Construction of New ICDS Centre Building at Andipatty in Division No. 20 , Zone-1

Amount

Earthwork Excavation for foundation in all types of soils and sub soils including soft disintegrated rock and soft rock to the full depth including all leads and lifts etc., complete.

Supplying and filling with approved quality of dry river sand to filling in foundation and basement and filling the site in layers of not more than 15cm thick etc., complete.

Cement concrete of mix 1:4:8 (one cement – four sand – eight broken stone) using Hard broken granite stone jelly of 40 mm gauge for foundation leveling course, standard specifications and Including cost and conveyance of all materials to working site, laying concrete and curing etc.

Supplying and erecting in the position of MS sheets including necessary supports for plane surfaces using MS Sheets of size 90cm x 60cm and or suitable shifted with welded mild steel angles of size 25mm x 25mm x 3mm for boarding laid over silver oak (country wood) joints of size 10cm x 6.5cm, complete complying with standard specification below Ground level.

a) Square Columns & Sunshades

b). Plinth Level Beam Sides

c) Lintel, Beam & Roof Slab

Supplying, fabricating and placing in position mild steel or tar steel bars for all reinforced cement concrete items of work including cost of steel transporting, straightening, cutting, bending, cranking, blinding, welding etc. including cost of MS or RTS rod and binding wire, all labour and materials complete

Providing and laying in position, standardized concrete mix M-20 grade in accordance with IS 456-2000, using 20mm and below graded hard granite stone jelly for all RCC items of works with minimum cement concrete of 325kg/m3 and maximum water content ratio of 0.55, including admixture (plasticizer / super plasticizer) in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without preparing strength and durability with about (5 cum) 7730 kg of 20mm machine crushed stone jelly with about (3.30 cum) 5156 kg of 10-12mm machine crushed stone jelly and with about (4.79 cum) 7670 kg of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrator, finishing curing etc., complete complying with standard specifications and as directed by the departmental officers. The coarse and fine aggregates to be used should be comply with the requirements of IS standards (No separate payment will be made by the department for the excess usage of materials) charges.

Foundation & base ment

Ground Floor

Brick work in cement mortar 1:5 mix using Fly Ash bricks of 230x110x70mm (8 3/4" x 41/4" x 23/4") from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing, laying and curing etc. complete. Complying with std. specifications

Providing Gravel filling including cost and conveyance of Gravel from approved quarry to work site and stacking to departmental gauge for pre measurement including labour for spreading etc., complete.

Supplying and fixing MS grill to doors windows and ventilators etc. using 20mm x 6mm as directed by the departmental officers inclusive of cost of MS grill and labour charges including one coat of red oxide and fixing in position etc. complete

Manufacturing,supplying & fixing in position Steel windows of MS sheet 20 gauge thick with openable shutter frame and shutter frame made out of steel section confirming to IS 7452/ 1990.The outer frames of windows made of Z section (F7D) of size 25 x 20 x 3 mm confirming to IS7452/1992 mullions are made of (F4B) of section size 46x25x3mm confirming to IS7452/1990.The shutters are individual and each of them can be operated separately. Sash bars are made of 'T'section (T2) of size 25x22x3m, 2nos of sturdy hinges and one numbers of handle cum slatch of special type are fixed for with openable shutter. Suitable opening is left for its any operation. One number of adjustable stay with locking bracket of sufficient length shall be provided for each shutter 4 nos. of 40x40x3mm anngle hold fast 230mm length are welded to the outer frame at appropriate point.M.S square bars of 12mm size is welded to the inner face of the window at equal intervals not excluding 10cm spacings ,20gauge MS sheet is used for covering the shutter. Grill members are painted with one coat of primer.

Doors-1.00 x 2.00 m

Windows- 1.00 X 0.90 m

Providing weathering course over roof slab using 20 mm size brick jelly mixed with pure slacked lime no sand to be used the proportion being 32:121/2 including cost and convenience of all materials to working site, well beating with wooden beaters giving necessary slope and thickness including finishing neatly etc.

Finishing the top of roof with one course of machine pressed tiles of size 200 mm x 200 mm x 20 mm of approved quality in Cement Mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 12 mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete

Special Plastering with cement mortar 1:3 (one cement Threee sand) 10 mm thick etc., Complete.

Plastering with cement mortar 1:5 (one cement five sand) 12 mm thick etc., Complete.

Plastering with cement mortar 1:3 mix, 20mm thick including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing etc. complete . complying with std. specifications

Dadooing walls with ceramic tiles of sizes 300mm X 450mm X 8mm size of approved make and quality and colour Set in cement mortar 1:2 (One part of Cement and two part of Plastering Sand (P- Sand)) over 10 mm base layer plastering and pointing with white cement neatly as directed.

