PROVISION OF CERTAIN LBW REVENUE AND MINOR WORKS AT GRC UNDER AGE B/R-II AND PROVISION OF 10 SOLAR WATER HEATER FOR OTM ACCN OF TRG BN UNDER AGE E/M W/S OF GE (WEST) JABALPUR

Amount

Excavating in trenches, n.exc 1.5m wide and n.exc 1.5m depth; for fdn etc,or for shafts n.exc 10 sqm on plan in any type of soil complete all as specified and as directed.

Excavation in trenches, n exc 1.5m wide and exc 1.5m but n.exc 3.0m in depth for fdn etc or for shafts wells, manholes pier holes etc n.exc 10 Sqm on plan and in any type of soil complete all as specified and as directed.

Excavating over areas, n exc 1.5 m deep and getting out in any type of soil complete all as specified and as directed.

Excavating over areas, exc 1.5 m deep and n exc 3 m getting out in any type of soil complete all as specified and as directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm complete all as specified and as directed.

Removing excavated materials n.exc 50M and depositing where directed at a level n.exc 1.5M above the starting point complete all as specified and as directed.

M&L for laying DWCP 200 mm dia pipes in trenches class SN-8 conforming to IS 16098 (Part 2) in 6 mtr length with coupler complete all as specified and directed by Engr-in-charge

M&L for laying DWCP 150 mm dia pipes in trenches class SN-8 conforming to IS 16098 (Part 2) in 6 mtr length with coupler complete all as specified and directed by Engr-in-charge

M&L PCC 1:4:8 type D-2 (using 40 mm graded stone aggregate) as in concrete bed to drain pipes including packing under and haunching against the sides of pipe after they are laid and tested for 200 mm dia pipe complete all as specified & directed.

M&L PCC 1:4:8 type D-2 (using 40 mm graded stone aggregate) as in concrete bed to drain pipes including packing under and haunching against the sides of pipe after they are laid and tested for 150 mm dia pipe complete all as specified & directed.

M&L PCC 1:4:8 type D-2 (using 40 mm graded stone agg) as in foundation or subbase of man holes complete all as specified & directed.

M&L for 200mm thick PCC 1:2:4 type B2 (40mm graded crushed stone aggregate) as in floors finished even & smooth without using extra cement complete all as specified and directed by Engr-in-charge.

M&L for brick work with sub class' B' bricks of old size, straight or curved on plan exc 6 m mean radius built in cement mortar 1:6 complete all as specified and as directed.

M&L for brick work with sub class'B' bricks,straight or curved on plan to any radius in half brick thick wall built in CM 1:4 complete all as specified and as directed.

M&L for brick work with sub class "B" bricks in one brick thick honey comb walling built in CM 1:4 etc all as specified

M & L for TMT bars 6mm to 8mm dia and over cut to length , bent to shape reqd incluidingcrancking, bending spirally hooking ends and binding with mild steel wire (anealed) not less 0.9mm dia or securing with clips complete all as specified and as directed.

M & L for TMT bars 10mm dia and over cut to length , bent to shape reqd incluidingcrancking, bending spirally, hooking ends and binding with mild steel wire (anealed) not less 0.9mm dia or securing with clips complete all as specified and as directed.

M&L for rendering 15mm thick in CM 1:4 on fair faces of brick work , finished even and smooth without using extra cement mixing with water proofing compound @ 3% by weight of cement all as specified and directed. Note:- Water proofing compound shall be measured and paid for seperately.

Supply only integral water proofing compound.

M&L for Providing precast cement concrete 1:2:4 type B-1 (using 20mm graded stone agg) as in manhole covers set in cement motar 1:6 etc all as specified and directed including necessary formwork and moulds all as specified and directed

M&L for Extra forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred / stopped ends etc complete all as specified and directed.

M & L for Reinforced cement concrete (Nominal Mix) in 1:2:4 type B1 (using 20mm graded stone aggregate) slab supported on walls, beam and column in floors, roofs, landings,balconies, canopies, deck slabs and in shelves and the like etc complete all as specified and direced.

M & L for Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work, not exceeding 200mm thick (Horizontal or sloping) with fair finish surface complete all as specified and directed.

