REPAIR/MAINT OF BOUNDARY WALL, INTERNAL DRAINAGE, FENCING, CULVERTS, HARDSTANDING AND MISC B/R WORKS AT CH (CC) AND AT OFFICE COMPLEX OF GE E/M LUCKNOW IN THE AREA OF AGE E/M (HOSP) UNDER GE E/M LUCKNOW

Amount

Demolition of brick work or stone / boulder masonry built in cement mortar or cement lime mortar including all quions, arches, pillars etc but excluding ashlar facings, dressed stone work and pre cast concrete articles complete all as specified and directed.

Demolition of cement concrete (un-reinforced) in ground floors and paving/paver block n. exc 15 cm thickness (below or above ground level), complete all as specified and directed.

M&L for brick work with fly ash bricks as per IS 12894 -2002 straight or curved on plan exc 6 m mean radius built in cement mortar 1:6, complete all as specified and directed.

M&L TMT 10mm dia and over , cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming Fe- 500, complete all as specified and directed.

PCC 1:2:4 type B1 using 20 mm graded stone aggregate as in coping, chajja, facia , manhole cover and the like including weathering, slightly rounded or chamfered angles with & including necessary use and waste of form work for fair faces of concrete, complete all as specified and directed.

Supply only integral water proofing compound powder conforming to IS specification, complete all as specified and directed.

M&L for PCC 1:4:8 type D-2 as in foundation and mass concrete (using 40 mm graded stone aggregate), complete all as specified and directed.

M&L for providing cement concrete type B-1, 1:2:4 (20 mm graded stone aggregate) as in roof kerbs /padding or similar work or mud stops rounded or chamferred on edges, complete all as specified and directed.

M&L for providing cement concrete type B-0, 1:2:4 (12.5 mm graded stone aggregate) as in sub base in floor, padding or similar work, complete all as specified and directed.

Taking down cement plaster on brick wall, racking out joints hacking for key scrubbing down with water complete all as specified and directed.

M&L 15mm thick rendering on brick work or concrete surfaces in CM 1:6 finished fair & even without extra cement, cement mortar mixed with WPC @ 3% of weight of cement, complete all as specified and directed. (Note: WPC measured & paid for separately)

M&L for rendering 10 mm thick on brick work/ concrete surfaces in cement mortar 1:6 on fair faces finished even and smooth without using extra cement, complete all as specified and directed.

Dismantling fencing wire,any type, complete all as specified and directed.

Mild steel screw bolts (machine made) of 10 mm dia of sank withhexagonal or squre head at one end & screw the other or screwed both end (as directed)each screwed end to be fitted with washer and one hexagonal or square nut n exc 5 cm long, complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts etc including provision of binding wire, complete all as specified and directed.

Supply only chain link MS galvanised fencing of any shape and size complete all as specified and directed.

S & F in repair for Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and directed including dismantling of old wire, complete all as specified and directed (Note :- Each line wire to be measured)

M&L for Providing and laying 60mm thick factory made chamfered edge cement concrete paver block ISI Marked of M-35 grade conforming to IS-15658-2006 with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and directed including dismantling and removal of existing paver blocks including removal of existing paver blocks, complete all as specified and directed

M&L for Machine pressed precast concrete interlocking paver block ISI Marked with grey cement and no pigment any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade (ISI marked), complete all as specified and directed

M&L for exterior grade outdoor coloured floor tiles (heavy duty) of tactileseries of size 300x300x10mm of Make Johnson endura or equivalent make bedded over and including 20mm thick screed bed in CM 1:6 and jointed in cement mortar to match the colour of floor including dismantling of existing tiles, complete all as specified and directed.

M&L Chequered cement concrete coloured tiles 30 cmx30cmx20 mm thick with coloured cement and pigment , set, jointed and pointed in neat cement slurry over and including 20mm thick screed bed in CM 1:4 as in floors including dismantling of existing tiles, complete all as specified and directed.

M & L for 75mm thick plain cement concrete type D- 2, 1:4:8 (using 40mm graded stone aggregate) as in sub base finishing the surface even and rough, complete all as specified and directed.

M & L for Hardcore of gauge n exc. 63mm, of broken bricks, deposited, spread and levelled in layers n exc. 15cm thick, watered and rammed to a true surface, complete all as specified and directed.

M & L for Sand filling under floors or in foundations including watering and consolidation, complete all as specified and directed.

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out in hard/dense soil, complete all as specified and directed.

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, ® and getting out in soft/loose soil, complete all as specified and directed.

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out in soft/loose, complete all as specified and directed.

Removing of soil excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point, complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm, complete all as specified and directed.

M & L in replacement Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, steel gates, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting, welding or riveting, etc., and similar work conforming to Fe-290 Gde E-165, complete all as specified and directed.

Preparation of newly plastered surfaces of walls and applying two coats of cement base paint of any tint/shade over a coat of primer complete all as specified and directed.

Preparation of new steel and iron based surfaces of any description, not otherwise described over 10 cm width or girth, including knotting and stopping and applying two coat of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

S&F GI Barbed razor type concertina coil of 600 mm dia (when unstretch) (having 15nos round per 6 metre length) running metre per coil) fixed between Y/U angle post and over barbed wire as per requirement with coil of coverage 6 running metre per coil, weight of each coil 9.50 Kg to 10 Kg hot deep galvanised and binding with and including MS annealed wire 0.90 mm including dismantling of existing wires, complete all as specified and directed.

Complete removal of existing treatment on wall/ roof projections including facia, cornices etc by scrapping with mechanical sander (having mechanical vaccum mechanism) with sanding pad of appropriate grit to make surface clean,free from dust, loose paint etc by skilled labour complete all as specified and directed. (Note:- Rate included for necessary scaffolding and arrangments for working upto 15m height)

M & L for Providing and applying minimum 1mm thick wall care putty over prepared surface to achive the surface even and smooth for painting, complete all as specified and directed. (Note:- Rate included for necessary scaffolding and arrangments for working upto 15m height)

Material & Labour for applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm, complete all as specified and directed. (Note- Primer and emmulsion to be carried out through air less spray machine Mechanical means)

Temporarily blocking of inlet of septic tanks/manhole with suitable wooden plugs/gunny bags and pumping/bailing out effluent and taking out/removing the accumulated sludge soil sewage/any other foreign/foul materials etc (solid/semisolid) from the septic tanks/manholes. complete and cleaning the septic tank/manholes with water by mechanically/manually including taking out the blocking arrangements of inlet and making the system functional complete all as specified and directed. (Note : (i) Depth of manhole/SOAK WELL/SEPTIC TANK exc 0.5 to 1.5M from below GL. (ii) Size of tank upto water level shall be measured)

Temporarily blocking of inlet of septic tanks/manhole with suitable wooden plugs/gunny bags and pumping/bailing out effluent and taking out/removing the accumulated sludge soil sewage/any other foreign/foul materials etc (solid/semisolid) from the septic tanks/manholes. complete and cleaning the septic tank/manholes with water by mechanically/manually including taking out the blocking arrangements of inlet and making the system functional complete all as specified and directed. (Note : (i) Depth of manhole/SOAK WELL/SEPTIC TANK exc 1.50M to 4.50M from below GL. (ii) Size of tank upto water level shall be measured)

disha construction

M K Engineers and Contractors

NEW BHARAT ENGINEERING AND CONSTRUCTION CO

M/S SWATI CONSTRUCTION

Divya Jyoti Constructions

m/s raghubar dayal

M/s Solution

M/S AMARJIT SINGH

M/S GR construction compony

Khushi Muskan Engineer & Developer