Reconstruction of O/L at RD...

Supply of APM block size B

Percentage BoQ

BoQ_Ver3.0

Name of the Bidder/ Bidding Firm / Company :

PRICE SCHEDULE (This BOQ template must not be modified/replaced by the bidder and the same should be uploaded after filling the relevent columns, else the bidder is liable to be rejected for this tender. Bidders are allowed to enter the Bidder Name and Values only )

NUMBER #

Item Description HSR Item

[11.4.2]10 mm thick cement plaster 2. 1:3 (1 cement: 3 fine sand)

[14.1]Dressing bed and preparation of sub grade for lining by mechanical/ mannual means

[14.2]Dressing side slopes and preparation of sub grade for lining by mechanical/ mannual means

[14.31.1]Single layer brick lining for irrigation channels for discharge up to 150 cusecs consisting of: (i)10 mm thick cement plaster 1:6 on sub grade. (ii)10 mm thick cement plaster 1:3 over first plaster (iii)First layer of 68.3 mm thick brick layer (22.86x11.11 mm) laid in 1:3 mortar over 6 mm thick cement 1:3 the above cost (total thickness of lining as 9.43 cm) 1. In Bed

[14.31.2]Single layer brick lining for irrigation channels for discharge up to 150 cusecs consisting of: (i)10 mm thick cement plaster 1:6 on sub grade. (ii)10 mm thick cement plaster 1:3 over first plaster (iii)First layer of 68.3 mm thick brick layer (22.86x11.11 mm) laid in 1:3 mortar over 6 mm thick cement 1:3 the above cost (total thickness of lining as 9.43 cm) 2. On Side Slopes.

[4.12.1]Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m, as directed by Engineer-in-charge. 1. All kinds of soil

[4.33]Excavating, supplying and filling of local earth (including royalty) by mechanical transport up to a lead of 1 km also including ramming and watering of the earth in layers not exceeding 20 cm in trenches, plinth, sides of foundation etc. complete.

[6.1.6]Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 6. 1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

[6.14.2]Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 2. 1:2:4 (1 cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

[6.34.3]Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect above plinth level Note:- Reinforcement shall be measured in length including hooks, if any, separately for different diameters as actually used in work , excluding overlaps. Wastage, overlaps, couplings, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire or other methods of binding & placing shall not be measured and cost of these items shall be deemed to be included in the rates for reinforcement. 3. Cold twisted bars

[7.21.1]Brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 1. Cement mortar 1:4 (1 cement : 4 coarse sand)

[7.21.3]Brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 3. Cement mortar 1:3 (1 cement : 3 coarse sand)