Form work to edges of concrete flats, treads breaks in floors, window cills, concrete railings, openings in concrete walls, floor and roof and sides of bands in walls, horizontal or sloping and similar work for rough finished concrete surface exc 10 cm but not exc 20 cm wide complete all as specified and directed.

S & F MS works for fencing post and struts including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets, MS Rungs (for securing wire mesh etc) including all necessary drilling, bolting or riveting, etc conforming to Fe-290 Gde E-165 complete all as specified and directed.

M&L for Providing cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate as in lintels upto 1.5m clear span, cills,steps,and other similar bands,plinth courses, string courses, lacing courses, parapets and railing upto 60cm height,copings,kneelers,apex stone,bed plates and the like including weathering slightly rounded or chamfered angles and throating, all as specified and directed.

Surface excavation n.exc (not exceeding) 30cm deep and averaging 15cm deep and getting out complete all as specified.

M&L for PCC (1:5:10) type E-2 using 40mm graded stone aggregate as in foundation & mass concrete complete.

M&L for 50mm thick cement concrete type B1, 1:2:4 (20mm graded stone agregate) as in floor, finished even and smooth w/o using extra cement complete.

M & L for Moorum / red bajari filling in floor or paving laid in layers n exc 15 cm thick, spread, levelled and rammed inclding watering complete all as specified.

M&L for filling hard core of broken stone or boulders of gauge not exc 63mm, deposited spread and levelled in layers n nxc 15cm thick watered and rammed to a true sufrace etc complete all as specified and directed.

M & L for preparation of new plastered surfaces of walls & applying three coats of white wash complete all as specified.

M & L for plain Cement concrete type D-2, 1:4:8 (40mm graded crushed stone aggregate), 75mm thick as in sub base complete.

M&L for PCC 1:2:4 type B1 using 20 mm graded stone aggregate in coping including necessary use and waste of form work etc. complete.

M & L for 50 mm thick sand filling under floors or in foundations including watering and consolidation complete all as specified.

M & L for providing machine pressed precast concrete rubber moulded glossy finish interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade with grey cement pigment complete all as specified.

S&F plates/sheets plain or chequred channel, square cut or notched (ordinary and counter sunk) forming holes, without and attachment Fe 410-w Gde E-250 quality "B" etc complete all as specified and directed

S&F rolled sections as in main ans cross beam, hip and jack rafters purline where connected to common rafter and running rails and guides for sliding door fixed with angle cleats or other connecting plates, Fe-410 w (Gde E-250) quality 'B' complete.

S&F framed work as in doors or gates of angle or other section with gussest plates, rails, braces, etc, complete drilled for fixing and incl steel sheeting or other covering doors etc, to be prepared for hanging and sliding with and including either hooks and hinges or steel hnging door fittings and fixing complete conferming to gde Fe 410-w

M&L for two coat of synthetic enamel painting over a coat of red oxide primer incl preparation of steel new surface over 10 cm width or girth

S&F 05 to 10mm dia mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed to other end, or screwed both ends, each screwed and to fitted with washers and one hexagonal or square nut exc 10 cm and n exc 15 cm

Excavation in post holes(or similar holes) each n. exc.0.50 cum getting out, returning filling in and ramming earth and removing surplus soil to a distance n.exc. 50M and making good surface getting out in any type of soil complete.

M&L for PCC 1:2:4 type B1 using 12.5 mm graded stone aggregate as in surface channal and drains complete.

S&F steel work as in tubler truss/ Post including special shaped washer etc complete using ERw induction Butt welded tubes.

S & F hand rails, half ruond or other stock section or core for woodenhand rail starigt portion drilled and countersunk for balusters running bars for door balusters nosing to steps inculuding embeding in concrete and screwing etc. Wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets(for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc.' and similar work conforming to Fe-290 Gde E-165.

S&F Pre-painted galvalume aluminium zinc coating GI based corrugatged steel sheet 0.5mm thick of an colour having tensile strength of 550 Mpa as in roof covering /cladding to wall, fixed with self tapping screws as specified.

S&F Pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.5mm thick of an colour having tensile strength of 550 Mpa as in roof covering /cladding to wall, fixed with self tapping screws as specified.

