Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹1.1 LAccepted-Finance BUNKULUNG BUSTY MIRIK DARJEELING | JALPAIGURI | WEST BENGAL | 734001 | ₹1.1 L | L1 | Accepted-Finance Lowest bid hence accepted |
| 2 | L1₹1.1 LRejected-Finance | ₹1.1 L | L1 | Rejected-Finance The bid has been rejected as per decision made by tender committee |
| 3 | L2₹1.1 LRejected-Finance | ₹1.1 L | L2 | Rejected-Finance Highest bid hence rejected |
| 4 | L3₹1.1 LRejected-Finance | ₹1.1 L | L3 | Rejected-Finance Highest bid hence rejected |
Tender Value
₹1.2 L
EMD Value
₹2,300
Closing Date
21 Jan 2026, 1:35 pmClosed
PRADHAN S1GP
Khaptawali gaon, Soureni-I GP, PO- Soureni, Mirik, Dist- Darjeeling
Construction of Goat shed on the land of Prashant Ramtel, Toklang.
2026_GTA_986424_4
10/PRA/S-I/15THFC/UT/2025-26
Open Tender
CIVIL WORKS
Hallaney
Please refer Tender documents.
4 documents required · 4 mandatory
₹250
₹2,300
6 Mar 2026
10 Jan 2026
27 Jan 2026
10 Jan 2026
21 Jan 2026
10 Jan 2026
Earth work in excavation of foundation trenches or drains in all sorts of soil (including mixed soil but excluding laterite or sand stone) including removing, spreading or stacking the spoils within a lead of 75m. as directed. The item includes necessary trimming the sides of trenches, levelling, dressing and ramming the bottom, bailing out water as required complete.(a) Depth of excavation not exceeding 1.500 mm.
Laying 150 mm. to 200 mm. boulder soling including rough dressing hand packing and ramming down small pieces in the interstics without rolling but including ramming.
Cost of stone boulder 150 mm size delivered ans stacked at site.
Ordinary cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttring and reinforcement, if any, in ground floor as per relevant IS codes. (b) River bazree.
Ordinary cement concrete (mix 1:1.5:3) with graded stone chips (20mm nominal size) excluding shuttering and reinforcement, if any, in ground floor as per relevant codes.(ii) River bazree.
Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc. initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at inter-section, complete as per drawing and direction.(a) For works in foundation, basement and up to roof of ground floor/up to 4m. Tor steel/Mild steel.SAIL/ TATA/RINL
Hire and labour charge for shuttering with centreing and necessary staging up to 4 m. using approved stout props and thick hard wood planks of approved thick ness with required bracing for concrete slabs, beams, columns, lintels curved or staight including fitting fixing and striking out after complection of works. (up to roof of ground floor).(a) 25 mm. to 30 mm. thick wooden shuttering as per decision & direction of the Engineer-in-charge. .
(A) Wood work in posts, post plates, rafters, battens, truss members,purlins etc. fitted and fixed complete (excluding the cost of bolts, paints but including the cost of nails, screw etc.) (The quantum should be corrected up to three decimals).(ii)Sal :Local
Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame excluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be corrected up to three decimals).(i) Other Local Wood.
Panel shutters of door and window, as per design (each panel consisting of single plank with out joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings.In ground floor.(In case of non-supply of single plank, panel rate of reduction of 20% will be made).(ii) 40 mm.thick shutters with 19 mm. thick panel of size 30 to 45cm.(c)other Local wood.
Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark.(ii) 75 mm x 60 mm x 3.15 mm.
Anodise aluminium barred/tower/socket bolt (full covered) of approved manufactured from extruded section conforming to I.S.204/74 fitted and Fixed with cadmium plated screws:.(iii) 100 mm long x 10 mm dia. bolt.
Anodise aluminium barred/tower/socket bolt (full covered) of approved manufactured from extruded section conforming to I.S.204/74 fitted and Fixed with cadmium plated screws:.(iii) 150 mm long x 12 mm dia. bolt.
Iron pad bolt (lock) of approved quality rod and handle single cast.(ii) 200 mm x 16 mm dia rod 105 mm x 3 mm plate
Galvanized corrugated iron sheet work (excluding the supporting frame work) fitted and fixed with 10 mm. dia J or L hook-bolts, limpet and bitumen washers and putty complete with 150 mm. end lap and one corrugaion minimum side lap. ( payment to be made on area of finished work). (GCI sheet to be supplied by contractor). (i) in Roof:-.(b) With 0.63 mm.thick sheet.
Plain and finished timber planks in partition, shelves etc. fitted and fixed complete as per design (butt joints) in ground floor.(i) 12 mm. thick planks.(c)Other Local Wood.
Bamboo Floor (local rate)
Display Board
Add 18 % GST on Total Amount
Add 1%labour cess on (Total Amount + GST)
Please Enable Macros to View BoQ information
stage.html
html • 0.04 MB
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 1.45 MB
BOQ_2409128.xls
BOQ • 0.27 MB
Download all tender documents and submit your bid