Providing of Aluminum Partition Wall at East Zonal Office in East Zone

Amount

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections.

Providing cup board Shutter with frame using termite/water proof plywood of 19mm thick over which laminated sheet of 0.8mm thick fixed inside the shutter and 1mm thick fixed outside the shutter using fevicol along with necessary furniture fittings such as hydraulic hinges tower bolt handles multi purpose locks etc as directed by the Departmental officers. The design pattern water proof plywood laminate sheet and other materials should be got approved from the Executive Engineer before use on work

Supplying of Aluminium Grill of standard pattern (diamond shape) -10mm thick including 'F' (or) 'H' Section the rate includes all cost and conveyance of materials etc.,complete, in all floors

Labour charges for fixing aluminium Grill the rate includes all cost and conveyance of materials etc.,complete, in all floors

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated unsheathed SC copper conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW switch box with 5A FT switch inflush with wall covered with hylum sheet of 3mm thick with painting of suitable colour for open PVC light / fan point (for electronic regulator) (5 points per coil)

Wiring with 2 x 1.5 sq.mm (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150 x 100 x 113mm TW switch box for 5A 3 pin non inter locking Wall socket with 5A flush type switch with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC plug point

Wiring with 2 x 4 sq.mm. (56 / 0.3) PVC insulated SC unsheathed copper conductor cable of 1100V grade in suitable pipe on wall and ceiling with PVC accessories with 150mm x 100mm x 113mm TW switch box for 15A 3 pin non inter locking wall socket with 15A flush type switch with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC power plug point

Supply and fixing of 24W LED 4000K 2 x 2 Square Type Recessed Fitting with LED (Higher End) on False Ceiling with Suitable hanging Support from Ceiling With PVC unsheathed copper leads from terminals to the fitting SD 526

Removing of Existing Work Station the rate includes all Cost and Conveyance of labour, accessories, Shifting and all other incidental Charges etc., Complete., etc., Complete

Labour wrought and put up in position Shutters for fully panelled doors internal five plywood panels including labour charges for fixing furniture fittings complying with standard drawings and standard specification.

Supplying and Delivery of Mesh Type Executive Chair With arm Rest the rate Includes all cost and conveyance of materials,labour ,loading, unloading Charges etc., Complete

Supplying and Delivery of Executive Table With One Side Storage Unit of prelaminated Particle Board Wooden Product Size (1.50mx 0.75mx0.80m) (± 50mm) the rate Includes all cost and conveyance of materials , labour,loading,unloading Charges etc., Complete

P. JEFFERSON SAMUEL RAJ & SONS