Library Room Partition Arrangement and UGD Pipe line Laying at MGR Bus Stand K.K. Nagar in Ward No 33 Zone II Madurai Corporation

Amount

Cutting the existing BT Road surface the debris clearing away from the site etc.complete..,

Earth work excavation for foundation & depositing on bank with an initial lead of 10m & lift of 2 m for depths in soft disintegrated Rock when required, barricading with safety lamps etc all complete as per standard specification as directed by the Departmental Engineer.

Supply of UN PLASTICIZED PVC PIPES FOR POTABLE WATER SUPPLY AS PER IS 4985 /2000

Lowering PVC/ DWSC rigid pipes and specials to trench and laying to proper grade and alignment, jointing with PVC couplers with cement paste.

Refilling the trenches with suitable excavated earth available along the alignment after the pipes & specials are laid, jointed & tested in layers & watering, ramming & consolidation directed by the Engineer-in-Charge

Supplying and fixing in position of Aluminium Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI

Supplying, fabricating and fixing in position of Aluminium Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using ectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sectionsn.

Painting old wall surface with Two coat of Plastic Emulsion paint of approved quality including cleaning of plaster surface with soap soda and water by manual labour.washing plastered surfaces with soap, soda and water with soda lime etc.

Wiring with 2x1.5sq.mm. PVC insulated single core unsheathed FRLS copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories with 150mm x 100mm x 75mm MS switch box for 5A3 pin no n interlocking flush type CS plug wf th painting of suitable colour with continuous earth wire connection of 1.5 sq.mm copper wire for open plug point

Supply and fixing of single box type 4'36W fluorescent fitting complete with copper choke and condensor with conduit pipe suspension from the ceiling with PVC unsheathed FRLS copper leads from terminals to the fitting with tube

Supply and fixing of 1200mm (48") AC Ceiling fan complete with stepped electronic 300W regulator with 1meter downrod on the existing clamp

Supply and fixing of 300mm (12") sweep (light duty) AC exhaust fan complete with necessary wall opening and making good of the wall

Add GST 18%

C SATHIYASEELAN (BID ID -1285104)