Loading…
India Infra Updates on WhatsApp
Join the Tenderkart WhatsApp channel for India Tender Updates
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹31.4 LAccepted-AOC | L1 | Accepted-AOC AOC | |
| 2 | L2₹31.8 L+₹28,650 (0.91%)Rejected-Finance | L2 | Rejected-Finance BIDDER REJECTED DUE TO HIGHER BID VALUE | |
| 3 | L3₹32.2 L+₹67,700 (2.15%)Rejected-Finance | L3 | Rejected-Finance BIDDER REJECTED DUE TO HIGHER BID VALUE | |
| 4 | L4₹32.7 L+₹1.2 L (3.77%)Rejected-Finance | L4 | Rejected-Finance BIDDER REJECTED DUE TO HIGHER BID VALUE | |
| 5 | L5₹33.2 L+₹1.7 L (5.39%)Rejected-Finance BOMDILA WEST KAMENG ARUNACHAL PRADESH PIN 790 001 | BOMDILA | WEST KAMENG | ARUNACHAL PRADESH | 790001 | L5 | Rejected-Finance BIDDER REJECTED DUE TO HIGHER BID VALUE |
Tender Value
₹31.5 L
EMD Value
₹63,000
Closing Date
20 Sept 2023, 4:30 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
LT COL BIRENDRA SINGH
GE 859 EWS
SPL REPAIR TO FILTER BED WATER FILTER MEDIA OF FILTRATION POINTS AND ALLIED WORKS AT PHASE-I (RVPA AREA) AND PROVN OF LT CABLE FOR 5 MDSR UNDER AREAS OF AGE E/M UNDER GE
2023_MES_615312_1
8454/E8
Open Tender
Civil Works
Item Rate
180 days
RVPA
PL REFER TENDER DOCUMENTS
7 documents required · 7 mandatory
₹500
GE 859 EWS
₹63,000
Yes
29 Nov 2023
23 Aug 2023
21 Sept 2023
23 Aug 2023
20 Sept 2023
6 Sept 2023
Amount
M/L for cleaning of internal surface of sedementation tank by draining out water, removing of mud and sediments accumulated in the tank, removing weeds, unwanted growth inside washing and drying up of capacity upto 1.0 lakh Gallons, for preparation of applying two coats of black bituminous paint (potable for drinking water) cemented surface exceeding 10 cm width or girth internally incl repairing of damaged plaster inside with cement mortar 1:3 with WPC and repairs to water channels complete all as directed by Engr-in-charge. (Note : The sedimentation tanks located in different pockets of Phase-I Rupa Area.)
M/L for cleaning of outer surface of sedimentation tank, removing weeds, unwanted growth outside washing and drying up of cap upto 1.0 lakh Gallons, applying two coats of cement base paint over cemented surface complete externally incl repairing of damaged plaster outside with cement mortar 1:4 with WPC complete all as directed by Engr-in-charge. (Note : The sedimentation tanks located in different pockets of Phase-I Rupa Area.)
M/L for cleaning of inner surface of filter bed, watering channels,removing weeds, unwanted growth inside scrubbing, washing and drying up of cap upto 0.50 Lakh Gallons , applying two coats of black bituminous paint over internal surfaces (suitable grade of paint for potable water) of filter bed complete incl repairing of damaged plaster inside with cement mortar 1:4 with WPC and repairs to water channel complete all as directed by Engr-in-charge. (Note : The sedimentation tanks located in different pockets of Phase-I Rupa Area.)
M/L for cleaning of outer surface of filter bed, watering channels,removing weeds, unwanted growth inside washing and drying up of cap upto 0.50 Lakh Gallons, applying two coats of cement base paint over outer surfaces of filter bed complete incl repairing of damaged plaster outside with cement mortar 1:4 with WPC complete all as directed by Engr-in-charge. (Note : The sedimentation tanks located in different pockets of Phase-I Rupa Area.)
Taking down carrefully existing filter media (sand/gravel) from the water filter bed and removing the same not exceeding 50 mtr and depositing where directed at a level not exceeding 1.5 mtr above the starting point all as directed.
M&L for laying old filter media (Sand/Gravel) obtained from water filter bed, washing with fresh water, removing dirt, mud and sludge and reusing the same after washing complete all as specified and directed.
Supply and laying filtaration plant gravel round shape of size 2.5 to 12.5 mm as per sample all as specified and directed
Supply and laying filtaration plant gravel round shape of size 12.5 to 20 mm as per sample all as specified and directed
Supply and laying filtaration plant gravel round shape of size 20 to 40 mm as per sample all as specified and directed
Supply and laying Silicon (Barakar) Sand in filteration plant of effective size of 0.35 mm to 1 mm as per sample and suitable for filter media complete all as specified and directed.
S&F GI tubing medium grade, ISI Marked conforming to IS 1239 Part-I 2004, 150mm bore with and including all fittings such as bends, elbows, tees, short length, socket, union, check nuts, nipples etc. fixed and laid in trenches/floor/under culvert/road crossing etc, fixed as in repair including dismentling taking down old unserviceable one complete all as specified and directed. Make: Jindal Pipes / Tata / Swastik /Prakash Tubes / OSWAL (Note: Exacavation and earhwork shall be measured and paid for separately.)
