Loading
Loading…
Loading…
Tender Value
₹2.0 Cr
EMD Value
₹2.5 L
Closing Date
16 Jan 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Revenue
Above/Below/Par
TMS
17 conditions · 6 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or V whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Tenderer shall submit all mandatory documents as mentioned in SN-41 of Chapter III (Special Condition of Contract) at the time of bid. Non submission of mandatory documents or submission of incomplete documents shall result in rejection of bid. No further communication in this regard shall be accepted.
The tenderer must have successfully completed any of the following during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: Three similar works costing not less than the amount equal to 30% of advertised value of the tender, or Two similar works costing not less than the amount equal to 40% of advertised value of the tender, or One similar work costing not less than the amount equal to 60% of advertised value of the tender.
The Tenderer shall upload self-certification with completed details as Form-1 (Format for self certification regarding local content (LC) for telecom product, Services or works) issued by Department of Telecommunications, Ministry of communications vide notification published in the Gazette of India Extraordinary (Part I Sec. I), New Delhi, the 21st Oct-2024. Non submission of document or submission of incomplete document shall result in rejection of bid. No further communication in this regard shall be accepted.
Similar Nature of Work: "The tenderer should have completed the work of Supply and installation of PA System". Or "The tenderer should have completed the work of Annual Maintenance Contract (AMC)/CAMC of Supply and installation of PA System".
Local content (LC) shall be as per Table-A (List of telecom product, Services and works) issued by Department of Telecommunications, Ministry of communications vide notification published in the Gazette of India Extraordinary (Part I Sec. I), New Delhi, the 21st October-2024. It is mandatory to give percentage of MII content along with documentary evidence, else the offer of tenderer shall be treated as rejected. No further communication in this regard will be accepted.
9 conditions · 3 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
For those conditions for which standard formats have been given in the uploaded documents titled Formats for uploading of various format.The information should only be submitted in these standard formats.
Rates are inclusive of all taxes/octroi,license fee, royalty charges etc legally leviable by state , Central Govt and/or any other local authority.
Certificates from private individuals for whom such works are executed being executed is not acceptable.
Tenderers are required to submit authenticated certificate along with the tenders from officers of govt or semi-govt/public sector undertaking under whom the work has been executed indicating there in the name of work executed, value of works/payment details and period during which completed. Such certificate should have signature and seal of the concerned officer. in the absence of such certificate the tender may not be considered.
Tenderer shall submit all the documents in support of minimum eligibility criteria/ credentials along with the tender offer. no document in support of minimum eligibility criteria/credential will be considered /accepted /entertained after closing of tender and the decision will be taken based on the document submitted by the tenderer along with the offer only.
Comprehensive Annual Maintenance Contract of Bosch make PA System in New Auditorium along with Associated Equipments for a period of 05 years and SITC of PA System Equipments at RDSO Lucknow
STTTMSSTCAMCPASyste~RDSO
STTTMSSTCAMCPASyste
Open
Works - General
60 Months
Lucknow, Uttar Pradesh
₹0
₹2.5 L
16 Jan 2026
17 Dec 2025
26 Dec 2025
23 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 1,98,20,756.08 | ||
| — | 5.00 | — | — | ||
| Comprehensive Annual Maintenance Contract of following PA system items: (a) Flying line arreyable 15" two way by ampable speaker having 381 LF transducer. Make- Bosch (EV) - 4 Nos. (b) Stage monitor Make- Bosch - 2 Nos. (c) Heavy duty high performance amplifier class H, Make- Bosch(EV) - 4 Nos. (d) 5.25 inch 2 way full range speaker make - Bosch - 4 Nos. (e) Commercial power amplifier 2x450 watt, make- Bosch(EV) - 1 No. (f) Gooseneck mic 18" make- Bosch(EV) - 4 Nos. (g) Microphone, make- Bosch(EV) - 6 Nos. (h) Mic with coridiod partten, make- Bosch(EV) - 6 Nos. (i) Premium dynamic vocal mic, make- Bosch(EV) - 2 Nos. (j) Boundry layer mic, make- Bosch(EV) - 4 Nos. (k) DSP 2 in 6 out, make- Bosch(EV) - 1 Nos. (l) Speaker (400W) make- Bosch (EV)- 4 Nos. (m) Amplifier (2X1200) make- Bosch (EV)-2 Nos. (n) Microphone make- Bosch (EV)- 6 Nos. (o) Wireless Mic make- Bosch (EV)- 4 Nos. (p) Collar Mic make- Bosch (EV)-2 Nos. (q) 5 KVA UPS - 2 Nos. | — | — | — | 96,93,274 | |
