Providing Special repair works for Mini Handloom hall and Construction of 6 Nos. of toilet at Sirumugai Industrial Handloom Weavers Co-operative Society Office in Coimbatore District.

Amount

1.1 : Earth work excavation in all soils (including refilling) a. 0 to 2 mt.

30 : Ellispattern

39 : S & F of M.s Grills

51.2: Supply and erection of Rotational Moulded Polyethylene water storage tanks (HDPE Cylinderical vertical type) for outdoor use having capacity of 1000 litres

52 : PVC Water supply (ASTM) a. 32 mm dia

b. 25 mm dia

c. 20 mm dia

55.2 : Flat Back Urinal

Electrical arrangements 74 : Charges for fixing of "Fan"

112 : S & F of Exhaust Fan 300 mm dia

ANNEXURE-I 2.1.1 : Supplying and filling Gravel

2.1.3 : Filling crushed stone sand

3.1.1: P.C.C.1:5:10 for Foundation & Basement (using crushed stone sand)

6.2.1.1 : Brick work in C.M. 1:5 (F& B) with Admixture using Fly ash bricks of size 230x110x70mm having the compressive strength of not less than 100 Kg/CM²

9.2.1.1: Brick work in Cement Mortar 1:6 (One of cement and six of Crushed stone sand) with Admixture using Fly ash bricks of size 230x110x70mm having the compressive strength of not less than 100 Kg/CM² for superstructure in the following floors a. In Ground floor

10.2.1.1 : Brick partition wall in Cement Mortar 1:4 (One of cement and four of Crushed stone sand with Admixture) 110mm thick for super structure in the following floors using Fly ash bricks of size 230x110x70mm having the compressive strength of not less than 100 Kg/CM² in the following floors b. In Ground Floor

14.1.1.II : Precast cupboard slab 40 mm tk using standardised concrete mix M20 grade.(using crushed stone sand) a. In Foundation & basement

16.1.2 : Precast Jally Ventilator 50mm thick. Using standardised M20 grade concrete Mix. (using crushed stone sand) a. In Ground Floor

21.5.2 : Supply and fixing Solid UPVC door shutter with frame

23.2.1 : 4mm thick pin headed Glass panels with Aluminium beedings

26.1 : Flooring in C.C.1:5:10 (using crushed stone sand)

29.8.1 : Glazed tiles using Grout (Tile Joint Filler) (using crushed stone sand)

29.9.1 : Floor ceramic tiles using Grout (Tile Joint Filler) (antiskid) (using crushed stone sand)

33.1 : Plastering in C.M. 1:5, 12 mm tk. (using crushed stone sand) including plasticizer

34.1 : Plastering in C.M. 1:4, 12 mm tk.(using crushed stone sand) using plasticizer

38.7 : Plastic Emulsion PAINT including primer for inner walls

38.7.1 : Plastic Exterior Emulsion PAINT including primer for outer walls

43.1 : Supply & Fabrication of Mild steel / RTS grills (without cement slurry) for all sizes of rods.

53.5.2 : Wash Hand Basin of size 550 x 400 mm (White without Pedestal)

54.1.1 : S & F of 15mm dia half turn CP long body tap

54.2.1 : S & F of 15mm dia half turn CP short body tap

56.3.1: S&F of Indian Water Closet white glazed (Oriya type) of size 580 x 440mm with PVC SWR grade P' or "S' trap - In G.F.(using crushed stone sand)

57.1.2 : S & F of E.W.C (White) 500mm with PVC SWR grade "P" or "S" Trap (using crushed stone sand)

58.3 : PVC SWR pipe (Soil line) with ISI mark - type 'B'. a. 110mm dia.

b. 75mm dia.

58.5 : PVC (SWR) pipe with ISI mark - type 'A' for Ventilating shaft with cowl

60.1 : PVC Nahani trap (4way/2way)

67.1 : Wiring with 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark confirming IS: 694:1990 for 5 amps 5 pin plug socket point @ Switch Board Itself.

75.1.2 : Supply and delivery of 48" (1200 mm) Fan with ISI mark with Eletronic Dimmer

77.5 : Run of 2 Wires of 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark confirming IS: 694:1990.

211: Clean removal of the old cement plastering from the existing walls of brick masonry and racking out joints to 20mm deep without damaging the existing structure and surroundings and clearing the debris away from the site including cost of required tools and plant and necessary scaffolding if necessary etc., complete and as directed by the departmental officers.

212 : Dismantling the damaged cement concrete flooring C.C 1:5:10 (one of cement, five of crushed stone sand, and ten of hard broken stone jelly) without affecting the adjacent structures, including the cost of required tools and plants and clearing the debris away from the site etc., all complete and as directed by the departmental officers.

