Construction of Compound wall around the proposed compost yard at R.S. NO.11/3 Melakasakudy Revenue Village in Nedungadu Commune

Amount

Code No. 20.2.1 Boring , providing and installing bored cast -in-situ reinforced cement concrete piles of grade M-25 of specified diameter and length below the pile cap, to carry a safe working load not less than specified, excluding the cost of steel reinforcement but including the cost of boring , with bentonite solution and temporary casing of appropriate length for setting out and removal of same and the lenghth of the pile to be embedded in the pile cap etc. all complete , including removal of excavated earth with all lifts and leads (length of pile for payment shall be measured upto bottom of pile cap) - 300 mm dia piles

Code No. 2.8.1 Earth work in excavation by mechanical means (Hydraulic excavator/manual means in foundation of drains not exceeding 1.5m in width or 10 sqm on plan) including dressing of sides and ramming of bottoms, lift upto 1.5m, including getting out the excovated soil and disposal of surplus excavated soil as directed, within a lead of 50m-all kinds of soil.

code No. 2.27 Supply and filling in plinth with river sand under floors including, watering ramming consoliddling and dressing complete.

Code No. 4.1.10 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering.- All work upto plinth level -1:5:10 (1cement:5coarse sand:10graded stone aggregate 40mm nominal size).

Code No. 5.9.1 Centring and shuttering including strutting, propping etc.and removal of form for:Foundations , footings, bases of columns ,etc. for mass concrete.- Using steel sheet with M.S.frames.

Code No. 4.1.3 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering.- All work upto plinth level -1:2:4 (1 cement:2coarse sand : 4 graded stone aggregate 20mm nominal size).

Code No. 5.1.2 Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centering,shuttering,finishing and reinforcement -All work upto plinth level : 1:1.5:3 (1 cement : 1 .5 coarse sand : 3graded stone aggregate 20mm nominal size).

Code No. 5.9.6 Centring and shuttering including strutting, propping etc. and removal of form for: columns,pillars,piers,abutments,posts and struts.- Using steel sheet with M.S.frames.

Code No. 5.2.2 Reinforced cement concrete work in walls (any thickness), including attached pilasters , buttresses, plinth and string courses , fillets, columns , pillars, piers, abutments, posts and struts etc.upto floor five level excluding cost of centering, shuttering,finishing and reinforcement:1:1.5:3 (1 cement : 1.5coarse sand : 3 graded stone aggregate 20mm nominal size).

Code No. 5.22.6 Reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete - Thermo - Mechanically treated bars (TISCON/VIZAG/IISCO/SAIL/JSW) including placing the M30 grade Athees make cover block @ 60cm centre to centre.

Code No.6.13.1 Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 3.5 in superstructure above plinth level upto floor V level - cement mortar 1:3 (1 cement : 3 coarse sand)

Code No. 13.1.2 12mm cement plaster of mix :Cement mortar 1:4 (1 cement : 4 fine sand).

Code No. 13.28.3 12mm thick plain cement mortar bands in cement mortar 1:4 (1cement : 4 fine sand) - raised band

Code No. 13.45.1 Finishing walls with textured exterior paint of required shade - New work (Two or more coats applied @ 3.28 ltr/10 sqm) over and including base coat of water proofing cement paint applied @ 2.20 kg/10 sqm.

Engaging of Front end loader 1 cum bucket capacity including fuel and operating labour charges etc, complete as directed by the Engineer - incharge.

Code No. 10.27 Supplying and fixing of steel grill work of m.s. angles,flats,squares and pipes including cost of welding charges, fixing in position in masonry walls with cement concrete 1:2:4 (1 cement : 2 course sand : 4 graded stone aggregate 12.5mm nominal size) including one coat of priming coat etc. complete.

Code No. 13.61.1 Painting with synthetic enamel paint of approved brand and manufacture to give an even shade - Two or more coats on new work.

Code No. 9.165.1A Providing and fixing of 65mm Godrej Navtal lock of 6 levers etc complete.