PROVN OF COVERED PARKING SHED OPPOSITE OF BLDG NO P-7 AT AF STATION JAIPUR

Amount

Excavating in post holes (or similar holes) each not exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance not exc 50m and making good surface, work in soft/disintegrated soil, complete all as specified.

M&L for PCC 1:3:6 type C-2, using 40 mm graded stone aggregate as in pillars, boundary pillars and fencing post or similar work complete all as specified and directed.

S&F steel work in tubular trusses including special shaped washers wind tie, bolts, plates etc complete including purlins and post using ERW or induction butt welded tubes conforming to IS 1161-1998 grade St -240complete all as specified and directed.

S&F for rolled section as main and cross beam, hip and jak rafters, purlins where connected to common rafters and running, rails, vertical members and guides for sliding doors, fixed with angle cleats or other connecting plates etc confirming to Fe-290, Gde E-165 complete all as specified and directed.

S&F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to walls, fixed with self tapping screws complete all as specified and directed.

M&L for preparation of steel surfaces and applying two coats of synthetic enamel paint exceeding 10 cm width or girth over a coat of red oxide primer complete all as specified and directed.

Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed by Engineer-in-charge.

M/S HARI CONSTRUCTION (BID ID -3092657)

shree shyam enterpises (BID ID -3095558)

Choudhary Traders and Engineers (BID ID -3092251)

M/S JALANDRA CONSTRUCTIONS (BID ID -3095123)

LAKSHMI ASSOCIATES (BID ID -3089533)