All as per item serial No. 11.00 here-in-before but of size 100mm bore -ditto-
All as per item serial No. 11.00 here-in-before but of size 80mm bore -ditto-
Supply and fixing cast iron Sluice valve PN 1:6 as per IS-14846, body, dome, wedge-CI IS:210, rings bronze IS:318, Spindle-SS IS-6603, Gland Packing gresy jute packing, fasteners-CS, Gasket-Natural rubber, Nominal size DN-150mm, both ends flanged in existing line, after removal of old unserviceable sluice valve without damaging to existing pipe line, fixed as in repair including dismentling taking down old unserviceable one complete all as specified and directed by Engineer-in-charge. Note :- Suitable size flanges for existing pipe line, joints and jointing material shall be included under this item. Make : Kirloskar / Leader / BIR / L&T (Audco)
All as per item serial No. 14.00 here-in-before but nominal size DN-100mm bore -ditto-
All as per item serial No. 14.00 here-in-before but nominal size DN-80mm bore -ditto-
M&L for Mild Steel fabrication/framed work, made out of structural steel sections as in frame works to cover for sedimentation tanks, ducts / MS door panels, framed guard bars, ladders, framed balusters, walk ways, railings, gates, frame work of water tank, valvepit and similar work with ends of bars souldered, welded or reveted or forced into spikes, confirming to Fe.290.Gde-E-165 incl painting with one coat of red oxide primer and one coats of anticorrosive black bituminous paint incl dismantling mild steel work of any description not otherwise specially provided for all including takin down old unserviceable one complete all as specified and directed
M&L for galvanised steel wire netting as per old/existing sameple mesh, made up into cover for sedimentation tank, lapped, wired and laid in position, including closing after filling complete including takin down old unserviceable one complete all as specified and directed
M&L for PCC(1:3:6) type C1 (using 20 mm graded crushed stone aggregate) as in concrete pedastal for supporting the CI/GI pipes including necessary form work complete including takin down old unserviceable one complete all as specified and directed.
Taking down cement plaster from brick or concrete surfaces of any description including racking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.
Material and labour for rendering 15 mm thick cement plaster in cement mortar (1:4) on old face of brick or concrete surface on walls complete complete all as specified and directed
Surface excavation not exc 30cm deep and averaging 15 cm deep and getting out in hard/dense soilcomplete including takin down old unserviceable one complete all as specified and directed
M&L for hard core of gauge n.exc 63mm, deposited, spread and levelled in layers n.exc 15cm thick, watered and rammed to a true surface complete all as specified and directed
M&L for 100mm thick PCC 1:3:6 type D2 (40mm graded stone aggregate) as in sub base flooring complete all as specified and directed
M&L Painting to old steel surfaces of any description, over 10cm in width or girth,not otherwise described with synthetic enamel paint (ordinary tint) one coat as per specified colour code all as specified and directed.
Excavation in trenches not exc 1 .5 wide and n exc 1 .5m in depth in hard / dense soil foundation etc . N exc 10 sqmm on plan and n exc 1.5m in depth and getting out all as specified .
Returning filling in trenches including spreading, leveling, watering, well ramming in layers n.exc 25cm thick in soils.
Removing excavated materials to a distance n.exc 50mtr and depositing where directed at a level n.exc 1.5mtr above the starting point.
S&L unreinforced precast concrete cable cover, class LV, Type 1, flat, size 250mm X 40mm X 40mm complete all as specified and directed.
Supply and spread fine dry river sand for cable cushioing in trenches complete all as specified and directed.
Supplying and laying XLPE insulated armoured heavy duty aluminum conducftor 1100 volt grade of 50 Sqmm 3.5 Core sizes, conforming to IS-1554 all as specified.
Supply and laying galvanised tube light grade ISI marked of size 40 mm dia incl all fittings in trenches/fixed on pole/wall/floor or laid in position complete all as specified and directed.
M & L for road cutting incl necessary excavation 45 cm wide and 90 cm in depth as in trenches in any type of soils/rock for laying LT UG cable through pipe after laying /through the cable trenches will be filling top with M&L PCC 1:3:6 type C-1 using 20 mm grdaeds stone aggregates from top over 15 cm thick hard good of broken boulders , 63 mm gauge over 15 cm bolders 100 mm dia over filled and rammed earth to make good the disburbed surface etc complete all as specified and directed.
S&F of TPN Kit kat main switch unit of 415 Volt 50 Hz three phase of capacity 100 Amp including MS box with backelite fuse & fuse carrier fittings , operating insulated handle, top cover necessary locking arrangemnts etc as per IS/IEC 60947 1&3 including necessary wall mounting fitting as directed all as specified and directed.
Material & labour for earthing complete with galvanised steel earth plate electrode 600x600x6 mm thick buried directly in ground (earth pit not less than 2.25m deep below the ground level) with top edge of the plate not less than 1.5mtr below the normal ground level connected to galvanised wire 4mm dia by means of bolts, nuts, check nuts and washers of galvanised iron.Earth wire protected by GI pipe 15 mm bore(medium grade) and connected to main switch board or main control board as directed and as specified and shown in electrical plate No. 3 of SSR Part I (2009) including necessary concrete pit in PCC (1:3:6) type C1, pre-cast RCC (1:2:4) type B1 cover slab 40 cm x 40cm x 5cm reinforced with 8mm dia TMT bars @ 15cm C/C with one handle for lifting made out of 8mm dia bar, funnel, wire mesh, 20mm dia GI pipe medium grade for watering, charcoal or coke and salt in alternate layers including necessary excavation and earth work in any type of soil and testing complete all as directed by Engineer-in-Charge.
M/S N D ENTERPRISE
M/S ASHOK CONSTRUCTION
M/S DKT CONSTRUCTION
M/S R N ENTERPRISES
M/S SM ANSARI
M/S SUNRISE CONSTRUCTION AND CO
M/S DK TRADERS
stage.html
html • 0.06 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .