REPAIR ROOF, OHT, STAGING, WINDOW, DOORS, JOINERY, PLUMBING WORKS IN OFFICER MD ACCN, JCOS OR ACCN AND OTM ACCN OF VARIOUS UNITS AT ZONE I AT MIL STN JAISALMER UNDER GE (A) JAISELMER.

Amount

Taking down shutters of any description exc 1 Sqm but not exc 2 Sqm each all as specified and as directed

Taking down chowkats or frames n.exc 1.5 sqm each, without taking off shutters from the frames including iron mongry.

Ditto- all as per item No 02 above but exc 1.5 sqm and n exc 4 sqm each

S & F factory made second class hard wood plain framed panelled shutters 35mm thick with panels of timber flat on both sides (feather edged) or of veneered particle board medium density wood particle tone veneers, fixed to chowkhat all as specified and as directed.

S & F glazed and skeleton shutters second class hard wood 35mm thick for door, open rebated and prepared to receive glass, gauze, etc. (without sash bars), edges of framing plain, chamfered or rounded. fitted with cut and mitred beads for securing glass, etc.; sizes of me-mbers of shutters as specified in SSR Part I, Section 8, clause 8.24 (a); supplied and fitted to chowkats etc all as specified and directed

Solid PVC door frame of size 50 mm x 47 mm made out of 5 mm plain colour PVC sheet reinforced with M S square tubes, S&F in opening as per specification & drawing given in SSR 2010.

M & L for factory made solid PVC moulded door shutter , 28 to 30mm thick (stiles) with 2,4 or 6 raised panel design with 2mm thick moulded PVC sheet on the foront face & 2mm plain colour PVC sheet on back face supplying and fixing in frame at site as per specification & drawing.

S&F steel ventilator with top hung shutter including hinges, steel peg stay, complete all as specified & directed by Engineer-in-charge. Note :- To be fixed at any floor level not more than triple storey.

S&F factory made steel windows with side hung shutters including projecting type hinges with steel handle and steel peg stay complete with glazing bars, dovetailed or welded all as specified & directed by Engineer-in-charge. Note :- To be fixed at any floor level not more than triple storey.

S&F, 3mm thick, sheet glass ordinary quality and glazing with oil putty in squares not exceeding 0.50 sqm in each panes complete all as specified & directed by Engineer-in-charge. Note :- To be fixed at any floor level not more than triple storey.

Resecuring or easing and adjusting shutters of any description exc 1 Sqm and not exc 2 Sqm each without taking down of sutters.

S&F stainless steel wire cloth 0.36mm nominal dia of wire and average width of aperture 1.40mm and fixed with stainless steel wire staples complete all as specified & directed by Engineer-in-charge.

S&F, 100mm size, butt hinges, medium weight, cold rolled mild steel including necessary welding if required all as specified & directed by Engineer-in-charge.

S & F aluminium handle 125 mm cast type anodized

S & F mild steel sliding bolt 300 mm long plate type stove enameled black with bright bolt not less than 12mm dia with and including a minimum of 6 bolts and nuts, four on bolt plate and two on staple plate and fix complete all as specified and as directed

S&F 150 mm size aluminium anodised barrel tower bolts of extruded section all as specified & directed by Engineer-in-charge.

S&F 150 mm size extruded aluminium handle, fabricated type, anodiesed complete all as specified & directed by Engineer-in-charge.

S&F in repair Aluminium (Die cast) body Door closer hydraulically regulated, designation No 3, universal type, suitable for door shutters of 851 to 1000 mm in width and of weight between 61 to 80kg and fixed

M&L for preparation of new wooden surfaces exceeding 10 cms width or girth and applying two coats of synthetic enamel paint over one coat of pink primer complete all as specified.

M & L preparation of new steel surfaces exc 10cm in width or girth and applying two coat of synthetic enamel paint over a coat of red oxide primer primer

Dismantling floor hearth or wall tiling including cement mortar bedding (but not backing) removing serviceable tiles to store and rubbish off the premises.

M&L for 25mm thk PCC 1:2:4 type B0 using 12.5mm graded stone aggregate as in subbase of floors & finishing the surface even & smooth without using extra cement.

M&L for Cool roof tiles exterior grade 300 x 300 x 7 to 10mm including 15 mm thick screed bed in CM 1:6, set and jointed in neat cement slurry and pointed in coloured cement to match, all as specified and directed

M&L Non Skid (coloured) joint free ceramic tiles 7 to 8mm thick (square/rectangular) area of each tile exceeding 0.18 but not exceeding 0.38 sqm, including 15mm screed bed in floors in CM 1:6 etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match, complete all as specified and directed by Engr- in -Charge.

M&L Non skid ceramic coloured tiles 7 to 8 mm thick joint free tile square/rectangular area of each tile exceeding 0.06 but not exceeding 0.11 sqm, in floors etc. jointed in neat cement slurry and pointed in white or coloured cement to match with the colour of tiles and including scread bed or bedding layer 15mm thick in CM 1:6 all as specified.

M&L Glazed colour ceramic tiles (Joint free) in of size 350 x 250x 7mm /450X350X7mm thick as in dado including 10mm thick rendering in CM 1:4 all as specified.

