NIT No. 04 (24-25) Item No. 4

Dismantling of existing open well submersible dewatering 5 HP pump set, pipe, flange, bend etc.

Supply of open well Submersible Pump Set 5 HP, 3 Ph, 2900 rpm, discharge 1050 L/min at 14 Mtr head suitable for mixed water application. Make: - Kirloskar/ WILO M&P/Havells/Lubi Pump/ Mody/ Any DJB Approved make.

Supply of 80 mm diameter medium (B class) MS pipe. Make: - Jindal Hisar/ Jindal Star/Tata/ISI Mark

Supply of Slipon flange 80 mm diameter internally threaded. ISI Mark

Supply of 80mm dia. MS Bend with both side flanges duly welded and threaded as per site requirement.

Supply of Nut, Bolt and Washer of good quality as per site requirements

Supply of Neoprene rubber sheet 50% Neoprene. Make: - Jyoti/ Any DJB Approved make. DJB SOR 2022 Item Code: 22.6.1

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: 1:3:6(1 Cement: 3 coarse sand (zone-III): 6 graded stone aggregate 20 mm nominal size). DSR (Civil) 2021 Item No. 4.1.5

Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed / XLPE aluminium conductor cable of 1.1 KV grade of size 3 X 10 Sq. mm. DSR (E&M)- 2022, Item No. 9.1.7

Supply, 1.1 kV grade, XLPE insulated, stranded Aluminium conductor, galvanized steel flat strip /round wire unarmoured, extruded PVC type ST2 sheathed, conforming to IS:7098 (Part-1) & IEC:60502 (Part-1) of sizes 3 core X 10 Sq. mm.

Providing of electrical insulating mats confirming to IS 15652/2006 of size 1-meter X 2-meter, 3mm thickness for electrical purposes. Make; - Jyoti/Any DJB Approved make. DJB SOR Item Code: 22.5.3

Installation, erecting, laying of pipe, testing, and commissioning of the above said pumps, dewatering fitting of valves, necessary reinforcement and nut bolts, rubber gasket, vibration isolation arrangement, loading, unloading, cartage, dismantling of existing system, lifting the same and taking out at floor level, making good all damages caused during installation and restoring the same to their original finish as required, adequate safety provision, barricading, warning signal and other safety measures while executing the work or wherever necessary so as to avoid accident. The components of the installation shall be of such design to satisfactory function under all conditions.

Raj Engineering Co.

Devraj Enterprises

Monarch Engineering Works