REPAIR/REPLACEMENT OF TRUSS, PURLIN, ROOF SHEETING, BRICK WORK, PLASTERING, PLINTH PROTECTION, FLOORING ETC IN OLD AREA INSIDE COD UNDER AGE B/R-I OF GE (I) KANPUR

Amount

Dismantling of asbestos cement (corrugated, semi corrugated, etc.) sheets in roof coverings including ridges complete all as specified and directed.

Dismantiling of CGI/PGI sheets any thickness as in roof coverings complete all as specified and directed.

S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws of required size and dia complete all as specified & directed.

S&F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws of required size and dia complete all as specified and directed.

Taking down wooden roof truss exc 10 m but n.exc 15 m compled rafters or trussed beams span complete all as specified and directed.

Dismantling of unframed work timber scantlings 40 sq. cm and over in section, in any position complete all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

M&L for roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc conforming to Fe 410 W (Gde-E-250) quality A complete all as specified and directed.

S&F in repair 2 mm thick fibre glass reinforced translucent corrugated sheeting with two corrugations side lap fixed with coach screw and washer in roof, wall etc complete all as specified and directed.

S&F wind ties for roof including securing bolts as directed, including all necessary drilling, bolting or riveting, etc. and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

Demolition of unreinforcement cement concrete of any description and in position not otherwise specifically provided for complete all as specified and directed

M&L for PCC type B0 1:2:4 (using 12.5mm graded stone aggregate) as in roof kerb, benching/ padding over roof surface including chamfered on eges etc complete all as specified and directed.

M&L for PCC 1:2:4 type B-0 (using 12.5mm graded stone aggregate) as in copings, filling for fixing of hold fast etc including necessary formwork etc complete all as specified and directed.

Demolition of brick work or stone/boulders masanory built in cement mortar including all quoins, arches, pillars etc, but excluding ashler facing, dressed stone work and precast concrete articals complete all as specified and as directed.

M&L brickwork with subclass ‘B’ bricks, straight or curved on plan exc 6m mean radius built in cement mortar 1 : 6 complete all as specified and directed.

All as per item No 15 above but except bricks complete all as specified and directed.

M &L for Brickwork with subclass ‘B’ bricks, straight or curved on plan to any radius in half brick thick walls built in CM 1:4 complete all as specified and directed.

Taking down cement plaster on bricks including raking out joints hacking for key scrubbing down with water etc.complete all as specified and directed.

M&L for 15mm thick rendering in cement mortar 1:4 on fair faces of brick work or concrete surfaces of walls, finished fair and even (upto two storey of building) complete all as specified and directed. Note:- Cost of sccaffolding upto two storey and safety measures shall be deemed to included in quoted rate by the contractor.

M&L for 10mm thick rendering in cement mortar 1:6 on brick or concrete surfaces of wall finished fair and even complete all as specified and directed.

M&L for preparation of new plastered surfaces of wall and applying two coat of cement based paint of approved shade complete all as specified and directed.

M&L for preparation of new plastered surfaces of wall and applying three coats of white wash complete all as specified and directed.

M&L for preparation of new steel surfaces over and including 10cm width or girth and applying two coats of synthetic enamel paint over and including a coat of red oxide complete all as specified.

M&L for preparation of new steel surfaces n.exc 10cm width or girth and applying two coats of synthetic enamel paint over and including a coat of red oxide primer complete all as specified and directed.

M&L for preparation of old steel surfaces width or girth exc 10 cm and applying one coat of synthetic enamel paint complete all as specified and directed.

Demolition of plain cement concrete in ground floor and pavings not exc 15cm thickness below or above ground level complete all as specified and directed

M&L 75 mm thick PCC 1:2:4 type B-1 (using 20mm graded stone aggregate) as in flooring finished even and smooth without using of extra cement laying in alternate bay complete all as specified and directed.

M&L 75 mm thick PCC (1:3:6) type C1 (using 20 mm graded stone aggregate) as in plinth protection finished even and smooth wihtout using extra cement complete all as specified and directed

Taking down 100/ 110 mm dia rain water pipes, any pattern with all fittings & bends etc complete all as specified and directed.

S&F 110mm dia , PVC (SWR) pipes, single socketed in any length with rubber ring joints, fixed to walls complete all as specified and directed.

S&F PVC (SWR) bends 110 mm bore complete all as specified and directed.

Taking down chowkhat or frame with shutter (without taking off shutter from the frame) area not exc 1.5 Sqm each complete all as specified and directed.

S&F rolled sections of angle and tee or other section as in framing for cladding, glazing , ventilator and the like fixed with angle cleats and connecting plates, etc complete all as specified and directed.

S&F steel wire fabric not exc. 4 kg/ sqm in wood or steel members etc fixing through welded etc complete all as specified and directed.

Demolition of reinforced (reinforcement cut as required to facilitate demoltion) cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L Providing precast cement concrete 1:2:4 type B1 (using 20 mm graded stone aggregate) and set in cement mortar (1:4) in window or door cills, lintels (of any section indicated), with plain fair faces, including chamfers, weatherings, throating etc. and setting in mortar with joints complete all as specified and directed.

S&F TMT MS bar 10 mm dia & over, cut to length, bent to shape required, including cranking, bending, spirally for hooping for columns, hooking ends and binding with and including MS wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed.

All as per item No. 37 above but 6 to 8mm dia in stirrups, spacers and binders complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed.

M&L Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging also fastening and fixing, conforming to Fe 410 W (Gde-E-250) quality A complete all as specified and directed.

S&F in repair 0.63 mm thick galvanised, corrugated mild steel sheeting with zinc coating 120 gram/sqm with two corrugations side lap fixed with coach screws and washers on frame of MS gate etc complete all as specified and directed.

Hacking out old broken glass (any thickness, size, quality or description) from metal frame including punching or drilling out old glazing pins/spring clips and providing and fixing new ones complete all as specified and directed.

S&F rough cast wired figured glass 5 to 6.4 mm thick and glazing with oil putty /beads square exc 0.4 but n.exc 0.75 sqm complete all as specified and directed.

S&F 3 mm thick sheet glass ordinary quality and glazing with putty in square n.exc 0.5 sqm min each pane complete all as specified and directed.

M/S EASTERN SUPPLIERS (BID ID -3333104)

ARORA BROTHERS (BID ID -3332076)

U.R ASSOCIATES (BID ID -3340547)

M/S BABA CONSTRUCTION (BID ID -3341971)

SHRI KRISHNA CONTRACTOR & SUPPLIERS (BID ID -3340788)