Demolition of Concrete (unreinforcement) in ground floors and pavings n exc 15 cm thickness (below or above ground level)

M&L for 75mm thk cement concrete 1:4:8 type D2 using 40mm graded stone aggregate as in subbase of flooring/hard standing as specified

S & F rubber moulded chequered cement concrete tiles 20cm X 20 cm X 25mm thk with grey cement and pigments,set jointed in neat cement slurry as in floors/path etc over and including 15mm thk screed bed in CM 1:4 complete.

M&L for PCC 1:2:4, 100mm thick using 20mm graded aggregate as in flooring.

Dismantling water tanks and removing to store (exc 250 and not exc 500 ltr capacity)

Dismantling water tanks and removing to store (exc500 and not exc 1000 ltr cap)

S&F in repair 500 ltrs capacity white colour three layer rotational moulded polythene water storage tank (Cylinderical vertical with closed top) hoisted and fixed in postion all as directed by Engg-in-Charge

-Ditto- All as per above, but 1000 ltr capacity.

Disconnecting existing tanks exc 250 and n.exc 500, setting aside (or lowering if required) for repairs, cleaning, etc. and hoisting if required reconnecting and re-fixing in position. (Cleaning repairing etc. measured separately) complete all as specified & directed by Engineer-in-charge.

All as per item above but exc 500 and n.exc 1000 litres

S&F in repairs Symet ball valve 20 mm with high pressure of PTMT with epoxy coated aluminum rod & high density plastic ball screwed for iron pipe and fixed min weight for 20 mm 210 gms, complete all as directed by Engr-in-Charge.

Taking up or down steel tubing and connections and S&F GI tubing (ISI) marked) medium grade with all fitting and fixed complete to wall ceiling or laid in floors of following sized :-

(a) 15 mm bore

(b) 20 mm bore

Dismantling Stone slabs and tiles of any description or thickness in floors, aprons laid bedded and pointed in any mortar etc.

M&L for Jodhpur stone roof slabs, self faced, 10.0cm to 12.5 cm thick, 25 cm to 35 cm wide, hoisted & set, jointed and grouted in cement mortar (1:3) all as specified.

Demolition of brick work /stone masonry built in cement mortar incl coping of any description all as specified and directed.

Precast cement concrete block masonry with solid blocks PCC type C1 (1:3:6) (using 20mm graded aggregate) exc 10cm in width and setting in CM 1:6

M& L Plain cement concrete 1:3:6 type C 1 using 20mm graded stone agregate cast in situ kerb stone ,copings, bed plates ,water through and the like including wethering, slightly rounded or chamfered angles and throating including use of form work (straight or curved ) set in CM 1:4 complete all as specified and as directed by Enginneer in charge

Taking down cement or cement lime plaster, any description on brick or stone surfaces ofany position etc including racking out joints, hacking for key, scrubbing down with water etc and removal of rubbish off the premises and leaving the work clear of any plastering complete all as specified & directed by Engineer-in-charge.

M&L for rendering 15 mm thick plaster in cement mortar (1:4) on fair faces of brick work or concrete surfaces of walls and finishing the surface even and smooth without using extra cement all as specified and directed by Engineer-in-charge.

M&L for rendering 15 mm thick plaster in cement mortar (1:6) on fair faces of brick work or concrete surfaces of walls and finishing the surface even and smooth without using extra cement all as specified and directed by Engineer-in-charge.

M&L for preparation of new plastered surfaces of wall and applying two coats of distemper oil emulsion over 3mm thick wall care putty

M&L for prepration of new plastered surface of wall and applying two coat of cement base paint over a coat of primer, complete all as specified and directed.

Taking down Shutters of any description exc 2 Sqm each, all as specified and as directed.

S&F 50 mm thick sand stone slabs Jaisalmer pattern/colour in sun-shades, chajjas, shelves, cills, landings, cover stones, templates, etc not exceeding 2m in length, punched dressed on face and along exposed edges, self faced on other side and set and pointed in cement mortar (1:4) complete all as specified & directed by Engineer-in-charge.

Dismantling water tanks and removing to store (exc 1000 and not exc 2000 ltr capacity)

S&F in repair 250 ltrs capacity white colour three layer rotational moulded polythene water storage tank (Cylinderical vertical with closed top) hoisted and fixed in postion all as directed by Engr-in-Charge

S&F in repair 2000 ltrs capacity white colour three layer rotational moulded polythene water storage tank (Cylinderical vertical with closed top) hoisted and fixed in postion all as directed by Engr-in-Charge

Demolitoin of Concrete (reinforced) in ground floors and pavings n. exc 15 cm thickness above ground level)

M &L Squared rubble walling Jodhpur type, brought upto courses, well bonded, bedded and solidly hearted, built in CM 1:6

AMBEY MAA CONSTRUCTION COMPANY

GEMRARAMCONTRACTOR

M/S MAYA CONSTRUCTION COMPANY

Dadhich Engineers

M/s Shri Inder Construction Company

BHAGWATI CONSTRUCTION

Leelashah Enterprises