Flooring with Eurocon plain tiles of size 30 x 30 x 1cm of approved colour and quality (Endura industrial tiles) in cement mortar 1:3 mix and pointing with the same mortar etc. complete and finish very neatly

Paving the floor with Double charged Vitrified tiles of approved quality and colour of size 600x600x8mm thick of approved make, quality and colour in all floors over a base layer of cement mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 20mm thick and laid straight alignment and pointed neatly with colour cement at the rate of 0.40kg/m2 laid without any air gap in the tiles neatly and fixing in position as per standard specifications and as directed by the departmental officer. The colour & quality of tiles should be got approved by Municipal Engineer before use on work

Painting two coats with ready mixed plastic emulsion paint of 1st class quality and of approved color over a priming coat including through scraping clean removal of dirt etc., complete and including necessary plaster of paris putty wherever required

Painting two coats with best approved quality colour enamel paint for new Iron Works excluding priming coat including cost and conveyance of enamel paint etc.

Supplying and fixing of Cudappa slab of 20/30/40/50mm thick for Cup board including cost of materials and labour etc complete

Wiring with 2 x 1.5 sqmm (22 / 0.3) PVC insulated SC unsheathedCu. Conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 3mm thick hylum sheet cover with Meatl switch box and 5A Ornamental Modular switch with continuous earth wire connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for PVC concealed light point / Fan point (For electronic regulator).SD-23

Supply and Fixing of 5A 3Pin and Combined flush type wall socket with 5A flush type switch condealed in suitable MS Box in flush with wall and concealed with 3mm thick hylem sheet. -SD-138

Supply and fixing of single box type 4'40 W flu fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed Copper leads from terminals to the fitting.SD-88

Supply and fixing of 1200 mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 1meter down rod on the existing clamp.SD-107

Supply and fixng of TNEB Meter Board suitable for 3 Phases 200A service connection made up of suitable angle iron frame work of size 3 feet x 2 feet using angle iron of size 1 1/2" x 1 1/2" x 1/4" rigidly fixed on wall covered with hylem sheet of size 3 feet x 2 feet of 12mm thickness with necessary bolts and nuts supports and supply and fixing of 3 Nos 200A fuse units (500V) 1 No. Neutral link, copper earth flat of size 1" x 1/4" with inter connection of EB meter to fuse units by 19/16 PVC insulated copper wire with earth connection complete - SD 131

Geological investigation charges preparation of geological survey report etc., complete

Drilling of 150mm Dia bore well in hard rack area in including labour charges for drilling and development charges for erection of caching pipe in over burden soils all cost and conveyance etc., complete

a). Drilling of 150mm Dia Bore wells in overburden soil including labour charges for insertion of casing pipes.

b). Drilling of 150mm Dia Bore wells in hard rock areas including transportation to the work site in hard rock areas and developing the bore wells

Supplying of best approved quality of PVC casing pipe of 150mm dia for bore well with socket end to suit bore well of required depth -6kg/cm2 best approved quality with ISI mark with necessary PVC coupling etc.,

Supply and delivery of 3 Phase Three HP Subnersible Motor (50LPM x 100m) with as per ISI standard specification including all cost and conveyance etc., complete. Sl. No.: 3.1-5)

Supply and fixing of 3 phase panel Board DOL with two level guard and auto start inculding all cost and conmveyance etc complete SD (11.1)

Labour charges for erection 3HP three phase Submersible Motor t including conveyance of all materials to the site and all labour charges etc., complete SD 17.C-1

Supply and Delivery of following specials with ISI making as per standard specifications (MEDIUM)

11/4" HDPE hose 10Kgf

32 mm G.I. Pipe

32 mm Coupling

32mm GI Elbow

32mm Gate valve

32mm NR Valve

32mm GI Bend

32mm GI Union

32mm GI B Nipple 6"

32mm HDPE Nipple

32mm Dia Hex Nipple

32Amps Fuse carrier [Elec V (b)]

Wooden meter board SD 127

Earth Plate

7/18 GI Wire

Nylon rope 25 mm thick

Bore clamp set

Bore cover

32 SS Hose collar

11/4" x 1" GI Reducer

1" Dia GI Barrell Nipple 9" Long

3 core 4 sqmm cable ISI

7/20 Service cable SD 60

1" Dia GI Pipe

1" Dia GI Elbow

1" Dia Union

1" Dia Gate Valve

1" x 3/4" GI Reducer

3/4" Dia GI Pipe

3/4" Dia GI Elbow

3/4" Dia GI Tee

3/4" Dia Union

3/4" Dia Gate Valve

3/4" x 1/2" GI Reducer

CP Tap

Angle Valve

4'' pvc Pipe

6'' Pvc pipe

4'' Pvc Elbow

6'' PVC elbow

1000lit HDPE Tank

48W LED Street Light Fitting with LED

Supplying and fixing in Position of Indian Oriya pan type water closet with “P’’ or “S’’ trap to set in brick jelly concrete 1:4:8 Mix concrete 10 cm thick using 20mm brick jelly and top finished with CM. 1:3 mix 20mm thick without any leakage etc. complete.

Dismantling the damaged Brick or stone masonry in cement mortar, wall under 3m high up to 70cm tk. Etc completed

Dismantling, Clearing away RCC Concrete etc completed

Sri Vaideeswara & Co (BID ID -1275975)