Provision of galvanized steel sections (Hot dip) for cloth-drying purpose and vertical drain-lines in atrium area of all UG Hostels at AIIMS Bhubaneswar.

Providing, fabricating and fixing galvanized structural steel work in built-up sections/framed work made of plates, angles, circular and square hollow and soild pipes of required size including cutting, welding, hoisting, and fixing in position, conforming to IS:2062 and IS:4759, duly hot-dip galvanized with 80-100 micron coating. The work shall include the application of a priming coat of approved primer over prepared surfaces. The rate inclusive of all materials, labour, welding electrodes, proper alignment, leveling, tools, scaffolding, transportation and all incidental charges required for completing the work in all respects as per drawings, specifications as directed by Engineer-in-Charge. Mode of Measurement: Measured in kilograms of finished structural steel.

Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer's specifications including appropriate priming coat, preparation of surface, etc. complete: On steel work

Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil.

Extra for every additional lift of 1.5 m or part thereof in excavation /banking excavated or stacked materials. All kinds of soil

Filling available excavated earth (excluding rock) in trenches, plinth,sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m.

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix) .

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources : 6 graded stone aggregate 20 mm nominal size derived from natural sources)

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge : In cement mortar

Centering and shuttering including strutting, propping etc. and removal of form for all heights : Foundations, footings, bases of columns, etc. for mass concrete