SPECIAL REPAIR/ REPLACEMENT OF BARBED WIRE WITH CHAIN LINK FENCING FOR BLDG NO T-13 AND T-17 AT RMS CHAIL UNDER GE JUTOGH

Amount

Dismantling structural steel work including doors gates but excluding framed trusses etc complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15 cm thickness (below or above ground level) removing of rubbish outside premices as directed by Eng-in-charge complete all as specified and directed.

M&L for PCC 1:3:6, type C-2, using 40mm graded crushed stone aggregate as in foundation filling and mass concrete, sub base or levelling course, complete all as specified and directed.

S&F mild steel work as in hand rails half round or other stock section or core for wooden hand rail straight portion drilled and counter sunk for balusters running bars for doors, balusters, nosing to steps including embeding in concrete and screwing etc., wind ties for roof including securing bolts, post and strut in fencing including cutting tops to shape as directed drilling holes, notching for wire etc. flat iron fillets securing wire mesh including all necessary drilling and bolting and similar work confirming to Fe-290 Gde E-165 complete all as specified and directed.

S&F galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2mm dia barbs at 75 mm spacing and straining and fixing to any type of standard rails straining bolt, including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh size and type to any type of standard rails, straining bolts etc, including provision of binding wire, complete all as specified and directed.

Supply only Chain link MS galvanisd fencing any size and type complete all as specified and directed.

M&L for mild steel round bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (Annealed) not less than 0.90 mm dia or securing with clips quality conforming to Fe-410-W (Gde.E-250) quality-A or Fe 290 (Gde -E-165), complete all as specified and directed.

S&F mild steel screw bolts (machine made) dia of neck exceeding 5 but not exc 10 mm with hexagonal or square head at one end and screwed the other end or screwed both end, each screw end to be fitted with washers and one hexagonal or square nuts, n.exc 10cm long complete all as specified and directed.

M&L for preparation of new or previously untreated steel surfaces of any description not otherwise described over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

R. P. Suppliers and Construction Co.

M/s Parmod Kumar

NSK TRADER