Widening and strengthening of Mirpur Saraiya Nanemau Kachha Bhitaura road (ODR) from chain 5.650 to 18.850.

Amount

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m As per MoRTH Spc. 301

Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2.

Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2.

Construction of granular sub-base by providing coarse graded Material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with front end loader at OMC and compacting with vibratory power roller to achieve the desired density, complete as per MoRTH clause 401

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub base /base course on well prepared surface and compacting with vibratory roller to achieve the desired density. complete as per MoRTH clause 406

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, with 1 % OPC cement & 3.5 % emulsion laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.as per MoRTH clause 406

Providing and laying dense graded bituminous macadam 50 mm Thickwith higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder @ 4.5 per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 505 complete in all respects.

Providing and applying tack coat with bitumen VG-10 using bitumen pressure distributor at the rate of 0.30 kg per sqm on the prepared Primed surface/bitumen surface cleaned with mechanical broom. As per MoRTH 503 for B.C.

Providing and laying bituminous concrete 30 mm thick with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder @ 5.4 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 507 complete in all respects

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No.-300-2. As per MoRTH Spc. 305

Construction of Hume Pipe culverts Earth work in excavation by mechanical means (Hydraulic excavator)/ Manual means over areas (excedding 30 cm in depth, 1.5 M in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and to lift upto 1.5 m, as directed by engineer in charge as per DAR 2.6.1

Providing and laying in cement concrete 1:4:8 (1cement:4 fine sand:8graded stone ballast 40 mm nominal size) and curing complete including supply all materials, labour and T&P etc. required for proper completion of the work. As per DAR 4.1.8

Providing and laying 40 mm gauge brick ballast below pipe and in sides.as per PWD spec. no 1.2

Supply of NP3 pipe as per MORTH 9.3, 1100

Laying & fixing of NP-3 pipe with collers As per MORD 9.3, 1100

Class 150 brick work in foundation and plinth with cement mortar 1:4 (1Cement :4 Coarse sand) As per DAR 6.1.1

Struck Cement Pointing on Brick work with cement mortar 1:2 (1 Cement : 2 Fine sand) As per DAR 13.32.1

12mm cement plaster in 1;4 cement & coarse sand mortar. As per DAR 13.4.1

Construction of U-Type drain in abadi portion (450x450 MM) Earth in excavation in trenches for foudation in ordinary soil including lift upto 1.5 m lead upto 50 m. and dressing of sides and ramming of bottom and disposal of surplus excavated earth as directed by the Engineer-in-charge within a distace of 50m

Providing and laying in cement concrete 1:4:8 (1cement:4 fine sand:8graded stone ballast 40 mm nominal size) and curing complete including supply all materials, labour and T&P etc. required for proper completion of the work.

Providing and laying 20 mm gauge approved stone in M25 Concrete by laid over base concrete including supply all materials, curing, labour and T&P etc. required for proper completion of the work.

Supplying, fitting & placing HYSD bar reinforcement in foundation complete as per drawing & technical specifications. As per MoRTH Spc. 1600

M/S A.S.TRADERS

M/S LUCKY TRADERS