SITC of 1 No. 16 metre highmast system at Rose garden and P/F 2 Nos. 11 metre poles with fitting in tennis court at Sports Complex in MDU, Rohtak

Amount

Wire & Cable Supply and erection of 3 core PVC copper insulated and sheathed circular flexible wire (e) Size 2.50 sqmm (80/0.20mm)

Moulded case circuit breakers supply and erection of moulded case circuit breaker on wall or on existing pedestal including bonding to earth and necessary connections. (ii) 100 amp to 220 amp 3 pole 25 KA

Supply and erection of M.S. angle iron frame duly welded for housing M.S. sheet & main switches etc. on it, fixed on wall by means of suitable size of rag bolts with cement concrete, duly painted with three coats of approved paint including one coat of red oxide. ii) size 40 mm X 40 mm X6 mm

Supply and erection of 3 mm thick mild steel sheet duly welded on existing M.S. angle iron frame for fixing the main switches etc. as required, duly painted with three coats of approved paint including one coat of red oxide.

Supply and erection of miniature circuit breaker / isolator 240 / 415 V in the existing distribution board including making necessary connections. (a) Miniature Circuit Breakers of 9 K.A. breaking capacity (iv 40 Amp to 63 amp TPN MCB

Pipe laying Supply and erection of pipe for wiring purposes including bends inspection boxes etc. where necessary and painting as required: For additional length of Galvanised iron flexible pipe more than 1 metre (the payment to be made for additional length of pipe more than 1 metre only in time No. xxvii) (c) Size 25 mm dia

Supply and erection of cast iron pipe laid 1 metre below ground level including digging joining with jute and cement etc. Cast iron pipe 120 mm dia

Cast iron pipe 80 mm dia

Supply and erection of PVC pipe of 6 kg. pressure, laid 1 mtr. Below ground level complete including digging refilling of the trench with jointing etc. PVC pipe 65 mm dia

Earthing with G.I earth pipe 4.5 m long and 40mm dia with masonry enclosures on the top etc. as required.

Extra for using salt and char coal/ coke for pipe earth electrode as required.

Supply and laying 25mm x 5mm G.I. strip at 0.5 metre below ground as strip earth

Pdg and laying earth connections from earth electrode with 4.00 mm dia copper wire in 15mm dia G.I pipe from earth dlectrode as required.

Pdg. And fixing 4.00 mm dia copper wire on surface or in recess for loop earthing as required.

Supply and erection of under ground cable 1 metre below ground level covered with sand and bricks including necessary connections, digging and refilling of trenches:- (xli) 25 sq mm 4 core cable (armourd)

Supply and erection of underground cable, loose in existing pipe or trenches complete with necessary connections: (xli) 25 sq mm 4 core cable (armourd)

Supply and erection of suitable compression type brass Cable glands for underground cable: 25 sq mm to 50 sq mm cable 2 to 4 core cable

Supply and erection of godrej almirah type M.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hings and locking arrangement with Godraj type handle including round bars. The top covering should have downward overhang of 75 mm on all sides of pedestal, having two sets of water proof ventilation holes of suitable size on the sides, at top and bottom, each set contaning four Nos. holes to discharge the heat produced by the current. The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof. The pedestel duly painted both inside and outside with two costs of approveded paint and primary coat and it's legs are embeded upto the entire depth in 1:2:4 cement concrete block, projected 75 mm all around the pedestal and 200 mm above the ground level including the cost of all labour and material required to complete the job i all respect upto the entire satisfaction of Engineer-in-charge of work. (ii) M.S. pedestal of size 750mm wide, 900 mm high 300 mm deep and bottom tottally open duly embeded in cement concerete block of size 900 mm x 450 mm x 200 mm above ground level duly plastered with 12 mm thick 1:4 cement plaster, having a base of size 1050 mm x 600mm x 250mm below ground level.

Miscellaneous Supply and erection of aluminium lugs heavy duty including crimping etc. upto the entire satisfaction of the Engineering-in-charge of the work. e) 25 Sqmm

Supply and erection of PVC unsheathed copper conductor cable single core 1100 voltas grade in pipe of suitable size excluding cost and erection of pipe (i) Cable size 1.5 sqmm (3/1.081mm)

Cable size 2.5 sqmm (3/1.05mm)

Cable size 10 sqmm(7/1.35mm)

Supply and erection of double door sheet steel enclosure distribution board suitable for MCBs and ELCBs etc. recessed in wall including bonding to earth with all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in-charge of the work. (i) 4-way , SP&N (Horizontal)

Supply and erection of copper lugs including crimping etc. upto the entire satisfaction of Engineering-in-charge of the work. (a) 1.5 sqmm to 2.5 sqmm

Supply and erection of MS saddles and clamps on wall/RCC parapit for fixing underground cable at a distance of 0.60 meter centre to centre fixed by means of rawl plug including the cost of all labour and material required to complete the job in all respect.

