(1) Strengthening works 33 KV Line Silwarston (Muzaffarnagar). (2) Strengthening works 33 KV Line Paper Miil (Muzaffarnagar). (3) Strengthening works 33 KV Line Audhyogic No.-02 (Muzaffarnagar).

1. Supply of following material G.I Angle (65×65×6)mm

G.I Channel (125×65)mm

G.I Channel (100×50)mm

Stay Sets (20x1800) mm

Stay wire G.I 7/8 SWG

G.I Wire No. 6 SWG

G.I Wire No. 8 SWG

M.S. Earthing Rod

V Type Cross Arm 33 KV

Cross Arm Holding clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Top Channel Holding Clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Stay Clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Guarding Clamp for S.T. Pole 11 M & 13M long

F Bracket for 33 KV

E Bracket for 33 KV

Danger Board with clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long

Braccing clamps clamp for PCC Pole 9 M + S.T. Pole 11 M long & 13M long (Upper & Lower)

Aluminum Binding wire

Barbed wire

Grouting of Stay

Red Oxide Paint

Aluminium paint

M.S. Bolts Nuts & Washers

Earth wire clamp with Nut & Bolts

Eye bolt

Concreting of support

Stone pad (300×300×75)mm

P.G. clamp for Dog to Dog conductor

Turn Buckle

Guarding Angle 75×75×8

GI wire 16SWG for binding

2. Safe carriage of with loading & unloading at both ends respectively. (under jurisdiction of PVVNL) a) ACSR Dog Conductor

b) 33 KV Pin Isulators (Polymer)

c) Disc Insulators B&S 7000 Kg. (Polymer)

d) Disc Fittings B&S for Dog 70 KN (Polymer)

e) Steel Tublar Pole SP-55 11M (Bottom Portion Galvanized)

A- Erection of support after excavation of foundation pit in mix soil/normal soil/soft & hard rock and its back filling and leveling etc. The size of the pit will be (900×600)mm and having depth of 1/6th of the full length of the support & Erection of support. The work includes carriage and handling of supports from site store to pit site. 11 M Long STP, SP-55 Round Pole

B- Fixing of all clamps, Cross Bracing Sets 3.5 Mtr. from M.S. Angle 65×65×6mm/50×50×6mm & other accessories on the supports as per drawing. Work includes cutting of holes and providing M.S. Bolts of 16×40mm size in the middle of cross bracing with 1 no. spring washer. The work also includes carriage & handling of accessories from sectional store to pit site as well as any fabrication work if required. 11 M Long STP, SP-55 Round Pole

(ii) Double Pole Structures11 M Long STP, SP-55 Round Pole

(iii) TRI Pole Structures (a) 11 M Long STP, SP-55 Round Pole

Grouting of supports in CC 1:4:8 (Cement, sand & 40 mm brick ballast) Grouting will be done in the block of size (450×450)mm ×1/6th of full length of the support, up to ground level, 300 mm plinth above the ground level with C.C. 1:3:6 (Cement, Course sand and Stone grit) with muffing as per drawing, work includes back filling and proper ramming. 11 M Long STP, SP-55 Round Pole

Grouting of stay rods (20×1800)mm including all work of excavation, cement concrete in size (0.60 × 0.60 × 0.30)m in ratio 1:4:8 cement, sand, 40mm brick ballast) as per drg. including back filling, proper ramming etc and fixing tightening & nozzling of stay wire with stay rod with the poles of required tension as per drawing.

Painting of following supports/structures with 2 coats of synthetic enamel paint after one coat of ready mix primer including cost of all material, as well as rubbing/cleaning of surface as required for proper completion of work. Painting will be done by post office red paint from top to cross arm and remaining by Aluminium paint. (a) All channels, X-Arms and Clamps of 11Mtr. STP Poles (i) Single supports

(ii) Double supports 11 M Long STP, SP-55 Round Pole

(iii) TRI Pole Structures 11 M Long STP, SP-55 Round Pole

Earthing of supports with MS earth Rod of (20×2500)mm long including excavation of pit and driving M.S. Rod 3.0 M apart from support and 0.5m below the ground level and connecting below the earth electrodes with the help of G.I. wire no. 8 SWG and earthing lugs.

Laying, spreading, lifting and final sagging of 3 phases of ACSR Dog conductor in accordance with profile and sag chart including binding, Jumpering and fixing of P.G. Clamp as per requirement in 03 Nos. conductor in parallel.

Guarding between two poles like single poles, double poles, four poles, etc. to guard LT, 11 KV Line telephone and river crossing, road crossing etc. with G.I. wire no. 6 SWG and G.I. wire no. 8 SWG, including cutting with fabrication and fixing of guarding channel with clamps nut & bolts etc. as per drawing.

fixing of danger board at each location as per specification of the drawing with clamps etc.

Wrapping of barbed wire on 33 KV PCC Poles/SP-55 ST & SP-72 ST Poles as anti-climbing device for a length of 0.9 Mtr., wire pitch/gap 13mm and fixing upper and lower end keeping lower end at a height of 2.75 Mtr. from the ground complete with supply and fixing of lower end & upper end clamps made of M.S. Flat 40×5mm complete with nuts & bolts & all other required material.

Dismentling of dmage STP pole , and associated accessories (steel scrap ) and cartage to nearest store

Dismentling of old and used ACSR conductor , and cartage to nearest store

M/S PAWAN CONTRACTOR