Provision of CCTV surveillance system at 05 Parcel offices (GD, BST, GKP, STP, LMP) with 05 year AMC & Provision of Stainless Steel dustbin with grouting & Furniture in Baby Feeding corner at stations.

A-Supply & Execution

Supply and installation of 32 channel NVR Preparation of storage capacity calculation for recording back up days available for HD recording in NVR before supply of material. As per Technical Specification Schedule A attached Item no. 1. Inspection RITES. Above/

Supply and installation of 8TB Hard Disk Drive Internal for CCTV for NVR (WD) (WD Surveillance purple) with 3 year Waranty. As per Technical Specification Schedule A attached Item no. 2. Inspection Consignee Above/

Supply of HDMI CABLE 15 METER. Inspection Consignee Above/

Supply, Installation, Testing and Commissioning of Full HD Fixed Bullet type IP Color Camera along with 128 GB or Higher SD Card, housing and mountand all accessories required for installation purpose as per RDSO Spec No RDSO/SPN/TC/65/2021,Rev 6.0 or latest. Inspection RDSO Above/

Supply & installation of wall mounted 6U networking rack having power distribution board Fan, cable manager and front lockable door with glass. As per Technical Specification Schedule A attached Item no. 3. Inspection Consignee Above/

Supply of SFP Optical/Electrical 1 Gbps or 100/1000 Mbps Electrical as required. As per Technical Specification Schedule A attached Item no. 4. Inspection Consignee Above/

Supply of OFC patch cord cable (10 m long with APC/FC/LC/SC/-SC/LC/FC/APC or as per site requirenment connector Patch cord). Inspection Consignee Above/

Supply & Installation of layer-2 switch (minimum 8 +2 manageable ) with 08 Nos. 10/100/1000 Mbps ethernet port POE and 02 nos.1000 base X SM SFT port with optical modules complete with all accessories etc. as per RDSO specification no. RDSO/SPN/TC/65/2021 version-6 or latest. Inspection Consignee Above/

Supply of STP CAT-6 Cable (Shielded Twisted Pair) STP compliant with latest EIA/TIA- 568-B2-1. As per Technical Specification Schedule A attached Item no. 5. Inspection Consignee Above/

Supply and testing of STP/UTP RJ-45 Connectors as per site requirement. Inspection Consignee Above/

Supply and fixing of PVC conduit pipe 25 mm with accessories such as bend,tee, 11 coupling, elbow,saddle, clamp, screw, PVC/wooden plugs etc. on walls,angle or on rail of platform shelter etc. MS clamp made of 3 mm MS flat to be manufactured and supplied and fixed to clamp the PVC pipe or angle/ rail run of platform shelter. The clamp should be painted with red oxide primer over which two coats of aluminium paint to be given. Where ever necessary jumper holes to be made in wall and above PVC pipe threaded and wall to be repaired to its original condition. All the fixing material required to do the job will be provided by the contractor. Inspection Consignee Above/

Supply of 3 Core x 2.5 Sq mm multi strand copper conductor, PVC insulated, armoured power cable confirming to IS:1554 part I as per RDSO specification No. RDSO/SPN/TC /65/2021 rev 6.0 or latest). PVC insulated, Armoured, confirming to IS: 1554 Part I shall be provided. Inspection:- RITES Above/

Supply and installation of Two pole MCB for electronic equipments as per ISI Standard with current rating 6A to 32A as per site requirement in suitable PVC/ Metallic Box. As per Technical Specification Schedule A attached Item no. 6. Inspection Consignee Above/

Supply of 2 mtr Cat-6 Patch Cord LAN Cable . Patch cord should be of standard make. Inspection Consignee Above/

Supply and testing of Crimping tool for RJ-45 and RJ-11 . Crimping tool should be of standard make. Inspection Consignee Above/

Supply and installation of Professional Large Format UHD Display unit ,Size 139 cm. Non Touch screen duty cycle 24x7 with HDMI Port ,Ethernet Port,VGA Port and USB ports. As per Technical Specification Schedule A attached Item no. 7. Inspection Consignee Above/

Horizontal direction drilling (HDD)/Trenchless digging/machine drilling without damage to surface road /track for laying/insertion of DWC/GI/HDPE pipe. The bore shall be done of 17 min. diameter 120 mm & at the depth of minimum 1400 mm from the ground level.The ground level shall be considered ignoring the bank height of the bank of the road/ track. Note:- DWC/HDPE/GI Pipe supply is not covered under this item. Contactor shall provide all material required for work and adequate nos. of labours for proper laying of cables into the bore. Cables shall be laid cautiously so that these should not get damage due to rough handling & pressure on cable. Payment of boring shall be made only after laying of DWC/HDPE/GI pipein the bore. Inspection Consignee Above/

Excavation of cable trench of 1.20 mtr depth and 30 cm width in all kind of soil ,back refilling after laying of 6 Quad cable /OFC at 1.20 meter depth ramming & I consolidation of soil in trenches as well as disposal of soil if any.This includes all preventive works & all material supplied by contractor if required . As per Technical Specification Schedule A attached Item no. 8. Inspection Consignee Above/

Blowing/drawing of OFC cables in the HDPE duct along with all the protective work as per instructions of engineer incharge at site. As per Technical Specification Schedule A attached Item no. 9. Inspection Consignee Above/

Supply of 40/33 mm outer dia/inner dia . PLB HDPE duct as per RDSO Spec. No.RDSO/SPN/TC/45/2013, Rev 2.0 or latest with all accessories like end caps, collars, bends,couplers etc. Inspection Consignee Above/