S/E mark double walled coooorrugated (DMC) HDPE, pipe laid 1 Meter below ground level including diging and refilling of earth including cost of suitable size docket/cuppler for HDPE pipe including the cost of labour and material required to complete the job i all respect upto the entire satifaction of Engineer incharge of the work. (i) HDPE PIPE 63/50 mm outer dia / inner dia

Supply and erection of metal clad bus bar chamber made from 1.6mm thick M.S sheet fixed with rugbolts on wall or on existing pedestal angle iron frame including bonding to earth copper bars 63 amp 415 volt 4 bars of 325 mm each (cross section 20x30mm) duly tinned over all size of the chamber 375mm X 295mmX140mm.

Supply, insallation Testing and Commissioning of 16 Mtr, long high mast manufactured from B.S.E.N. 10025 or equivalent grade material in. 2 (Two) section hot dip, galvanized inside and outside in single dip suitable for wind velocity as per IS 875 part-3 suitable for 12 Nos. 1 uminaire loading fully motorized (power tool) with starter & cable complete along with standard accessories supplied by the manufacture with 3 Nos. steel wire rope double drum system and twin dome avaition light with LED without foundation but including cost of set of foundation nut and bolts. Installation at site complete in all respect upto entire satisfaction of Engineer-in-Charge Make- Philips/ Bajaj/ Crompton/Surya.

Earth work in excavation in foundation, trenches, etc. in all kind of soils, not exceeding 2 meters depth including dressing of bottom and sides of trenches stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonary, in 15 cm layers with compaction, including disposal ogf all surplus soil, as directed within a lead of 30 meters.

Cement concerete Cement concerete 1:8:16 with brick ballast 40 mm nominal size in foundation and plinth.

Cement concerete 1:1/2:3 with stone aggregate 20 mm nominal size in foundation and plinth.in foundation and plinth.

Fe-500 EQR TMT steel bars for RCC, works, where not including bending, binding and placing in position complete.

Supply and erection of 350 watt LED Flood Light fittings on existing 16 metre height high mastpole as per entire satisfaction of engineer in charge with following specifactions:- LED flood light of system wattage 350 watt, IP66, Multiple LED with Lens optics with electronic driver and pressure die-cast aluminium housing for effective thermal management Total system Lumen of 350W LED should be 35000 Lumen or above in cool day light (57000K to 6500K), Lumen Efficacy>110 Lm/W, Power Factor>0.95, CRI>70, Average life:>50000 hours, open/short circuit protection, over voltage protection, surge protection with SPD (10 KV) complete with Mounting Brackets & accessories as required with connections with two years warrenty period of the completion of work in all respect as per entire satisfaction of Engineer-in-charge. Make (Philips/ Bajaj / Havells/ Cromption /Surya/ Wipro). Contractor has to submit the test reports of NABL approved lab for LM 79 & LM 80 report. All cost of 3rd party testing and relevant test will be borne by bidder and all relevant test certificate shall be provided free of cost by the bidder.

S/E OF 300 watt aluminium dia cast housing IP 66 flood light fitting including all connection with following specification. P.F >0.95, Lumen > 30000, system Luminious efficacy > 110 LM/W, 50000 burning hours, CCT=5700k, to 6500k, CRI-70, operating Voltage range=140-270v, in build electronic driver with lower THD, output open/short circuit protection, over voltage protection, Surge voltage protection, with SPD (10KV) test certificate Make- Philips/ Bajaj/ Cromption/ Wipro/ Havells/ Surya of same illumination with 2 year warrenty period after completion of work complete in all respect as per entire satisfaction of Engineer-in-Charge. Contractor has to submit the test reports of NABL approved lab for LM 79 & LM 80 report. All cost of 3rd party testing and relevant test will be borne by bidder and all relevant test certificate shall be provided free of cost by the bidder.

Supply and Erection of 11 metre long Hot Dip Galvanized octagonal pole of G.I, top dia 90mm dia and bottom dia 210 mm of 3mm thickness, with base plate of size 300mmX300mm X 20mm including cost of nuts & bolts and all accessories as supplied by the manufacture including cost of foundation complete. The foundation bolts as per manufacturer design should be hot dipped galvanized pole complete with door locking arrangement. Terminal plate consising of 2 Nos. 100 A. 4 pole nature links including connection etc. with suitable connecting arrangement for 2 No. MCBs kit kat including cost of R.C.C. 1:1.5:3. for foundation of size 0.7 M x 0.7M x 1.8 M with minimum 8 Nos. 12mm dia longitudinal MS reinforcement rods with rings of 8mm dia not more than 200mm C.C. for fixing the pole all labour and material required to complete the job in all respect upto the entire satisfaction of Engineer in Charge of the work.

S/E of required size channel made of 50mm x 50mm x 6mm thickness for erection of led fitting 350 watt 2 Nos. to 6 Nos. including required size of m-slips, M.S. angle, welding, holing, silver paint, required length of bracket, fixed on existing, 11 meter poles to hold up the fitting stand etc complete in respect

Road cutting by masonary enclosure/Machine 1 meter below ground level to Pass. Pvc/C1 pipe of required size under the road complete in all respect as per entire satisfaction of Engineer-in-Charge.

DEVENDER KUMAR CONTRACTOR