Improvement of various old kuhls existing between Sanula and Nouti khad Tehsil Suni Distt Shimla HP

Amount

Laying and Jointing PVC Pipe. Heading

Excavation in foundation trenches etc.in earth work upto all depths in all kinds of soil such as pick work,jumper work,blasting and chiselling soft/hard rocks where blasting is prohibited in all leads and lifts including trimming and dressing of side levelling of bed to correct grade and returning the stacked soil in trenches in 15cm.layers by ramming and watrering and then disposing of all surplus excavated soil as directed in all leads and lifts and soring strutting/timbering and dewatering where ever required including restoration of un metalled/metalled paved surfaces to its original conditions including caution boards in all respect and to the entire satisfaction of the Engineer-in-Charge.

Excavation in drain channel etc. in earth work including dressing of sides and disposed of excavated earth upto lead of 20 mtrs & lift up to 1.5 mtrs disposed to be levelled and neatly dressed pick/ Jumper Work.

Dressing of bed and preparation of sub grade for lining in pick work.

Dressing of sides slope and preparation of sub grade for lining in pick work.

Providing and laying cement concrete 1:5:10 (1 cement : 5 sand : 10 graded stone aggregate 40 mm nominal size) with 15 % plum and curing complete excluding cost of form in retaining Walls / breast walls, the size of plums shall usually be 150 mm to 300 mm as per H.P.P.W.D. Specification

Providing and laying cement concrete 1:3:6 (1 cement : 3 sand : 6 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work in:-

Providing and laying cement concrete 1:2:4 (1cement :2 sand:4 graded crushed stone aggregate and 20mm nominal size) and curing complete excluding the cost of form work in foundation and plinth in all leads and lifts.

Plinth & Foundation

Suspended floors roofs, landings and shelves and their supports, balconies, beams, girders, bressumers and cantilever up to floor two levels.

Prov. Form work with steel plates3.15 mm thick welded with angle iron in frame 30x30x5 mm so as to give a fair finish i/c centering shuttering sturting and propping etc.with woodan batton and ballies ht. of propping and centering below supporting floor to ceiling not exeeding 4 mtrs. and removal of same for instu-reinforced concrete work in

Vertical surfaces such as walls ( any thickness ) partitions and the like including attached pilasters , buttresses, plinth and string courses and the like .

Flat surfaces such as soffits and suspended floors, roofs , landing and the like:-

Steel Work in single section including cutting , hoisting , fixing in position and applying a priming coat of lead paint .

Providing and laying cement concrete 1:3:6 (1 cement : 3 sand : 6 graded stone aggregate 40mm nominal size) and curing complete excluding cost of form work in:-

Foundation and Plinth.

Providing and laying cement concrete 1:1.5:3 ( 1 cement : 1.5 sand : 3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work & reinforcement for reinforced concrete work in:-

i) Foundation and Plinth.

ii) Walls (any thickness but not less than 0.1 m thickness) attached pilasters, buttresses, plinth and string courses etc. from top of foundation level up to floor two level.

Providing mild steel/tor Steel reinforcement for R.C.C work including bending , binding and placing in position complete up to floor two level.

Providing and fixing of Weep Hole 100 mm Dia PVC Pipe

White washing with lime on undecorated wall surfaces two coat to give an even shade i/c thoroughly brooming the surface to remove the dirt, dust, mortar and other foreign matter .

Providing in R.C.C work smooth finishing of the exposed surfaces with cement mortar 1 : 3

Wire crates of G.I. wire filled with boulder with square cut faces againts the wire ( wire crates to be measured and paid for separately)

G.I. Wire filled 5 mm Thick Corresponding to SWG 8.15 cm X 15 mm Mess

Manfacturing MS Manhole Cover 600x450mm with Frame of MS Angle 50x50x6mm and cover of black sheet 2.00mm thick complete with angle frames, flates etc including welding with locking arrangemets(Locks) (excluding Cement Concrete)

Laying & Jointing in trenches, GMS Tubes (Light Grade), Tube fittings (earth work in trenches to be measured and paid for separately).

32 mm Dia

50 mm Dia

Providing & fixing of brass full way wheel valve.

32 mm Dia

50 mm Dia

akash

Gurvaksh Singh

Suneel Dutt

Jia Lal Kapatia

Vijay Sharma

Anurag Deep