PROVN OF PARKING SHED AND HARDSTANDING IN KV NO. 2 AT AF STN ADAMPUR

Amount

Surface excavation n.exc (not exceeding) 30cm deep and averaging 15cm deep and getting out in soft loose soil complete, all as specified.

Excavation in trenches in soft/loose soil not exceeding 1.50 metre wide and not exceeding 1.50 metre in depth; for foundation, etc. and getting out complete, all as specified.

Removing excavated spoil to a distance not exceeding 50 metre and depositing where directed at a level not exceeding 1.5 metre above the starting point complete, all as specified.

PCC type B-2 (1:2:4), using 40 mm graded stone aggregates as in filling & mass concrete, complete all as specified.

Cement concrete, type B-0 (1:2:4), using 12.5 mm graded stone aggregates as in lintels up to 1.5 metre clear span, bed blocks, copings and the like including weathering, slightly rounded or chamfered angles & throating including provision of necessary formwork, complete all as specified.

Factory made pre-cast PCC 1:2:4 type B-1 using 20 mm graded crushed stone aggregate kerb stone of size & shape as directed including weathering, slightly rounded or chamfered angles & throating and laid & jointed in position with cement mortar (1:6), complete all as specified.

75 mm thick, cement concrete type D-2, 1:4:8 using 40 mm graded stone aggregate, finished even & rough, as in sub floors, complete all as specified.

Clean dry sand filling, 25 mm thick consolidated thickness in floors below interlocking tiles and the like, complete all as specified.

Factory made, machine pressed precast concrete interlocking paver block any shape and size approved by EIC, ISI marked (IS:15658-2006) of 80 mm thick, M-40 grade, with grey cement & pigment, laid dry in paths/roads over sand, complete all as specified.

Mild steel works in hand rails, half round or other stock section or core for wooden handrail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) in-cluding all necessary drilling, bolting or riveting, etc., confirming to Fe-290-Gde E-165, complete all as specified.

Rolled mild steel sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates quality confirming to grade Fe-290-Gde E-165, complete all as specified.

Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm of any colour hving tensile strength of 550 Mpa as in roof coverng/cladding to wall, fixed with self tapping screws comlete all as specified.

Two coats of synthetic enamel paint over & including a coat of red oxide primer over new steel & iron surfaces of any description, not otherwise described, over 10 cm in width or girth, including preparation of surfaces complete all as specified.

AAR KAY BEE ENTERPRISES