Construction of tin shed backside of Md. Ainul house at Sansad No. - XIII, P. S. No.-207 under Ukhra Gram Panchayat under APAS,

Earth work in excavation of foundation trenches in all sorts of soil, including removing spreading or stacking the spoils within a lead of 7.5 m. as directed and including trimming the sides of trenches, levelling, dressing and ramming the bottom, bailing or pumping out water as required complete.

Sand filling in foundation or plinth in layers not exceeding 15cm. as directed and consolidating same by thorough saturation with water and ramming complete, including the cost of supply of sand.

Single Brick Flat soling of Picked Jhamma Bricks including ramming and dressing bed to proper level and filling joints with local sand including cost of sand.

Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuutering and reinforcement, if any, in ground floor

Brick work with 1st class bricks in cement mortar (1:6) (a) In foundation and plinth

Earth work in filling with carried earth arranged by the contractor within a radius of 1 km. including cost of carried earth.

Plaster (i) With 1:6 cement mortar (c) 15 mm thick plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/ staging where necessary (Groundfloor). [Excludingcost of chipping over concrete surface]

Neat cement punning about 1.5 mm thick in wall, dado, window sill, floor etc. NOTE: Cement 0.152 cu.m. per100 sq.m.

25mm. Thick Grey Artificial Stone Flooring with graded stone chips in floor, Dado, Staircase etc. with cement concrete 4:2:1 laid in panels as directed, with 3.25 mm. Neat cement finishing at top and including rounding of corners and preparation of bed

Supplying, fitting & fixing circular corrugated Aluminium sheet (excluding the supporting frame work) of approved make & brand in alloy 3105 conforming to IS: 1254-1991 fitted and fixed with 55 mm & 25 mm Self tapping screw , EPDM Washer 16 mm dia & 3 mm th washer etc complete with 150 mm. end lap and one corrugation minimum side lap. (i) In Roof:- b) With 0.71 mm thick sheet

Supplying, fitting & fixing Aluminium sheet ridging fitted with self tapping screws, EPDM washers etc complete.(Minimum 225mm end lapping). (A) 300 mm lapping each way (a) With 0.71 mm sheet

Supplying fitting and fixing M.S.structural works in roof trusses with square sections

Supplying, fitting & fixing UPVC pipes A- Type and fittings conforming to IS:13592-1992 with all necessary clamps nails, including making holes in walls, floor etc. cutting trenches in any soil through masonry concrete structures etc if necessary and mending good damages including joining with jointing materails (Spun Yarn, Valamoid/Bitumen/M-Seal etc) complete (ii) 110 mm. Dia

Display Board writing & photo (3 phase).

Add CGST @ 9.00% of Total Cost

Add SGST @ 9.00% of Total Cost

Labour welfare cess @ 1.00%

Add Contigency

Please Enable Macros to View BoQ information