Restoration of Rain damage of WSS Shamoh Jager Gaura Gwal Phase-III in Nirmand Block Distt Kullu H.P.

Cutting in earth work and disposal of excavated earth in all kind of soil such as pick work, jumper work, blasting work in soft/ hard rock or chiseling wedging, out soft/ hard rock where blasting is prohibited i/c all leads and lifts complete as per direction of Engineer-in-charge.

Excavation in foundation and trenches (For pipes and pits) up to all depths and in all classification of each work such as pick work, jumper work, saturated soil including bailing or pumping out of water, blasting soft or hard rock or chiselling or wedging out of soft/ hard rock, where blasting is prohibited, in all lifts including trimming and dressing of sides, levelling of beds to correct grade including shoring, strutting, planking, timbering and dewatering where ever required. Stacking usable and unusable material/ soil separately and after laying, jointing and testing of pipes, returning the usable soil in 15cm layers by ramming and watering and then disposing of all surplus excavated soil/ unusable material as directed within all leads/ lifts including restoration of unmetalled surfaces to its original condition and including cost of diversion for traffic, night signal boards, fixing caution boards, crossing over trenches for access to houses, fencing etc. complete in all respect with in all leads and lifts as per direction of Engineer-in-Charge. Pick & Jumper work

Providing and laying cement concrete 1:6:12 (1cement: 6 sand: 12 graded stone agg.40mm nominal size) and curing complete excluding cost of centering and shuttering including all leads and lifts. a) Foundation and plinth.

Providing and laying cement concrete 1:5:10(1cement:5sand:10 graded stone aggregate of 40mm nominal size) with 15% plum and curing complete excluding cost of form work in retaining walls/breast walls, the size of plums shall usually be 150mm to 300mm as per H.P.P.W.D specification including all leads and lifts.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a rough finish including centering shuttering strutting and propping etc. height of propping and centering below supporting floor to ceiling not exceeding 4mtrs.and removal of the same for in situ reinforced concrete and plain concrete work including all leads and lifts:

Vertical surfaces such as walls (any thickness)portions and the like including attached pilaster buttresses plinth and string course and the like

Manufacturing and Supplying and Fixing of fencing panel of size 120mx1.80m of Jali 25X25mm welded to M.S.black tube of 32 mm dia of 14 guage mm thick with M.S Flats 20X3mm, welded all around the pipe pannel two on both sides and providing hold fasts 6 Nos of MS. Flate of 32x3 mm thickness having consting of tee of size 15X15 cms tee acting as hold fasts including cutting, weldign painting with red oxide paint to the entire satisfaction of the Engineer In charge

Steel work welded in built up sections trusses and framed work including cutting ,hoisting fixing in position and applying a priming coat of red lead paint complete with in all leads and lifts as per direction of Engineer-in-Charge.

Providing and Fixing of MS gate of the size 0.75 m x1.20m complete in all respect as per the directions of Engineer in charge.(Not Less than 40 Kg)

Painting two coats(excluding priming coatt) on new steel based surface with enamel paint to give an even shade including cleaning the surface of dirt,dust and other foreign matter,sand papering & stoping with animal paint other then white and as per direction & satisfaction of the Engineer- in- charge upto all lead & lifts.