Providing and fixing of pollution control chimney for BSF Campus Jalandhar under FTR HQ BSF Punjab

Excavation for foundation in soft soil including dressing of sides and ramming of bottoms, lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 metres.

Providing & laying in position cement concrete of 1:5:10 (1 cement : 5 coarse sand (zone-III): 10 graded stone aggregate 40 mm nominal size) excluding the cost of centering and shuttering - All work up to plinth level.

Centering and shuttering including strutting, propping etc. and removal of form for : Foundations & footing, base of column etc for mass concrete.

Providing and laying in position 1:1.5:3 grade ( 1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size) of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level.

Steel reinforcement for R.C.C work i/c straightening, cutting, bending, placing in position and binding all complete upto plinth level. a) Thermo-Mechanically Treated bars of grade Fe-500D or more

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineerin-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.10.16.1 Hot finished welded type tubes

Providing and fixing organic waste Incinerator size( 1828 x 1524x1219 mm) made by 3-4 mm Heat resistant mild steel up to capacity 100 kg , dual chamber Machine frame- 3-4 mm Heat resistant mild steel, Refractory Hot face-155 mm,70% high alumina brick,Refractory fire brick layer-155 mm fire brick, insulation layer- 35 mm shree shera fiberglass blanket, Electrical heating (35 - 50 kw),cycle time 45-60 mins, top load, Kanthal A1 Heating Coils , 1 HP Blower for Air circulation with semi automaticControl panel, power supply 220 V Single phase/415 Volt Three phase with pollution control unit (Chimney) de established, scrubber type -Cyclon separator, ID Fan- 2HP ID fan for negative flow,Chinmey Stack- not less then 19.812 mtr ( 65 ft) with installation, testing and commissioning as required. as per approved by Engg in charge