WBPWD/SSEWEC /BRED /NIQ-79 /2025-26

SUB-HEAD 1-SITC OF FIRE ALARM PANEL. Supply , Installation , Testing and Commissioning of minimum 6 loop Microprocessor based Multi-loop,  addressable fire alarm panel , Fully  7-inch Touch Screen 800 x 480 pixel display, with peer to peer networking of 250 FAP in single node, each panel should act as master panel, single loop with minimum 240 addressable points (Any combination) per loop, panel with built in battery charger that can support backup upto 24hours idle condition and 30 minutes during alarm condition, Programing via PC or panel keypad and touch screen, panel with integral thermal printer, option to interface to BMS with optional interface of LON Works, BACnet & MODBus, 96 Zonal LEDs on board, capacity to have upto 250 logic zones, 4 NAC circuits, 3 programmable relays, dedicated Alarm relay, Integral short circuit, History records of 100,000 events,  should have PAS (Positive Alarm Sequence) , should have Optional Redundancy CPU, total load Max.2.5A/24VDC. Should have Remote diagnosis via Ethernet, Email notification, Real time detector compensation level report. As per NBC guidelines- Networkable Fire alarm control panel shall be able to accommodate below given detectors & devices and shall have 20% spare capacity to accommodate future expansions of addressable points. Comply EN-54- LPCB approved. (Approved Make : GST/ Johnson Controls/ Edward other equivalent make as approved by E.I.C) )

Supply, Installation, Testing & Commissioning of Microprocessor based intelligent, addressable and network connected Repeater panel of EN-54 standard LPCB approved, should have all the controls and monitoring as on the main fire alarm panel, functioning as a controller, shall allow remote command in the system reset, trouble and alarm silence and manual alarm. It shall be programmable to display information for the entire system i.e. all panels in the network, having minimum 80 characters LCD display (display system status) With CAN networking. The system text displays shall include: Alarm missing point trouble; system test, service, local system test, extra custom test by polling circuit and address. The repeater panel should annunciate alarm and trouble conditions in the occasion of signal actuation. (Approved Make : GST/ Johnson Controls/ Edward)

Supply, Installation, Testing & Commissioning of Microprocessor controlled. IP Addressable Multi-sensor detector of EN-54 standard LPCB approved with inbuilt optical smoke Sensors and heat detector sensor with inbuilt short circuit fault Isolator as per NFPA style 7 wiring complete with base (Note Detectors without built-in fault isolator is also acceptable Provided one independent short circuit fault isolator per detector is to be provided extra without extra cost) the detectors should have built in LED indicator. Thedetector should have 360 degree optical view with single/ multiple LED that blinks on actuation of detector and the protection catagory of IP40. Reverse polarity or faulty zone wiring shall not damage the detectors. (Approved Make : GST/ Johnson Controls/ Edward)

Supply, Installation, Testing & Commissioning of Microprocessor controlled IP Addressable Heat detector of EN-54 standard LPCB approved with combination of fixed type & Rate of Rise of Temperature feature. Detector shall have minimum triggering temperature programmable from 60 deg. to 80 deg. having high level of imunity to electrromagnetic influences and show alarm signal limit temperature is reached. Detector shall have inbuilt short circuit fault isolator as per NFPA style 7 wiring complete with base (Note : Detectors without built-in fault isolator is also acceptable provided one independent short circuit fault isolator per detector is to be provided extra without extra cost) the detectors should have built in LED indicator with 360 degree viewing angle and the protection catagory of IP40. (Approved Make : GST/ Johnson Controls/ Edward)

Supply, Installation,Testing & Commisioning of IP Addressable Manual Call Point of EN-54 standard LPCB approved with necessary accessories for fitting, JB etc. (Approved Make: GST/ Johnson Controls/ Edward)

Supply, Installation, Testing & Commissioning of Loop Isolator Modules of EN-54 standard LPCB approved. Loop Isolator can isolate the shorted circuit from the whole system to ensure normal operation of other devices and locate the devices in fault. After the short circuit fault is cleared, those devices will be re-introduced into the system with degree of protection IP 30. (Approved Make : GST/ Johnson controls/Edward)

Supply, Installation, Testing & Commissioning of IP Addressable Loop Powered Hooter (sound output of minimum 80 db ) cum strobe (strength of iight 10 cd) of EN-54 standard LPCB approved with necessary accessories for fitting, JB etc. (Approved Make: GST/ Johnson Controls/ Edward)

Supplying, Installing, Testing & Commissioning of LED technology, High efficiency, Double Sided Exit Signage cum Emergency light with Function Use either as an emergency luminaire or exit sign, Testing system Stand Alone, Housing Polycarbonate, Glow wire test : 850°C, RAL9003, Type of mounting Surface: Recessed base for ceiling, double sided cone diffuser, plexi plate diffuser, set of 3 exit legends (L, R, D), Degree of protection IP65, Operation Mode Non Maintained or Maintained & Non Maintained mode selectable, Connection voltage 230V -/+ 5% [220V-240V] 50-60Hz, Permissible ambient: temperature +5°C to +40°C, Battery: Ni-Cd, Duration 3 hours, Viewing distance 30m, Insulation class II, Dimensions for 30 m viewing distance version: 371 x 170 x 62.(Approved Make: GST/ Johnson Controls/ Edward or other equivalent make as approved by E.I.C)

Supply & Laying of 1.1KV grade 2 Core 1.5 sq.mm FRLSH shielded copper Conductor stranded cables in red/black color (Make: Finolex/ Technoflex/ MEM/ KEI) for Looping.in PVC rigid FR conduit (Precision make of Red colour or as approved by EIC) on wall with saddles including Supply & Fixing of 20 mm PVC rigid FR conduit complete with all accessories. NOTE :- 1) The Fire Alarm system shall comply with latest requirements of -- (i) National Fire Protection Association (NFPA) standards, (ii) IS 2189 (iii) NFPA 7O National Electric Code, (iv) NFPA 72 National Fire Alarm & Signaling Code (v) Local Statutory Regulations , (vi) Manufacturer Recommendation vii) System should be integrated with the components like FACP, Detectors, MCP, Hooter, Monitor Module, Relay Module, etc. and all these components should be of same brand. viii) The agency must arranged a mock drill for the fire detection alarm system at Sainthia State General Hospital. (ix)The agency must be Maintenant atlist Two years of DLP

SUB-HEAD 2--SUPPLY & LAYING of fire Pump cable. Supply & delivary of 1.1KV grade 4 core 240 sq.mm. PVC/A AL. cable to be laid through masonary / U.G trench as per G.S. (from LT panel room to Fire pump room ) - [Make- Gloster/ Havells / Polycab/ KEI / As per choice of EIC]