Interconnection of 33KV Main Bus Bar IIIrd with 33KV Main Bus Bar Ist and IInd at 132KV Substation Budaun by 2 No. 33KV 3x400mm2 size XLPE Power Cables along with other associated Works under E.T.D. Budaun

Amount

Following Works are to be Carried out for Interconnection of 33KV Main Bus Bar IIIrd with 33KV Main Bus Bar Ist & IInd at 132KV Substation Budaun by 2 No. 33KV 3x400mm2 size XLPE Power Cables along with other associated Works under E.T.D. Budaun with all Cost of Men, Materials, Misc. Consumables, T&Ps etc. Required for Satisfactory Completion of the Work as per Technical Specifications and Direction of the Supervising Engineer, as per Details below :

Erection of Lattice type Auxiliary Structures (2 No. ABL) including their Shifting from Storage Place at the Sub Station to Erection Site.

Erection of 33KV Bus Section Isolators with Post Insulators including their Shifting from Storage Place at the Sub Station to Erection Site.

Fabrication of Support Structures with the help of Scrap M.S. Angles (to be Provided by the Department Free of Cost), suitable for Vertical Support of 2 No 33KV 3x400 mm2 XLPE Power Cables to be Connected with 33KV Bus Section Isolator at both ends. (1 Job per Structure)

Grouting of above M.S. Support Structures with due Concreting etc. near 33KV Bus Section Isolator at both ends. (1 Job per Structure)

Painting of above Grouted M.S. Support Structures with 1 Coat of Red Oxide Primer & 2 Coats of 1st Quality Synthetic Enamel Paint of Asian / Berger / Nerolac make in Smoke Grey Colour after due Rubbing with Sand Paper & Wire Brush. (The 2nd Coat of Paint shall be Applied at the Gap of 48 hrs. when 1st Coat of Paint is done). (1 Job per Structure)

Providing & Laying of 1 No. 33KV 3x400mm2 size XLPE Power Cables by digging and making a send bad or fine riddled soil bad, also provide sand bad on top of the cable followed by back filled the excavated soil leaving 300mm from the ground level in 33KV Power Evacuation Trench between Bus Section Isolator-1 at 33KV Bus Bar-II to Bus Section Isolator-2 at 33KV Bus Bar I at 132KV Sub Station Budaun.

Providing of Outdoor End Termination Jointing Kits and Making the End Termination Joints of the above Laid 1 No. 33KV 3x400mm2 size XLPE Power Cables to Connect the Cables with Bus Section Isolators at both ends.

Cutting, Straightening & Laying 500 mm below inside Ground and above the Ground of M.S. Flats for Earthing of the Bus Section Isolators, Cable Support Structures and Cable Trench to Connect the same with Main Earth Mat including Excavation of Trenches & its Back Filling etc. as per details below :

(a) Earthing of ABL Structures & Cable Support Structures with 50x6mm size MS Flat.

Painting of 50x6mm size M.S. Earthing Strip with 1 Coat of Red Oxide Primer & 2 Coats of 1st Quality Synthetic Enamel Paint of Asian / Berger / Nerolac make in Bus Green Colour after due Rubbing with Sand Paper & Wire Brush. (The 2nd Coat of Paint shall be Applied at the Gap of 48 hrs. when 1st Coat of Paint is done) :

(a) Painting of 50 × 6 mm size M.S. Earthing Strip in Bus Green Colour.

M/s S.S. Refregeration

Bharat Trading Corporation