361.5.1: Supplying and fixing of Stain Free Nano Polish colour Vitrified Tiles of size 60cmx60cmx8mm for flooring (using crushed stone sand)

ANNEXURE - II A1: Plastering with CM 1:5, 20mm thick (using crushed stone sand) with plasticizer

A2: Supplying and laying of Rubber Moulded Hydraulic Pressed Paver Block of 63mm thickness and crushed stone sand filling for pointing of approved quality and make suitable colour including cost of conveyance of Paver Blocks and labour charges for laying to proper level, slope etc., all complete and as directed by the departmental officers. (Design and colour should be got approved by the Executive Engineer before use)

A3: CENTRIFUGAL MONOBLOC PUMPSET AS PER IS 9079/2002 WITHOUT PANEL BOARD THREE PHASE Supply and delivery of Electric Monoset centrifugal pump conforming to IS 9079:2002 as amend- ed from time to time, with CI FG 200 Casing, hydraulically and dynamically balanced Bronze grade LTB-2 impeller, impeller ring and casing ring, stainless steel shaft capable of discharging required quantity of water against a total head noted below due to all causes. Pump shall of BEE 3 Star Rated and capable of discharging the specified quantity at the head noted at the minimum NPSHA at site conditions. The shut off head shall be atleast 25% over and above the head at duty point. The pump shall be suitable for operation in AC three phase , 415 V+/- 10% , 50 Hz +/- 5%. Squirrel cage induction motor for continuous operation. The speed of the Pump and Motor shall be not less than 2700 to 2900 RPM respectively. Duty lpm x m - 50 X 50

A4: SINGLE PHASE PANEL BOARD WITH TWO LEVEL GUARD AND AUTO START Supply and delivery of direct online starter confirming to IS13947, IEC60947-1 and as amended thereafter with suitable KW rating for operation in AC/single Phase/50HZ(± 5%) and 230 V(±10%) including Ammeter, Voltmeter, Thermal Overload relay, 16 Amps 2 pole Magnetic Contactor with under Voltage protection, Indication lamp, starting capacitor, running capacitor and On/Off Push button switches, 5 way connector, wiring with 1 sq. mm/1.5 sq. mm copper PVC insulated cable, powder coated vermin proof box including the capacitor (the cost of capacitor is to be taken separately). For 1.5 HP

A5: Supply and delivery of 3 core 2.5 sqmm 1100V grade copper UG flat cable of best and approved quality having ISI mark etc., all complete as directed by the departmental officers.

A6: Supplying and fixing of LED blubs suitable for fixing it to pendent / bakelite battern holder of best approved variety a) 9 watts LED bulb

A7: Supplying and fixing of 18W LED TUBE LIGHTS 4' long with necessary fittings and charges for assembling and fixing

A8: Wiring with 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark confirming IS: 694:1990. (open wiring) a. Light Point with ceiling rose.

b. Light Point without ceiling rose.

A9: Wiring with 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark confirming IS: 694:1990 for Fan point.(open Wiring)

A10: Wiring with 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark confirming IS: 694:1990 for 5 amps 5 pin plug socket point @ Convenient Places.(open Wiring)

A11: Run off main with 2 wires of 2.5 Sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark conforming to IS: 694/1990, 1.1 KV grade cable with continuous earth by means of 1.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cablewith ISI mark etc., (Open Wiring)

A12: Run off main with 4 wires of 4 Sqmm PVC insulated single core multi strand fire retardant flexible copper cable with ISI mark conforming to IS: 694/1990, 1.1 KV grade cable with continuous earth by means of 2.5 sqmm PVC insulated single core multi strand fire retardant flexible copper cablewith ISI mark etc., (Open Wiring)

A13: Painting two coats for old wall with ready mixed PLASTIC EMULSION PAINT of first class quality paint of approved colour and shade without primer including cost of materials, thorough Scrapping,necessary brushes, labour charges, patty etc., all complete. (paints and its shade shall be got approved from the Executive Engineer before using)

A14: Painting two coats for old wall with ready mixed EXTERIOR PLASTIC EMULSION PAINT of first class quality paint of approved colour and shade without primer including cost of materials, thorough Scrapping, necessary brushes, labour charges, patty etc., all complete. (paints and its shade shall be got approved from the Executive Engineer before using)

A15: Painting the old Iron work and other similar works such as PVC /ASTM Pipes, Kerb Stone and grills with one coat of approved first class synthetic enamel ready mixed paint of approved quality and brand, with relevant Standard specifications including thorough scrapping, material & labour charges etc., all complete (paints and its shade shall be got approved from the Executive Engineer before using)

A16: Providing A.C. Sheet roofing of approved brand with 6mm thick ISI mark fully corrugated including cost and labour charges for fixing AC sheet and cost of "J" bolts, washers with adjustable ridges, bitumen washers etc., all complete with relevant standard specifications and as directed by the departmental officers. (The AC sheet should be got approved from the Executive Engineer before use)

A17: Supplying and fixing of 4 way Distribution Board including 8 Nos. of 16 amps MCB, 40 amps ELCB 4 Pole, rotary switch - 3 Nos, indicator - 3 Nos, including all materials and labour charges etc., supplying and fixing in position of wall making good of the concealed portion with earth connection only etc., all complete and as directed by the departmental officers.

A18: Supply and fixing fabricating Galvanized sheet roof fixing 0.40mm thick and cost of 40mm x 40mm square allow bar outer edge, 8mm thick 25mm length screws cost of "J" bolts, washers with adjustable ridges, bitumen washers including cost of materials, labour for fixing etc., complete with relevant standard specification and as directed by the departmental officers.

M/s.V.S.D CONSTRUCTION (BID ID -1261532)