S&F Machine cut Kota stone slab flooring 18-22 mm thick as in floor over and including cement screed base 15mm thick in cm 1:6 laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and mirror polishing.

Ditto all as per above items but fixed as in skirting over and including 10mm thick cement plaster in CM 1:4

S&F mild steel work conforming to Fe-290 (Gde E-165), angle or tee section, fixed independently w/o convert plate including necessary cutting,drilling etc.

S&F medium grade galvanised steel tubing with all fittings fixed to wall or laid in floors for 50 mm bore GI tubing.

S & F sand cast iron soil, waste and vent pipe, 100mm bore, in any length with or without ear with cement joint laid in trenches or floors, complete all as specified.

S&F any height (above floor level) stainless steel (Grade 304) hollow round or square pipe of any dia/size fixed as in posts/railing with knock down fixing systme & top mounted round baluster made of 38 to 50mm dia stainless steel 304 grade. Channels, plates etc including welding grinding buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete . ie fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc of required size on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer in Charge inluding 4mm dia stainless steel chain industrial type as in row horizontally in garland shape welded to vertical stainless steel post complete all as specified and directed. Note : The distance between vertical stainless steel posts should be as site requirement centre to centre.

Demolition of cement concrete of any description and in any position provided for complete etc all as specified and directed

Supply and fixing solar water heater system of capacity 300 Ltr tank which having type which having type of collector is flat plate collector (FPC) operating is frequenly 50-60 HZ, 220 volts with material is used of copper 02 storage tank having thickness of mn 2 mm with 02 year of warranty of the complete arrangement as directed by Engineer in Charge, Make : TATA/V-Guard/Bosch/Supreme. Note : Hot water pipe duly insulated with glass wool and aluminium cladding including fittings etc as required at site enclusive in quoted rate.

S&F fabrication of angle iron frame stand with equal angle of size 40x40x 6 mm suitable for Solar water heater and fixing arrangement complete all as directed by Engr-in-Charge .

M&L for PCC 1:3:6 type C1 using 20mm graded stone aggrregate in coping of poles/foundation for poles, struts, posts etc including necessary form work, finished the exposed surfaces fair and even without using extra cement complete all as specified and directed

S&F 20mm dia ball valves high pressure PTMT with epoxy coated aluminium rod & highdensity plastic ball screwed for iron pipe and etc all completed

S&F rotational for Rational Moulded polyethylene water storage tanks 300 Ltrs (Cylindrical vertical with closed top) hoisted and fixed in position all as specified and directed by Engr-in-Charge. Make : Sintex/Polycon

S&F Gun Metal globe or gate valves with iron wheel head, screwed both ends for iron pipe 20mm bore

S&F Gun Metal globe or gate valves with iron wheel head, screwed both ends for iron pipe 15 mm bore

S&F 15mm dia cock bib brass chromium plated screwed down for size of 15mm dia pipe

S&F Tubes 20mm Medium grade galvanised with all fittings and fixed to walls and ceiling s or laid in floors

S&F Tubes 20mm Medium grade galvanised with all fittings laid in trenches

S&F Sub main wiring power/circuit using PVC insulated unsheathed, stranded copper conductor cable 2 Single core of size 2.5 Sqmm earth continuity of size 1.5Sqmm to be drawn through and including PVC casing capping 20mm dia medium Grade surface in wall/floors all as directed by Engineer in Charge Notes : (i) Two wires of 2.5 Sqmm and one wire of 1.5 Sqmm and one run of PVC casing shall be measured as one unit

S&F MCB SPN 240 Volts 'C' series Breaking capacity 10 KA of rating 6-32 Amps complete all as specified and as directed (Model No 4086 14-408617 of make legrand or equivalent model in Havells/Hager/C&S/GE)

S&F enclosure CRCA approved sheet metal enclosure 2 way vertical mounted module of make: L&T

Supply and laying or fixing or passing through pipe 1100 volts grade heavy duty cable with PVC insulated aluminium conductor served with an inner sheathing of PVC tape armoured with galvanised steel wire or tape and overall PVC sheathed 10 Sqmm 2 core nominal cross section in service connections

MAA SHARDA CONSTRUCTION

Sachdeva Enterprises