CE-MTPSI-SE-ES-EM2-OT112-25-26

Charges for excavation/filling of earth for checking the cable joints below 1.5 M depth from the ground level with 3M length and 3M width to facilitate the rectification works. (3M X 1.5M X 3M = 13.5 M³)

Charges for Identification of LT Power cable route, Opening and checking the cable joints.

Charges for Clearing of light jungles for identification of cable route. (If necessary)

Charges for Excavation/filling of earth for locating the cables which are laid below 1.5 M depth from the ground level with 559M length and 1 M width to easily attend the rectification works. (CT-common Swgr to CT-I SWGR = 559 M X 1.5 M X 1M = 838.5 M³) (if necessary)

Charges for Removing the bricks which is covering the cables for entire length and removing the sand on the cables. (if necessary)

Charges including material cost for Chipping of concrete and roughening the surface. (If necessary) (cables laid in concrete/cement sand mixture ground for a length 48 M. Total area = 48 M length x 1M width)

Charges for De-Termination and de gland charges for LTUG Aluminum armored cable of size 1 C X 1000 sq.mm. (If necessary)

Charges for releasing defective 1CX1000 Sq.mm LT UG. Aluminum armoured cable. (If necessary) (559 M per cable)

Loading, Transporting and unloading of LT UG. Aluminium armoured cable drum. (If necessary)

Charges for Laying of New 1CX1000 Sq.mm LT UG. Aluminum armoured cable. (If necessary) (579 M per cable)

Charges for Providing cable joints with Heat Shrinkable type straight thorough joint kit.(2 joints if necessary)

Charges for providing sand covering the cables for the entire length and Repositioning of removed bricks covering the Cables for the entire length.(Data-5) (if necessary)

Charges for providing Gland and Termination of 1CX1000Sq.mm LT UG. Aluminum armoured cable cables from both end panels.

Loading, Transporting and unloading of released LT UG. Aluminium armoured cable drum. (If necessary)

Charges for fabrication of MS Board 10 Nos. of size 2’ x 1’ with ‘L’ angle support for cable root identification marking plate.

Material cost:- Heat Shrinkable type LT straight Through joint kit suitable for 1C X 1000sq.mm UG aluminum armoured 1.1KV XLPE LT cable

Consumable (Gas Cylinder for cutting, Hack saw blade, cotton waste, Gland, Bolt and nuts 1000sq.mm LUG & Insulation tape etc.,)