| — | 1.00 | — | — | ||
| SITC Flying line arreyable 15" 2 way bi-ampable speaker having 381mm LF transducer with full symmetric drive , advance fourth order crossover network with HF protection, 51 mm diaphragm 36 mm pure exit titanium compressor driver , coverage pattern 90 x 60 degrees having freq response of 70-14000 at -3dB , recommended high pass freq 45 Hz, Max SPL /1m is 134 dB , System power handling 50 watt , nominal impedance 8 Ohms, enclosure material 13 ply weather resistant birch complete with internal cross over. As per Technical Specification Annexure 'A' | — | — | — | 2,95,076.78 | |
| — | 1.00 | — | — | ||
| SITC of Stage monitor with a maximum SPL rating of 121 dB and wide, even 100° x 100°coverage, capabilities defy its compact form factor and set uncompromising new benchmarks for its product segment. Core components include an 8"woofer mounted using Signal Synchronized Transducers port design, and a high-output titanium tweeter mounted onto a custom constant- directivity waveguide. Freq 60 to 20000 Hz, cross over freq 2.5 KHz, made of polypropylene with powder quoted grill. As per Technical Specification Annexure 'A' | — | — | — | 1,54,970.82 | |
| — | 1.00 | — | — | ||
| SITC of 16 channel Compact Mixing System (12 x Mic/Line + 4 x Mic/Stereo-Line) with Auxiliarys (MON, FX, AUX) 2 Pre, 2 Post, 2 Pre/Post switchable, MIC GAIN (Mono / Stereo) 0 to +60 dB / +10 to +60 dB, Frequency Response, -3 dB, ref. 1 kHz and any input to any Mixer output 15 Hz to 70 kHz. As per technical specifications Annexure 'A' | — | — | — | 21,08,433.59 | |
| — | 2.00 | — | — | ||
| SITC Wireless Handheld Microphone System having Frequency Oscillation Mode: Phase-locked loop (PLL),Carrier Frequency Range: 470 - 865 MHz (tuning bandwidth is band- dependent),Bandwidth: 36MHz,Signal/Noise Ratio: >100dB(A)Antenna Type: Detachable ½ wave with BNC connector and Contents Of Display: Group, channel, frequency, antenna A/B, transmitter battery level, transmitter status (mute, live, or no sync), output level attenuation, AF indication, RF indication, key lock indicator. As per technical specifications Annexure 'A' | — | — | — | 2,24,792.84 | |
| — | 4.00 | — | — | ||
| SITC of wireless mic with having Frequency response close: 30 Hz-17 kHz, Frequency response, far: 70 Hz-17 kHz and Polarity: Positive pressure on diaphragm produces positive voltage at center contact relative to ground contact. As per technical specifications Annexure 'A' | — | — | — | 2,74,633.12 | |
| — | 4.00 | — | — | ||
| SITC of wireless microphones working on UHF freq band handheld type dual units working on single receiver. Carrier wave freq range 865 to 867MHz, stability 10ppm, Sensitivity- 105dB, image rejection 85 dB typical, Freq response 40 to 18000 Hz, AF output impedance 2.2K ohms, transmitter power 30 mW. As per Technical Specifications Annexure 'A' | — | — | — | 4,49,585.68 | |
| — | 2.00 | — | — | ||
| SITC of EV Ultra compact 5.25 inch 2 way full range speaker made of vented trapezoidal enclosure of high impact polystyrene with passive crossover with power protection, Freq 85-20000 Hz, SPL 85 dB @ 1Mtr & Max SPL113 dB, power rating 120 Watt, coverage 100x 10 degrees, HF Transducer1" soft dome, Impedance 4Ohms with clamp. As per Technical Specification Annexure 'A' | — | — | — | 1,00,475.58 | |
| — | 1.00 | — | — | ||
| SITC of power amplifier 2X650 Watt having protection Audio limiters, high temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn on delay, Short- circuit & Signal Processing. As per technical specifications Annexure 'A' | — | — | — | 5,29,607.5 | |
| — | 1.00 | — | — | ||
| SITC of DSP matrix mix engine 76x72 channels having Open architecture DSP matrix for high performance audio applications, 12 mic/line inputs, 8 line outputs, 8 configurable GPIOs, 64 x 64 Dante channels, Task Engine for sophisticated system control and integration, Integrated into SONICUE Sound System Software. As per technical specifications Annexure 'A' | — | — | — | 15,23,567.17 | |
| — | 2.00 | — | — | ||
| Maintenance & Replacement of Layer 3 Core Switch with 48 x 25G/10G (SFP28) + 6x 100G QSFP28 ports with equipped with minimum 08 Nos.- 40G SM Fiber Modules and Redundant Power Supplies as per technical specification 'A' | — | — | — | 44,66,339 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
AuditoriumCAMCTender.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .