AIC/AED/NIeT-19/26-27/Gr_2

Supply at site with transportatlon and handling of 6Mtr Galvanised octagonal poles designed by manufacture to satisfy structurally sale of wind speed 50mm/s as per IS:875 lantern carriage made of 40 NB of pipe Suitable from 40 no's 25 W smart integrated solar LED street light, a) Material grade of shaft shall be of S33510/JR as per BSEN10025 or IS-2062 grade E350 (BR) b) Material grade of base plate shall be E350(BR) as per IS- 2062, c) Galvanization as per BSEN ISO:1461 Manufacturer shall submit GA Drawing and structural calculation of poled duty certified, make as approved by EIC (Supply should be along with the logo on pole and test certificate)

Supply at site with transpotation and handling 4 nos. M20x100 foundation bolts as per TS-600 (6.8 grade) manufacture from special steel along with nuts, washers and templats (all are galvanized)

Suplying and Fiting and Fixing Module - 100 WP a). The PV Module shall contain crystalline silicon solar cells and must have MNRE certified b). The power output of the modules under STC would be a minimum 100 WP at a load voltage of 20 (+) 0.2V c). The open circuit voltage of the PV modules under STC Would be 20 Volts. d). The module efficiency would be 14.5% e). A bird spike shall be provided to avoid bird sitting on the solar module at the heighest point of the module structure, f). SPV module shall be highly reliable lightweight and shall be a service of life of more than 25 years. It shall have a limited power loss of not more than 10% of normal output at the end of 10 years and not more than 20% at the end of 25 years. g). The solar module shall be able to withstand the following environment at conditions normally encountered at the site - Temp. extremes ranging from 10'C to 85°C, wind load - 200 krm/h, Max meanheavy rainfall of 40 mm, Humidity level up to 95%, h). Strip must contain the followings- Manufacturer name, model nurmber, year of make.

Suplying and Fiting and Fixing Lithium Battery (36 Ah LiFeP04) 12.8 volt, Lithium phosphate cells are incombustible in the event of mishandling during charge or discharge, more stable under overcharge or short circuit conditions. Phosphate chemistry also offers a long cycle life. 48 hours back up

Suplying and Fiting and Fixing Dusk to Dawn Charge controller 30Ah a). Battery over charge cut off: 20 V b). Battery deep discharge cut off: 23.5 V c). Short circuit protection inbuilt with the system. d). Protections against battery reverse polarity inbuilt with the system. e). Load re-connects facility inbuilt with the system. a). LED Luminaries must be to prevent water seepage and entry of insects.

Suplying and Fiting and Fixing Luminary- 30 watt LED based b). The light source will be of white LED type. The luminous performance of LEDs used should not be less than 12 lumen/watt. Use of LEDs, which emit ultraviolet light must be avoided c). The light output should remain constant with variations in the battery voltages. d). The make model number and technical characteristics of LED lights should be

Construction of suitable shwallow FOUNDATION With suitable grade concrete for solar Mini mast considering soilbearing capacity 10T/sqmts. At 2 mtr depth with all material (sand, stone chips, cement iron bar etc. labour as per approval & direction of EIC.

Erecting of solar pole by using of lifting hydra equipment at modern engineering practices and fixing foundation bolts, Anchor plates etc. with testing.

Suplying and Fiting and Fixing Cable 2.5 mm cable for solar panel & battery load

Display board at workside and letter writing as per direction of ElC. also scheme photo different stages