TN04-16/25-26-AGAMT-II-Guruba

Amount

Construction of New Panchayat Office Building at Gurubarahalli H/O Gurubarahalli

1. EARTHWORK EXCAVATION for foundation in hard soil and refilling the sides of foundation with excavated earth in layers of not more than 15cm thick, well rammed and consolidated and depositing the surplus earth within the compound in places shown by the departmental officers with initial lead and lift etc.,including levelling the sites complete complying with standard specifications and as directed. (Hard Soil )

2. Filling in foundation and basement with River sand in layer of not more than 15cm thick including all charges etc.complete

3. Refilling in foundation and basement with excavated eartth in layer of not more than 15cm thick including all charges etc.complete

4. Cement concrete 1:4:8 mix using 40mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing,laying and curing etc complete

5. Brick Work in CM 1:5 mix using country bricks ground moulded of size 83/4"x41/4"x21/4" for the following including curing etc., complete

a) Above basement

6. centering above G.L : Supplying and erecting centering shuttering including necessary supports for the plane surgace in foundation and basement and in all floors for RCC column footing column plinth beam, beams, roof slab, slaircase steps, bed blocks,critical pier etc., a) Below Ground Level

b) Above Ground Level

7. Supplying and fabrication of steel including cost and conveyance of steel to site and all labour charges for straightening, cutting to length, bending to shape and tying in position and forming grills for all R.C.C works

8. Reinforced cement concrete 1:1.5:3 mix using 20mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying, and curing etc complete for 10 cum

a) above basement column

9. Plastering with cement mortar 1:3 mix to 10 mm thick including cost and conveyance of all materials to site and all labour charges etc complete for 10 Sqm

10. Plastering with cement mortar 1:3 mix to 10 mm thick including cost and conveyance of all materials to site and all labour charges etc complete for 10 Sqm

11. weathering course with Brick jelly lime concrete using 20mm brick jelly with slacked lime in the ratio of 32:12.5 including cost and conveyance of all materials to site and all labour charges for mixing , laying ,and finishing etc.

12. Finishing the top of roof with one course of PRESSED TILES of size 23 cm X 23 cm X 2 12 cm laid in cement mortar 1:3 (One cement and three Sand) 12mm thick mixed with water proofing compound conforming to 1.S. at 2% by weight.

13. Paving the floor with best quality Vetrified (Such as Morbonite) Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification.

14. Paving the flooring with special type of flooring tiles (Cement based Hydraulically 14 pressed Anti skid tiles (20mm thick) in CM 1:3, 20mm thick

15. Dadooing of walls with colour glazed tiles of size 150x150x6 mm of best 15 quality including cost and conveyance of all materials to site and all labour charges etc complete.

16. Providing granolithic floor finish in cement concrete 1:2:4 mix using 10-12mm ISS metal to 25mm thick including cost and conveyance of all materials to site and all labour charges for mixing, laying, curing etc complete

17. Supplying and painting the walls with two coats of oil bound distemper over one coat of water based cement primer including cost for distemper, primer, cleaning and scrapping the walls, rendering the walls smooth with necessary putty, brushes, scaffolding arrangements, labour charges, etc., as per standard specification. (The colour and shade of the distemper shall be got approved by the Executive Engineer before use of work).

18. Painting two coats of newly plastered wall surface with ready mixed plastic emulsion paint of first class quality and approved colour over a priming coat including through scrapping, clean removal of dirt and including necessary plaster of pairs putty, wherever required etc complete complying with standard specification

19. Painting two coats over new iron works using ready mixed enamel paint including cost and conveyance of paint and all labour charges etc complete

20. Fabrication and supply of Mild Steel Door of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate et a) Door D (1.10x2.10m)

b) Door D1 (0.75x2.10m)

c) Door D2 (1.00x1.80m)

d) ROLLING SHUTTER

e) GRILL GAT

21. Fabrication and supply of Mild Steel Window of any size with single leaf outer frame mullion section made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered wi a) Window W (1.20x1.30m)

b) Window W1 (1.50x1.30m) 1

22. Labour charges for fixing door along with frames in position etc., complete

23. Supplying & fixing with cuddapah slabs 20-30mm thick for cup board thick and pointed with cement mortar 1:3

24. Supplying and Fixing in position of best quality make White glazed wash basin of size 550x 400mm

25. Supplying and fixing in position of Indian Type water closet 580x440mm of approved qualtiy

26. Supplying and fixing in position of Indian Type water closet 580x440mm of approved qualtiy

27. European water closet with all fittings and 10 lit capacity flushing tank

28. Supplying and fixing of RCC jolly of size 0.45x 0.45m including all charges etc complete

29. Supplying and fixing P.V.C rainwater down fall pipe of 110mm dia

30. Supplying and fixing of Bevelled Edge Mirror of size 600x450mm with ply wood back and aluminum beading complete complying with standard specification

31. Provision for electification (Sub Estimate)

a) Wiring with 2 X 1.5 Sq.mm (22 / 0.3) PVC insulated SC unsheathed Copper conducutor cable of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories inflush with wall with 3 mm thick Hylum sheet cover with TW box And 5 A FT switch with continuous earth connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for PVC Open Light point / fan point (For electronic Regulator) SD 18

b) Wiring with 2 X 1.5 Sq.mm (22 / 0.3) PVC insulated SC unsheathed Copper conducutor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories inflush with wall with 150 mm X 100 mm X 113 mm TW switch box with 3 mm thick Hylum sheet cover for 5 A 3 pin non interlocking CS plug with continuous earth wire connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for concealed PVC plug point SD 36

c) Supply and run of 2 of 1.50 sq.mm (22/0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade on 7/20GI bearer wire for service connection mains SD 64

d) Supply and run of 2 X 1.5 sq.mm (22 / 0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade in 25 mm dia GI pipe ( Class ' B ' ) suitably bent at both ends with necessary angle iron upright and end supports for mains. SD 69

e) Supply and fixing of WT bulk head fitting with guard ( Philips / Bajaj / Crompton / K Lite ) suitable for incandescent lamp with 60 W bulb.SD 84

f) Supply and fixing of CFL bulb SD 80

g) Supply and fixing of single box type 4'40 W flu fitting complete with copper choke and condensor with conduit pipe suspension from the ceiling with PVC unsheathed copper leads from terminals tot he fitting with tube SD88

h) Supply and fixing of 1200 mm ( 48") AC ceiling fan complete with stepped electronic 300 W regulator with 300 mm down rod on the existing clamp. SD 110

i) Supply and fixing of 32 Amps DPIC Switch of 500 V with fuse and neutral (Side Handle) on suitable TW box PWD Earthing SD 142

j) Supply&Fixing of Street light SD No.94

k) Supply and fixing of TNEB Meter board SD 125

l) TNEB Deposit Charges

32. Provision for water supply arrangement

a) Supply and delivery of 1000lit. Capacity HDPE tank As per IS 12701/1996

b) Supply and delivery of 32mm PVC pipe etc. complete.

c) Provision for PVC & GI Specials

33. Provision for Disabled person toilet hand rails etc., complete.

34. Provision for Rain water harvesting structure etc., complete.

35. Provision for Manhole cover for septic tank, etc., complete.

36. Provision for Name board etc., complete.

38. Provision for QC Charges 0.5% Charges etc., complete.

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

R PANNEERSELVAM (BID ID -1308961)