of 1/6 the length of pole in ratio 1:4:8 in cement sand and brick balast as per RESPO norms.

Construction of pole plinth 300mm x 450 mm above ground level in 1:2:4 in cement, coarse sand and stone gritt as per RESPO norms.

Painting of new erected ST pole with two coat of red oxide paint,PO red paint at top of pole 2 M & balance by two coats of best quality aluminium paint ISI of Burger/Nerolac/Asian mark as per norms.

Fabrication & erection of single pole for 33 KV line on 11 M long ST Pole with fixing of necessary clamp & other acessories like 1 no. Channel cross arm, Danger board, No Plate, barbed wire etc. contractor shall provide, necessary clamps, F-Bracket etc. as per RESPO norms.

Stringing & Sagging of three phase 33 kv line on ACSR existing conductor as per RESPO Norms.

Guarding of O/H Line - Fabrication and fixing of gaurding angle on single/double Poles as per RESSPO Norms including provision of all necessary clamps and hooks. Stringing and sagging of Earth/GI wire withh caddle guarding of above 33 kv line as per RESPO Norms. Shifting of existing line conductor of 11 Kv/LT lines to maintain proper clearence in between both lines. (all the material arranged by contractor except steel and GI wire 6 swg)

Erection of Stay Set 16x1800 mm with proper grouting as per norms

Ordinary Earthing of pole by M.S. Earthing Rod 20x2500 mm as per Resspo Norms only earting rod provided by deptt

ARIHANT ELECTRIC COMPANY

dev engineering corporation