Providing voltage Stabilizer Submersible Motor Gantry for motor and other urgent repairing works at Filtration Plant Kunzwera

Providing/installation and fixing of 40 KV manualy operated electric 3 phase voltage stablizer with copper wiring including necessary connections and all carriages complete job

Providing and fixing of MS pipe/fittings (5mm thick) as per the requirement at site including cost of welding etc. complete.

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. Welded.

Repairs to CGI roofing including truss and soffit boarding by way of dismantling damaged sheets, angles, flats, etc. and refitting back all using welding, all leads and lifts, etc. complete job.

Supplying / installation and testing / commissioning of open well submersible pumping unit 7.5 HP, 8000 GPH, 10 Mtrs head complete with NRV, 30 mtr stand along with 10 sqmm 3 phase submersible cable 50 mtrs as per specification all complete.

Excavating / Removal of top layer (45 cm) of clogged filter media from filter beds, cleaning and screening / sieving the filter media and laying the same back into filter beds complete job.

P/L in position specified grade of cement concrete 1:2:4 mix including the cost of centering, shuttering, earthwork in excavation, stone soling, all related carriages, etc. complete job.

Providing and fixing aluminum work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixed with dash fastener of required dia. and size including necessary filling up of gaps at junctions i.e, at top, bottom and sides with required EPDM rubber / neoprene gasket felt etc. Aluminum sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminum snap beading for glazing / panelling, C.P. brass / stainless steel screws, all complete Powder coated aluminum (minimum thickness of powder coated 50 microns)

Providing and fixing aluminum work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixed with dash fastener of required dia. and size including necessary filling up of gaps at junctions i.e, at top, bottom and sides with required EPDM rubber / neoprene gasket felt etc. Aluminum sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminum snap beading for glazing / panelling, C.P. brass / stainless steel screws, all complete Powder coated aluminum (minimum thickness of powder coated 50 microns)

Providing and fixing 12mm thick prelaminated particle board flat pressed three layer or graded wood particle board (conforming to IS:12823 Grade-I type-II) in panelling fixed in aluminum doors, windows shutters and partition frames with C.P. brass / stainless steel screws etc. complete: Pre-laminated particle board with decorative lamination on both sides.