Maintenance work in (Surface Dressing, Jungle Cleaning, Drain Cleaning, Painting and other Miscellaneous work) for three years of Sector-12, Greater Noida

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineerin- charge. : All kinds of soil (DSR-2023/2.6.1)

Cartage of ballast, Kankar Coal, grit or sand including loading & unloading but excluding stackings on pakka roads: 1st Km. (SOR-25/Ch-4/4.02/232(a))

Extra rates for quantities of works, executed: In or under water and/or liquid mud, including pumping out water as required. (DSR-2023/2.24.1)

Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared. (DSR-2023/2.32)

Surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.: All kinds of soil (DSR-2025/2.28.1)

Tractor with trolley including driver & POL (SOR-25/S.No-1/Chapter-7)

Supply of labour. ( Based on SOR-25/SN-20/Chapter-2)

Laying at or near ground level old kerb stones of all types in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement : 3 coarse sand), including making joints with or without grooves (thickness of joints, except at sharp curve, shall not be more than 5 mm), including making drainage opening wherever required etc. complete as per direction of Engineer-in-charge. (Length of finished kerb edging shall be measured for payment). (Old kerb stones shall be supplied by the department free of cost) (DSR-2023/16.85)

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm), including making drainage opening wherever required complete etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineer-in-charge). (DSR-2025/16.69)

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineerin- charge. : All kinds of soil (DSR-2023/2.6.1)