Road Safety Work On Meerut Pouri NH-34 Km 55 to Meerapur Bus Stand Khedi Sari Bhumma NeharPul to Khedi Kuresh Ghatyan km 15 Tak

Provinding and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, Thickness of 2.5 mm is exclusive applied glass beads as per IRC 35 The Finished surface to level , uniform and free from streak and holes (Zebra Crossing) Excluding GST

Supply, fixing and hoisting of 12.00 - 15.00 M span Overhead Structure in position with two vertical posts of 6.00 M. clear height from the top of R.C.C. foundation made of 300 mm. dia pipe welded with 10 mm thick MS plate at bottom supported with 10 mm thick MS plate stiffeners & two nos.10 mm thick MS plates at top welded with structure of 50 mm NB (M) pipe comprising of horizontal, vertical pipe of 40 mm NB (M) and bracing pipe of 32 mm NB (M) as per structural design requirements and approved drawing with vertical and lateral clearance given in clause 802.2 and 802.3 including one coat of primer and two coat of synthetic enamel paint on the whole structure and installed as per clause 802.7 over a designed support system made up of concrete including excavation, lean concrete with 1:4:8 cement, coarse sand and approved 20 mm grit and R.C.C. 1:2:4 with cement, coarse sand and approved 20 mm grit complete for fixing the complete structure in position as per direction of E/I. charge. With 7 years warranty. Rates include design, fabrication, supply, transportation and erection of the sign board and also inclusive of all taxes, oyalty, etc Excluding GST.

Reflective Raised Pavement Marker Providing and fixing of raised pavement markers (Cat Eye) Type x-ASTMD-4956-04 Avery Dennision/3m(USA Make) having moulded body of polycarbonate, ASA, HIPS or ABS able to support a load of 13.635 M.T. tested in accordance with ASTMD 4280 type H and other requirement mentioned in MoRT&H Circular, its reflective lens made of micro prismatic lens (capable of providing total internal reflection of light), electronically welded to the body. The length, height and width of the body shall not exceed 130 mm, 20 mm and 105 mm respectively, The area of each reflective surface shall not be less than 13 Sq. cm . on each side sloping at the angle of 35 + 5 degree to the base to ensure maximum reflectively. it shall comply to specification of Category A of MoRT&H circular no. RW/NH 33023/10/97-DO-III dated 11.06.97 lenses shall be moulded of methyl methecrylate conforming to ASTMD 788 or equivalent. With 7 years warranty. Rate shall be inclusive of all taxes, royalty, etc. All T&P/ machine material and labour required for proper completion of work Excluding GST.