General Repairing of room no. 214 and 215 at Dr. Ram Manohar Lohiya Parikalp Bhawan, Telibagh, Lucknow. (Lot No.07)

Amount

Scraping old white or colour wash including disposal of refuse as directed by the Engineer-in-charge with in a distance of 60 meters

Providing and applying white cement based putty of average thickness 2mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Providing and Fixing 15 mm thick densified tegular edged eco friendly light weight calcium silicate false ceiling tiles of approved texture of size 595 x 595 mm in true horizontal level, suspended on inter locking metal grid of hot dipped galvanised steel sections (galvanising @ 120 grams per sqm including both side) consisting of main ‘T’ runner suitably spaced at joints to get required length and of size 24x38 mm made from 0.33 mm thick (minimum) sheet, spaced 1200 mm centre to entre,drawings and as directed by Engineer-in-Charge.

Finishing wall with Premium acrylic smooth exterior paint with silicone additives of required shade old work (Two or more coats applied @ 1:43 Ltr/10 sqm) over existing cement paint surface (apex Ultima , weather coat att guard)

Providing and fixing aluminium die cast body tubular type universal hydraulic door closer (having brand logo with ISI, IS : 3564, embossed on the body, door weight upto 35 kg and door width upto 700 mm), with necessary accessories and screws etc. complete.

Supply and Fixing of 55 watt indoor recess mounting LED Square fitting for Armstr5ong ceiling having powder coated die cast aluminium housing with body with extended heat sink and diffuser of polycarbonate meterial and driver set complete in all respect.

Providing and Fixing of Single Roller blind –utilise one layer of fabric Complete in all respect as per direction of Engineer-in-Charge

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below:

The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos.

Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs.

On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs.

On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)

M/S ASHOKA ENTERPRISES (BID ID -5437038)