Plastering painting and providing door shutter with frame in fire affected mini FRS control room at Ground floor of TAX Building Cantt Varanasi.

Amount

Providing and fixing ISI marked flush door shutters conforming to IS : 2202 (Part I) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and sun mica on both faces of shutters:

a) 30 mm thick including ISI marked Stainless Steel butt hinges with necessary screws.

Extra for cutting rebate in flush door shutters (Total area of the shutter to be measured).

Providing and fixing aluminium sliding door bolts ISI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with nuts and screws etc. complete :

Providing and fixing aluminium tower bolts ISI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868 ) transparent or dyed to required colour or shade with necessary screws etc. complete :

Providing and fixing aluminium handles ISI marked, anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete :

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Renewing glass panes, with putty and nails wherever necessary including racking out the old putty:

a) Float glass panes of nominal thickness 4 mm (weight not less than 10kg/sqm).

15 mm cement plaster on the rough side of single or half brick wall of mix :

a) 1:6 (1 cement: 6 fine sand)

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre, of approved manufacturer, of required shade and colour complete, as per manufacturer's specification.

a) Two or more coats on new work.

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade :

a) Two or more coats on new work.

Providing and fixing 12mm thick prelaminated particle board flat pressed or graded wood particle board complete as per directions of engineer-in-charge.

a) Pre-laminated particle board with decorative lamination on one side and balancing lamination on other side.

Dismantling the damaged false ceiling frame , burnt frame of door shutter, damaged wall plaster works all complete as per direction of E-in-C.

Arranging electric welding machine at site for repairing works etc. with necessary cables and other T&P including the cost of operator and electrodes but excluding the cost of necessary steel sections complete as per direction of Engineer-in-charge. (Note: One day or part day work at one site shall be taken as one job.)

M/S DILIP KUMAR