Cutting of all types of platforms/road crossing and trenching and excavation to width 21 and depth of 300 mm x 300 mm , laying of DWC/HDPE/GI pipe in the trench and refilling and concreting it after wards as per original condition. Inhard rocky ground area, cables will be laid normally on layer of soft earth of 0.05 mtrs thickness previously deposited at bottom of the trench. The cutting to be filled and finished with cement/concrete as per theRDSO drawing no.SDO/Cable laying/008,issued vide RDSO document no.RDSO/SI/G/2010 Version 1.1 dated 04.02.2014 or latest. As per Technical Specification Schedule A attached Item no. 10. Inspection Consignee Above/

Supply OFC single mode 6 fiber armoured cable Specification No.IRS:TC55-2006 Rev.1 or latest. As per Technical Specification Schedule A attached Item no. 11. Inspection Consignee Above/

Supply of Power Board (3 No's 5 Amp & 1 No. 15 Amp socket totao -4 points) Inspection Consignee Above/

Supply and installation of PVC Box water proof at camera end. Inspection Consignee Above/

Supply of 12 port loaded LIU rackmountable, LIU should be provided forterminating the optical fiber cables. Itshall provide minimum bending radiusand splice trays shall function as a splicecover for Pigtail Splicing. Cable glandsshall be provided for secure anchoring ofincoming cables. Rubber grommets shallbe provided at the cable entry point fortight sealing. The splice tray should bemade of ABS materials. As per Technical Specification Schedule A attached Item no. 12. Inspection Consignee Above/

Installation, Testing & Commissioning of rack mountable 12 port Loaded LIU. All the accessories and fixing materials required for this installation are to be supplied by contractor with in the same cost. As per Technical Specification Schedule A attached Item no. 12. Inspection Consignee Above/

Supply, installation and commissioning of maintenance free earthing system which consists of supply of earthing kit 1 set consisting of (1) Earth electrodes of copper clad steel alloy of min.10 feet (3 meter) long,17 mm dia and copper thickness of 250 microns-01 No. (2)RDSO 27 approved Earth enhancing compound in3 0 Kg. pack - 01 No. (3)Copper tape of 25 mm X6 mm X 150 mm with 99 % purity-02 Nos. and another of 25 mm X6 mm X 300 mm to terminate on earth electrode. (4) This include supply of 35 sq mm/ 16 sq mm/10 sq mm multi strand single core PVC insulated copper cableas per IS:694 for connecting Main Earth Electrode to the Equipment. The Earthing material shall be supplied as per RDSO specification RDSO/ SPN/ 197/ 2014 Ver. 1.0 or latest. As per Technical Specification Schedule A attached Item no. 13. Inspection :- RDSO for supply, Consignee for installation. Above/

Laying of PLB HDPE pipe in trench/open space, fixing and clamping of HDPE pipe on wall or structure and sealing of the duct after laying with proper fixing material. All the accessories like couplers, end caps/plugs to be provided by the contractor within the same cost and its protective work as per directionof site engineer. Inspection Consignee Above/

Laying and drawing of data/OFC /Power cable through PVC Pipe,Casing Capping & conduit Pipe as per Instruction of Engineer Incharge. All the accessories to be provided by the contractor within the same cost and its protective work as per direction of site engineer. Inspection Consignee Above/

Supply and Fixing of Hot Dip galvanized perforated type cable tray 100 mm width and 50 mm height made with 14 SWG Sheet. All the fixing material shall be provided by the contrator at no extra cost. Inspection Consignee Above/

Supply and fixing of Hot Dip galvanized type cover plate for 100 mm width cable tray with 18 SWG Sheet. All the fixing material shall be provided by the contrator at no extra cost. Inspection Consignee Above/

Supply and Fixing of Coupler plate with hardware for 50 mm Height Hot Dip galvanized/powder coated type trays. All the fixing material shall be provided by the contrator at no extra cost. Inspection Consignee Above/

Supply of networking Gigabit switch 24 port POE+ having 4 Uplink fiber ports Min. Switching capacity 128 Gbps. As per Technical Specification Schedule A attached Item no. 14. Inspection Consignee Above/

"Supply and installation of FDMS and termination of IN and OUT 24 fibre OFC cables as per GR No G/FDM-01/02 April-2007 of TEC or latest. [with all connecting materials]routing/dressing fibres as per direction of engineer/incharge. this work includes testing of fibres in the section/block. As per Technical Specification Schedule A attached Item no. 15. Inspection Consignee " Above/

Supply & Testing of high speed LAN extender 30 mbps 2/4 wire . As per Technical Specification Schedule A attached Item no. 16. Inspection RITES

Comprehensive Annual Maintenance Contract for Full HD Fixed Bullet Type IP Colour Camera For Period of 5 Year. The AMC rate for one unit quantity for 01 month. Total quantity considered as 60(1 set X 60 months), as AMC is for Five years). Qty- 60x60= 3600 months. As per Terms and Condition given in Technical Specification Schedule B-CAMC Above/ Number-

Comprehensive Annual Maintenance Contract for layer-2 switch (minimum 8 +2 2 manageable ) with 08 Nos. 10/100/1000 Mbps ethernet port POE and 02 nos.1000 base X SM SFT port with optical modules complete with all accessories. For Period of 5 Year. The AMC rate for one unit quantity for 01 month. Total quantity considered as 20(1 set X 60 months), as AMC is for Five years). Qty- 16x60= 1200 months. As per Terms and Condition given in Technical Specification Schedule B-CAMC Above/ Number-

Comprehensive Annual Maintenance Contract for 32 channel NVR Server along with storage with all acessories For the Period of 5 Year. The AMC rate for one unit quantity for 01 month. Total quantity considered as 10(1 set X 60 months), as AMC is for Five years). Qty- 10x60= 600 months. As per Terms and Condition given in Technical Specification Schedule B-CAMC